THANK YOU FOR BUYING A INDESIT PRODUCT.
In order to receive a more complete assistance,
please register your product on
www.indesit.eu/register
Before using the appliance carefully read the Safety Instructions.
CONTROL PANEL
1 ON/OFF button (Reset if long pressed)
2 Programme selection knob
3 Start/Pause button (Start: button lights up
solidly. Pause: button blinks)
4 Push & GO
Options buttons*
5 Dryness level
6 Timed drying
7 Start delay
8 Light drying
9 Crease care (Key lock if long pressed)
10 Cycle end
2
INDICATORS
Dryness level: Iron dry - Hanger dry - Cupboard dry - Extra dry
Cycle phase: Dry - Cool tumble - END End of cycle
Empty water tank Clean door lter Clean bottom lter
Failure: Call after sales service.
Demo mode Refer to troubleshooting section
10
8
DEMO
5 67
*Note: some models may have the wording in full instead of the icons
9
3’’
8
1
4
3
FIRST TIME USE
Make sure that the water tank is correctly inserted. Make sure
that the drain hose on the back of the dyrer is properly xed,
either to the dryers's water tank or to the domestic sewage
system.
The dryer must be installed in a room with a temperature
ranging between 5°C and 35°C to ensure proper operation.
Before you use your dryer ensure that it has been in a upright
position for at least 6 hours.
DAILY USE
Doing this will keep your machine working at its BEST!
Remember to empty your water tank after each drying cycle.
Remember to clean your lters after each drying cycle. (Refer to
section Care & Maintanence).
1. Open the door and load garments. Always refer to instructions
on clothing labels and the max loads indicated in the programme
section. Empty pockets. Make sure garments do not get caught
between the door and/or the door lter.
2. Close the door.
3. Press the button On/O .
4. Select the programme according to the laundry type.
5. Select the options, if necessary.
6. To start the cycle, press the Start/Pause button.
7. At the end of the drying cycle, a buzzer will beep. An indicator on
the control panel signals the end of the cycle. Pull the load out
immediately to prevent the formation of creases on laundry.
8. Turn the machine o by pressing the button On/O, open the
door and pull clothing out. If the machine is not switched o
manually, after about a quarter of an hour from the cycle end, the
appliance turns o automatically to save energy.
If this last stage is not carried out immediately, some machines
and/or some programmes/options are equipped with Crease Care
system. For some hours, after the end of drying, the drum rotates at
regular intervals to prevent the formation of creases.
In case of power failure, it is necessary to press the button Start/
Pause to restart the cycle.
PUSH & GO
This function serves to start a cycle, after machine switching on,
without enabling any further button an/or knob (the programme
PUSH & GO will be deactivated instead).
It is always necessary to follow the points 1, 2, and 3
concerning the daily use.
To start the cycle Touch & GO, keep the button pressed. The light
on signals that the cycle is started. The cycle is suitable for cotton
and synthetic textiles. Max. load 4 kg. (Cycle durat ion 140’).
If the door is opened during the cycle, to restart it, close the door and
press the button START/PAUSE. This programme does not allow to set
other options.
OPENING OF THE DOOR DURING THE CYCLE
During operation, it is possible to open the door. After having closed it,
press the button Start/Pause again to restart the dryer.
PROGRAMMES
Eco cotton kg Max* Time 197'
Standard cotton programme, suitable to dry normally wet
cotton laundry. Most ecient programme in terms of energy
consumption for drying cotton laundry. The values on the Energy
Label are based on this programme.
Synthetics kg 4 Time 106'
For drying laundry made of synthetic bres.
Mixed kg 4 Time 106'
This programme is ideal for drying cotton and synthetic fabrics
together.
Mini synthetics kg 2 Time 72'
Eco-drying of small laundry loads.
Mini cotton kg 2 Time 107'
Eco-drying of small laundry loads.
Delicates kg 2 Time 66'
For drying delicate laundry requiring a gentle treatment.
Wool kg 1 Time 130'
Programme for drying wool clothing. It is advisable to turn the
garments inside out before drying. Leave to dry naturally the heaviest
edges that are still damp.
