Induro TH-S Operating Instructions Manual

TH-S TilTHeaD

Oper aT ing inS T rucTiOnS

Thank you for making Induro your choice for

professional photographic gear. Your Induro gear

is manufactured to provide years of dependable

service. In order to obtain optimum satisfaction

and performance we suggest that you carefully

read these instructions and provide them to

anyone who may also use your Induro gear.

Bubble Level

Quick Release Plate

Tilt Lock Knob

Security

Locking Lever

Plate Locking Lever

USER NOTICE

Do not exceed the maximum specied c
load capacity (see Specication chart)

Always ensure that leg and head locks c
are tightly engaged before mounting a
camera on the tripod

Do not use the tripod below c
temperatures of -4°F or above +158°F
(-20°C / +70°C)

Do not leave the product in the sun c
for prolonged periods and avoid high
temperature exposure

For your safety, don’t let your Induro c
tripod come in contact with any
electrical power source

Remove camera, lens, and all gear c
from the tripod when transporting
the tripod

Avoid leaving the tripod unattended c
in areas where people could trip over
the tripod and get hurt

Always clean and dry the tripod after c
it has been exposed to wet, dusty,
sandy or salty conditions. Your tripod
is not recommended for use in salt
water. If required clean tripod using a
mild soap solution applied with a soft
cloth and follow by wiping down with
fresh water. Remove any dust, dirt or
sand from all leg locks, leg lock levers,
leg sections and all moving parts.

OPERATION

1

Install by screwing the head

clockwise onto the 3/8" mounting
thread of monopod plate. Once it is hand
tight, secure by fully tightening the
three head locking screws from below.

2

When used properly, the patented

dual lock quick release system
offers two levels of security for your
gear. To remove the quick release
plate, squeeze both the Plate Locking
Lever and the Security Locking Lever
and pull the larger locking lever out.
The Quick Release Plate will disengage
allowing it to be removed.

3

To reconnect the Quick Release

Plate, insert the angled part
of the plate into the groove on the
opposite side of the locking levers and
press down at. The locking levers
will automatically engage the locking
system and will return to the safety
lock position. Press the Plate Locking
Lever in rmly to secure.

4

Horizontal rotation or panning
can be easily accomplished by

swiveling the entire monopod.

5

Front to rear angle or tilt

adjustments can be easily
accomplished by rst loosening the
Tilt Lock Knob (be sure to hold rmly
to balance weight of the camera).
Position as desired and tighten the
knob securely.

6

Depending on your requirements,

you may nd it convenient to reorient
the camera or lens 90 degrees on the
Quick Release Plate and then remount.
This allows the Tilt Control Knob to give
you different positioning support.

INDURO Camera Support Gear | 8 Westchester Plaza, Elmsford, NY 10523 | T 914-347-3300 | F 914-347-3309 | [e-mail] | indurogear.com

SPECIFICATIONS

CAT # MODEL # CAMERA MOUNT TILT

RANGE

PANNING

RANGE

MATCHING

MONOPODS

WEIGHT LOAD

LB KG LB KG

Monopod Tilthead TH-Series

484-001 TH-S QR-3D-01-14S* +90°/-90° 360° 0, 1 & 2 0.6 0.3 5.5 2.5

* 1/4-20 Quick Release Plate