INDESIT YT M11 82 X UK Daily Reference Guide

THANK YOU FOR BUYING A INDESIT PRODUCT.
EN
Quick guide
DEMO
5 67
In order to receive a more complete assistance, please register your product on
www.indesit.eu/register
Before using the appliance carefully read the Safety Instructions.
CONTROL PANEL
1 ON/OFF button (Reset if long pressed)
2 Programme selection knob
3 Start/Pause
4 Push & Go
Options buttons*
5 Dryness level 6 Start delay 7 Timed drying
8 Cycle end 9 Light drying (Key lock if long pressed) 10 Crease care (Mute if long pressed)
2
INDICATORS
Dryness level: Iron dry - Hanger dry - Cupboard dry - Extra dry -
Cycle phase: Dry - Cool tumble - END End of cycle -
Empty water tank Clean door lter Clean bottom lter
Refer to Troubleshooting section: Failure: Call after sales service -
DEMO
*Note: some models may have the wording in full instead of the icons
10
3’’
9
3’’
8
Demo mode
1
4
3
FIRST TIME USE
Make sure that the water tank is correctly inserted. Make sure that the drain hose on the back of the dyrer is properly xed, either to the dryers's water tank or to the domestic sewage system. The dryer must be installed in a room with a temperature ranging between 5°C and 35°C to ensure proper operation. Before you use your dryer ensure that it has been in a upright position for at least 6 hours.
DAILY USE
Doing this will keep your machine working at its BEST! Remember to empty your water tank after each drying cycle.
Remember to clean your lters after each drying cycle. (Refer to section Care & Maintanence).
1. Open the door and load garments. Always refer to instructions on clothing labels and the max loads indicated in the programme section. Empty pockets. Make sure garments do not get caught between the door and/or the door lter.
2. Close the door.
3. Press the button On/O .
4. Select the programme according to the laundry type.
5. Select the options, if necessary.
6. To start the cycle, press the Start/Pause button.
7. At the end of the drying cycle, a buzzer will beep. An indicator on the control panel signals the end of the cycle. Pull the load out immediately to prevent the formation of creases on laundry.
8. Turn the machine o by pressing the button On/O, open the door and pull clothing out. If the machine is not switched o manually, after about a quarter of an hour from the cycle end, the appliance turns o automatically to save energy.
If this last stage is not carried out immediately, some machines and/or some programmes/options are equipped with Crease Care system. For some hours, after the end of drying, the drum rotates at regular intervals to prevent the formation of creases. In case of power failure, it is necessary to press the button Start/ Pause to restart the cycle.
PUSH & GO
This function serves to start a cycle, after machine switching on, without enabling any further button an/or knob (the programme PUSH & GO will be deactivated instead).
It is always necessary to follow the points 1, 2, and 3 concerning the daily use.
To start the cycle Touch & GO, keep the button pressed. The light on signals that the cycle is started. The cycle is suitable for cotton
and synthetic textiles. Max. load 4 kg. (Cycle duration 131’).
If the door is opened during the cycle, to restart it, close the door and press the button START/PAUSE. This programme does not allow to set other options.
OPENING OF THE DOOR DURING THE CYCLE
During operation, it is possible to open the door. After having closed it, press the button Start/Pause again to restart the dryer.
PROGRAMMES
Eco cotton kg Max*
cotton laundry. Most ecient programme in terms of energy consumption for drying cotton laundry. The values on the Energy Label are based on this programme.
Synthetics kg 4
For drying laundry made of synthetic bres.
Mixed kg 4
This programme is ideal for drying cotton and synthetic fabrics together.
Mini synthetics kg 2
Eco-drying of small laundry loads.
Mini cotton kg 2
Eco-drying of small laundry loads.
Delicates kg 2
For drying delicate laundry requiring a gentle treatment.
Wool kg 1
Programme for drying wool clothing. It is advisable to turn the garments inside out before drying. Leave to dry naturally the heaviest edges that are still damp.
