Industrial Scientific GasBadge Pro Quick Start Manuals
NOTE: This reference sheet is a supplement
to the GasBadge Pro manual (part number
17123100) and is not intended to be used as a
replacement for the information in the manual.
For other language versions of this quick start
guide, go to www.indsci.com.
Personal
Single Gas
Monitor
Mode
Button
(
On/Off)
ACTIVATION
Instrument
Firmware
Version
Countdown
After
Activation
Gas
Monitoring
Screen
IMPORTANT: A function or "bump" test, using a
known concentration of calibration gas, should be
performed periodically based on instrument use,
exposure to gas, and environmental conditions.
The frequency is best determined by company
policy or local regulatory agencies. If an
instrument fails a function or "bump" test, or, if it is
dropped, submerged, or appears damaged, a full
calibration is recommended. The safest
approach is to perform a function or "bump" test
prior to each day's use. Industrial Scientific is not
responsible for establishing customer safety
p
ractices and policies.
MONITOR MODE
Quick Start Guide
Up
Button
Down
Button
Time Weighted
Average
Reading (TWA)
Short Term
Exposure Limit
Reading (STEL)
Create New
Session
Enter
Button
Part Number: 17126368
Revision: 3.0
Release Date: 01-02-2009
© 2005 Industrial Scientific. All rights reserved.
Gas
Monitoring
Screen
Days Since/Until
Calibration (if
enabled)
Zero Initiate
Bump Test
Initiate (if
enabled)
Peak Reading
Industrial Scientific Corporation
Corporate Headquarters
1001 Oakdale Road
Oakdale, PA 15071-1500
Phone: (412) 788-4353
Toll Free: 1-800-DETECTS (1-800-338-3287)
Fax: (412) 788-8353
CONFIGURATION
A
TWA Time Base
Setting
STEL A lar m
Setting
Cal Gas Value
Setting
Set C lo c k
Set Calendar
Security Code
Setting
Rec ording Interval
Setting
Warm-up
Countdo wn
Hold 3-S e c .
Enter Security
Code if not = 0
Initiate
Zero/Calibration
Days Since/Until
Calibration
Initia te IR Data
Print
Low Alarm
Setting
High Alarm
Setting
TWA Alarm
Setting
Display Setting
A
Calibration Due
Alarm Enable
Calibration Interval
Setting
Field Bump Test
Enable
Bump Test Due
Alarm Enable
Bump Test
Interval
Bump Test
Time-Out
Always On
Enable
Confidence Beep
Enable
Alarm Latch
Enable
Field Zero
Enable
Field Calibration
Enable
Days Since/Until
Calibration Setting
Loading...