WW 5 Series WW 5, WW5-2 Installation
Parts List
(A) W5 Strainer
Weep holes
Waterproofing
membrane
(C) Fits standard
size residential
drains in Cast Iron,
ABS or PVC.
Figure 1
Installation Instructions
1. Determine clamp down drain
(C) location. Connect to drain pipe.
2. Create a pre-slope in four directions
towards drain body (C). Waterproof
to local code.
3. Insert W5 Strainer (A) into clamp
down drain (C) and adjust height
as needed. Allow secondary mortar
bed to support W5 Strainer (A).
4. Finish floor must be 1/16″ higher
than top edge of W5 Strainer (A).
Infinity Drain recommends this product be
installed by a licensed contractor
Determining floor height
Finished floor height must be 1/16″ higher at top edge of Infinity Drain
Minimum height
≈ ¾″
Maximum height
≈ 2¼″
Figure 2
18 Secatoag Avenue, Port Washington, New York 11050 ● p:516.767.6786 f:516.740.3066 www.infinitydrain.com
Fits standard residential drain
Loading...