*MAX LOAD 8 Kg (Dry load)
CARE LABEL
Always check the care labels, especially when placing garments in the tumble dryer for the  rst time. Below are the most commonly used symbols:
May be tumble dried.
Do not tumble dry.
Tumble dry – high heat.
Tumble dry – low heat.
45’
The duration of these programs will depend on the size of the load, types of textiles, the spin speed used in your washer and any extra options selected. In machines equipped with display, the duration of the cycles is shown on the control panel. The remaining time is constantly checked and adjusted during the drying cycle to show the best possible estimate.
Refresh
A short programme suitable for refreshing bres and garments by means of fresh air. Do not use with garments that are still wet. It can be used on with any load size but is more eective with small loads. The cycle duration is about 20 minutes.
Jeans kg 3
For drying cotton jeans-wear and garments made of robust
cotton, like denim, such as trousers and jackets.
Shirts kg 3
This is a programme for Shirts made from cotton or cotton blend/synthetics.
Duvet
Programme intended to dry bulky garments, as single duvet.
Baby kg 2
A programme intended to dry garments and linen of
new-born babies (cotton and chenille), as well as delicate
garments. Do not dry garments having plastic covering.
Sport kg 4
For drying sports garments made of synthetics or cotton
blends.
Smart iron
This cycle allows to extend the bres of garments thus making ironing and folding easier. Do not use in case of garments that are still wet. Suitable for small loads of cotton textiles or cotton blends.
Xpress 45' kg 1
This is a quick timed programme, ideal for drying garments spun at high speed in the washing machine, e.g. the shirts used in a working week.
OPTIONS
After selecting the programme, the various options can be set, if necessary.
Dryness level
Press the related button several times to obtain a dierent level of residual moisture on garments. An indicator signals the level being selected.
Iron dry: a very delicate ironing. Suitable for making ironing of
garments easier immediately after the end of the cycle.
Hanger dry: a level intended for delicate garments ready to
be hanged.
Cupboard dry: the garments are ready to be folded and put away.
Extra dry: used for garments to be worn at the end of the cycle.
Timed dryning
This option allows to set the drying time. Press the corresponding button to set the required time for drying. An indicator on the control panel signals the time being selected.
Start delay
This option allows you to set the delay of the cycle start. Press the corresponding button several times to obtain the required delay. After having reached the max. settable time, the option is reset by pressing the button again. An indicator on the control panel signals the time being selected. After having pressed the button Start/Pause, the machine signals the remaining time for the cycle start. In case of door opening, after closing, it is necessary to press the button Start/Pause.
Crease care
This option add a crease treatment at the end of the cycle by means of a periodic rotation of the drum (duration up to 10 hours). It is particularly suitable when it is not possible to remove the laundry as soon as the drying ends. If this option is used together with the Start Delay, the crease treatment is added also in the Start Delay phase. This option remains in memory if selected in the previous drying.
Light dry
Enables a more gentle treatment of the laundry by reducing the drying temperature.
Key lock
This option makes all machine controls inaccesible, except the button On/O. When the machine is on:
to activate the option, keep the button pressed until the
indicator goes on.
to disable the option, keep the button pressed until the indicator
goes o.
This option remains in memory if selected in the previous drying.
Mute
This option turns o all sounds of control panel. Only
warnings remain active.
to activate the option, keep the button pressed until the
indicator goes on.
to disable the option, keep the button pressed until the indicator
goes o.
Cycle end
This option activates a prolonged buzzer at the end of the cycle. Enable it if you are not sure to hear the normal sound at the end of the cycle. This option remains in memory if selected in the previous drying.
OPTIONS BUTTONS
These buttons serves to personalise the selected programme according to personal requirements. Not all options are available for all programmes. Some options are incompatible with the ones previously set. The buzzer and/or blinking indicators will signal the incompatibility. If the option is available, the option indicator will stay on. Some options may be kept in the memory of the programme if selected in the previous drying.
Loading...
+ 2 hidden pages