Infloor Tubing Uncoiler User Manual

Tubing Uncoiler and Assembly

Thank you for purchasing an Infloor Sales and Service tubing uncoiler. This document with some pictures will

explain the assembly of the tubing uncoiler.

Remove tubing uncoiler assembly from box and lay out all the parts on the floor.

Item 1 Tubing uncoiler base assembly

Item 2 Install washer on the base of the uncoiler

Item 3 Install cr

oss assembly on washer from Item 2

PO Box 4945 www.infloor.com 719-395-3400
503 Gregg Dr 800-608-0562
Buena Vista CO 81211 fax [phone]

Item 4 Install second washer on top of cross assembly

Item 5 Install nut ass

spin freely)

Item 6 Install 4 ex

tension bars to cross assembly and ghten bolts and wing nuts

embly on top of washer assembly do not over ghten (this allows the uncoiler to

Ite

m 7 Slide vercal riser assemblies to onto extension bars

PO Box 4945 www.infloor.com 719-395-3400
503 Gregg Dr 800-608-0562
Buena Vista CO 81211 fax [phone]

Item 8 Tighten nut assembly at desired locaon

Item 9 The assembly should look like the picture below

Item 10 Install L braces onto the vercal assemblies L braces should face out. Tubing uncoiler is

completely assembled

Item 11 Remove L braces and put roll of tubing onto uncoiler

PO Box 4945 www.infloor.com 719-395-3400
503 Gregg Dr 800-608-0562
Buena Vista CO 81211 fax [phone]

m 12 Install L braces on vercal risers over the tubing

Ite

Item 13 pull on tubing to begin installing tubing, the tube uncoiler will rotate to allow tubing to be

uncoiled

Thank you for choosing Infloor Sales and Service for your radiant needs. Please feel free to contact us with any

quesons in regards to the Infloor Tubing uncoiler part # 26055

PO Box 4945 www.infloor.com 719-395-3400
503 Gregg Dr 800-608-0562
Buena Vista CO 81211 fax [phone]