InFocus 610, 620 User Manual

009-0279-00 (English)

SAFETY SUMMARY

: Please

read these instructions before

using your LitePro 610 or 620.

Failure to comply could result in

fire, electrical shock, personal

injury or equipment damage.

Definition of Safety Icons

on Product Labels

Refer to the User’s
Guide for more
informat i on.

Avoid hot surfaces.

Bulb explos io n
haza rd.

Don’t Look Into The Lens!

Be extremely careful not to look directly into the lens when the projector is on.
The bright light can harm your eyes. Be especially careful to keep children from
looking into the lens.

Don’t Disasse m ble

Do not open the projector’s case! Doing so exposes you to an electric shock haz­ard. Except for the projection lamp, there are no user-serviceable parts. All service
must be performed by an In Focus Systems Authorized Service Provider.

Avoid Hot Su rfaces

The rear of the projector becomes very hot during operation. Avoid touching the
exhaust grill on the lamp door. Allow the projector to cool for at least 45 minutes
before opening the lamp door to replace the lamp. The inside of the lamp housing
can be very hot. Use extreme care. Avoid touching the hot surfaces inside.

Use On ly T he 610/ 620 Power Cord

Always use the power cord that came with the projector. Although other cords
might look the same, they have not been safety-tested with the 610 or 620. Never
use the power cord if it’s damaged or frayed. When you disconnect the projector,
always remove the power cord from the electrical outlet first, then from the pro­jector.

Don’t Defeat The Purpose O f The Gro unding P lug

The projector is grounded through the grounding conductor on the power cord.
To avoid electric shock, plug the power cord into a properly wired receptacle.

Avoid Liquid Spills

Don’t set drinks on top of the projector. Spilled liquids can flow inside causing
damage.

Don’t Block Ventilation

Openings in the case provide ventilation to protect the projector from overheat­ing. Keep loose papers and other objects away from the bottom, top and side
grills. Don’t place the projector on top of or close to a computer or other heat-pro­ducing equipment.