Infinity Drain TDB 20 User Manual

TDB 20 Series

TDB 20│Tile Drain Series

- 12 gauge 316 Stainless Steel Frame and Body

- ¾″ depth inside frame for material

- ¼″ drainage gap

- Indoor or outdoor use

- Residential grade bonded flange (PVC or ABS) with 4” throat

- Connects to 2”, 3” or 4” waste line

- Uses liquid and fabric sheet membrane waterproofing (not Hot Mop)

- Grate can be removed completely for cleaning

- Requires traditional 4-way floor pitch

- Flow rate 9 GPM with 2″ outlet

Finishes:

____

Satin Stainless

_

Polished Stainless

_____

Complete Kits:

TDB 20-A SS Bonded Flange ABS Drain
TDB 20-A PS Bonded Flange ABS Drain
TDB 20-P SS Bonded Flange PVC Drain
TDB 20-P PS Bonded Flange PVC Drain

Components:

T 20 B 8″ x 8″ Tile Drain Strainer

BFA 42 Bonded Flange ABS
BFP 42 Bonded Flange PVC
TKEY Lift Out Key

Installation (TD) Center Drain

Infinity Drain

18 Secatoag Avenue
Port Washington, NY 11050
Phone: [phone]
Fax: [phone]
www.InfinityDrain.com

Dimension are subject to Manufacturers tolerance and change without notice. We can assume no responsibility for use of superseded or void data.

Note: Installer must verify all rough-in

dimensions prior to installation and consult
local and national codes. Conformity and
compliance to local and national codes
are the responsibility of the installer.

Page 1 of 2

REV. 08.01.2013

TDB 20 Specifications

TDB 20-A

8″ x 8″ Kit with ABS Bonded Flange Drain
Body, fits 2″, 3″ and 4″ Outlet

(8″ L x 8″ W x 1 5/16″ H)
1 - T 20 B Tile Drain Strainer
1 - BFA 42 Bonded Flange ABS Drain

TDB 20-P

8″ x 8″ Kit with PVC Bonded Flange
Drain Body, fits 2″, 3″ and 4″ Outlet

(8″ L x 8″ W x 1 5/16″ H)
1 - T 20 B Tile Drain Strainer
1 - BFP 42 Bonded Flange PVC Drain

Infinity Drain

18 Secatoag Avenue
Port Washington, NY 11050
Phone: [phone]
Fax: [phone]
www.InfinityDrain.com

Dimension are subject to Manufacturers tolerance and change without notice. We can assume no responsibility for use of superseded or void data.

Note: Installer must verify all rough-in

dimensions prior to installation and consult
local and national codes. Conformity and
compliance to local and national codes
are the responsibility of the installer.

Page 2 of 2

REV. 08.01.2013