*MAX LOAD 7 Kg (Dry load)
CARE LABEL
Always check the care labels, especially when placing garments in
the tumble dryer for the rst time. Below are the most commonly
used symbols:
May be tumble dried.
Do not tumble dry.
Tumble dry – high heat.
Tumble dry – low heat.
The duration of these programs will depend on the size of the
load, types of textiles, the spin speed used in your washer and
any extra options selected. In machines equipped with display,
the duration of the cycles is shown on the control panel. The
remaining time is constantly checked and adjusted during the
drying cycle to show the best possible estimate.
Refresh
A short programme suitable for refreshing bres and
garments by means of fresh air. Do not use with garments
that are still wet. It can be used on with any load size but is
more eective with small loads. The cycle duration is about 20
minutes.
Jeans kg 3 Time 127'
For drying cotton jeans-wear and garments made of robust
cotton, like denim, such as trousers and jackets.
Duvet Time 179'
Programme intended to dry bulky garments, as single duvet.
Baby kg 2 Time 107'
A programme intended to dry garments and linen of
new-born babies (cotton and chenille), as well as delicate
garments. Do not dry garments having plastic covering.
Shirts kg 3 Time 137'
This is a programme for Shirts made from cotton or cotton
blend/synthetics.
Sport kg 4 Time 96'
For drying sports garments made of synthetics or cotton
blends.
Sport shoes 1 pair Time 101'
This programme is intended to dry a pair of sport shoes.
The shoes must be washed and spun at a minimum spin speed
of 400 revolutions. It is necessary to use the apposite shoe rack
supplied. Only dry shoes made of synthetic material or canvas.
Xpress 45' kg 1
This is a quick timed programme, ideal for drying garments
spun at high speed in the washing machine, e.g. the shirts used
in a working week.
.
OPTIONS
After selecting the programme, the various options can be
set, if necessary.
Dryness level
Press the related button several times to obtain a dierent
level of residual moisture on garments. An indicator signals the
level being selected.
Iron dry: a very delicate ironing. Suitable for making ironing
of garments easier immediately after the end of the cycle.
Hanger dry: a level intended for delicate garments ready to
be hanged.
Cupboard dry: the garments are ready to be folded and put
away.
Extra dry: used for garments to be worn at the end of the
cycle.
Timed dryning
This option allows to set the drying time. Press the
corresponding button to set the required time for drying. An
indicator on the control panel signals the time being selected.
Start delay
This option allows you to set the delay of the cycle start. Press
the corresponding button several times to obtain the required
delay. After having reached the max. settable time, the option is
reset by pressing the button again. An indicator on the control
panel signals the time being selected. After having pressed the
button Start/Pause, the machine signals the remaining time for the
cycle start. In case of door opening, after closing, it is necessary to
press the button Start/Pause.
Light dry
Enables a more gentle treatment of the laundry by reducing
the drying temperature.
Crease care
This option add a crease treatment at the end of the cycle by
means of a periodic rotation of the drum (duration up to 10 hours).
It is particularly suitable when it is not possible to remove the
laundry as soon as the drying ends. If this option is used together
with the Start Delay, the crease treatment is added also in the
Start Delay phase. This option remains in memory if selected in
the previous drying.
Key lock
This option makes all machine controls inaccesible, except
the button On/O. When the machine is on:
• to activate the option, keep the button pressed until the
indicator goes on.
• to disable the option, keep the button pressed until the
indicator goes o.
This option remains in memory if selected in the previous drying.
Cycle end
This option activates a prolonged buzzer at the end of the
cycle. Enable it if you are not sure to hear the normal sound at the
end of the cycle. This option remains in memory if selected in the
previous drying.
OPTIONS BUTTONS
These buttons serves to personalise the selected programme
according to personal requirements.
Not all options are available for all programmes. Some options
are incompatible with the ones previously set. The buzzer and/or
blinking indicators will signal the incompatibility. If the option is
available, the option indicator will stay on. Some options may be
kept in the memory of the programme if selected in the previous
drying.
USE OF SHOE RACK
Remove the door lter and place
the shoe rack. Put shoelaces
into the shoes with the shoe tips
facing downwards and the soles
frontwards. Do not add garments
or other shoes into the drum.
Position the door lter back in place
at the end of drying.