Infinity Drain TDB 15 User Manual

TDB 15 Series

TDB 15│Tile Drain Series

- 12 gauge 316 Stainless Steel Frame and Body

- ¾” depth inside frame for material

- ¼” drainage gap

- Indoor or outdoor use

- Residential grade bonded flange (PVC or ABS) with 4” throat

- Connects to 2”, 3” or 4” waste line

- Uses liquid and fabric sheet membrane waterproofing (not Hot Mop)

- Grate can be removed completely for cleaning

- Requires traditional 4-way floor pitch

- Flow rate 9 GPM with 2” outlet

Finishes:

Satin Stainless

_____

Polished Stainless

_____

Complete Kits:

TDB 15-A SS Bonded Flange ABS Drain
TDB 15-A PS Bonded Flange ABS Drain
TDB 15-A SS Bonded Flange PVC Drain
TDB 15-P PS Bonded Flange PVC Drain

Components:

T 15 A 5” x 5” Tile Drain Strainer
T 15 B 5” x 5” Tile Drain Strainer

BFA 42 Bonded Flange ABS
BFP 42 Bonded Flange PVC

Installation (TD) Center Drain

Infinity Drain

18 Secatoag Avenue
Port Washington, NY 11050
Phone: [phone]
Fax: [phone]
www.InfinityDrain.com

Dimension are subject to Manufacturers tolerance and change without notice. We can assume no responsibility for use of superseded or void data.

Note: Installer must verify all rough-in

dimensions prior to installation and consult
local and national codes. Conformity and
compliance to local and national codes
are the responsibility of the installer.

Page 1 of 2

REV. 08.01.2013

TDB 15 Specifications

TDB 15-A

5” x 5” Kit with ABS Bonded Flange
Drain Body, fits 2”, 3” and 4” Outlet

(5” L x 5” W x 1 5/16” H)
1 - T 15 B Tile Drain Strainer
1 - BFA 42 Bonded Flange ABS Drain

TDB 15-P

5” x 5” Kit with PVC Bonded Flange
Drain Body, fits 2”, 3” and 4” Outlet

(5” L x 5” W x 1 5/16” H)
1 - T 15 B Tile Drain Strainer
1 - BFP 42 Bonded Flange PVC Drain

Infinity Drain

18 Secatoag Avenue
Port Washington, NY 11050
Phone: [phone]
Fax: [phone]
www.InfinityDrain.com

Dimension are subject to Manufacturers tolerance and change without notice. We can assume no responsibility for use of superseded or void data.

Note: Installer must verify all rough-in

dimensions prior to installation and consult
local and national codes. Conformity and
compliance to local and national codes
are the responsibility of the installer.

Page 2 of 2

REV. 08.01.2013