INDESIT YT CM08 8B IL Daily Reference Guide
THANK YOU FOR BUYING A INDESIT PRODUCT.
EN
Quick guide
In order to receive a more complete assistance,
please register your product on
www.indesit.eu/register
Before using the appliance carefully read the Safety Instructions.
CONTROL PANEL
1 ON/OFF button (Reset if long pressed)
2 Programme selection knob
3 Start/Pause button (Start: button lights up solidly. Pause: button
blinks)
4 Push & GO
Options Buttons*
5 Start delay
6 Crease care
7 Key lock
2
*Note: some models may have the wording in full instead of the icons
INDICATORS
Cycle phase: Dry - Cool tumble - END End of cycle
When the same indicators of the cycle phase are blinking, they show the start delay of the programme set.
Empty water tank Clean door lter Clean bottom lter
6h3h 9h
3”
1
5
6
7
4
3
FIRST TIME USE
Make sure that the water tank is correctly inserted. Make sure
that the drain hose on the back of the dyrer is properly xed,
either to the dryers's water tank or to the domestic sewage
system.
DAILY USE
Doing this will keep your machine working at its BEST!
Remember to empty your water tank after each drying cycle.
Remember to clean your lters after each drying cycle. (Refer to
section Care & Maintanence).
1. Open the door and load garments. Always refer to instructions
on clothing labels and the max loads indicated in the programme
section. Empty pockets. Make sure garments do not get caught
between the door and/or the door lter.
2. Close the door.
3. Press the button On/O .
4. Select the programme according to the laundry type.
5. Select the options, if necessary.
6. To start the cycle, press the Start/Pause button.
7. At the end of the drying cycle, a buzzer will beep. An indicator on
the control panel signals the end of the cycle. Pull the load out
immediately to prevent the formation of creases on laundry.
8. Turn the machine o by pressing the button On/O, open the
door and pull clothing out. If the machine is not switched o
manually, after about a quarter of an hour from the cycle end, the
appliance turns o automatically to save energy.
If this last stage is not carried out immediately, some machines
and/or some programmes/options are equipped with Crease Care
system. For some hours, after the end of drying, the drum rotates at
regular intervals to prevent the formation of creases.
In case of power failure, it is necessary to press the button Start/
Pause to restart the cycle.
PUSH & GO
This function serves to start a cycle, after machine switching on,
without enabling any further button an/or knob (the programme
PUSH & GO will be deactivated instead).
It is always necessary to follow the points 1, 2, and 3 concerning
the daily use.
To start the cycle Touch & GO, keep the button pressed. The light on
signals that the cycle is started. The cycle is suitable for cotton and
synthetic textiles. Max. load 4 kg. (Cycle duration 100’).
If the door is opened during the cycle, to restart it, close the door and
press the button START/PAUSE. This programme does not allow to set
other options.
OPENING OF THE DOOR DURING THE CYCLE
During operation, it is possible to open the door. After having closed it,
press the button Start/Pause again to restart the dryer.
*MAX LOAD 8 Kg (Dry load)
CARE LABEL
Always check the care labels, especially when placing garments in
the tumble dryer for the rst time. Below are the most commonly
used symbols:
May be tumble dried.
Do not tumble dry.
Tumble dry – high heat.
Tumble dry – low heat.
extra
The duration of these programs will depend on the size of the
load, types of textiles, the spin speed used in your washer and
any extra options selected. In machines equipped with display,
the duration of the cycles is shown on the control panel. The
remaining time is constantly checked and adjusted during the
drying cycle to show the best possible estimate.
PROGRAMMES
Mixed kg 4 Time 130'
This programme is ideal for drying cotton and synthetic
fabrics together.
Cottons
Extra Dry kg Max* Time 150'
Programme suitable for drying cotton garments ready to
wear.
Cupboard Dry kg Max* Time 130'
Standard cotton programme, suitable to dry normally
wet cotton laundry. Most ecient programme in terms of
energy consumption for drying cotton laundry. The values on the
Energy Label are based on this programme.
Iron Dry kg Max* Time 110'
Drying for cotton garments intended to make ironing easier,
immediately after the end of the cycle.
Synthetics
Cupboard Dry kg 4 Time 90'
Programme to dry synthetics and put them away directly.
Iron Dry kg 4 Time 77'
Drying suitable for synthetic garments. It is intended to make
ironing easier, immediately after the end of the cycle.
Shirts kg 3 Time 70'
This is a programme for shirts made from cotton or cotton
blend/synthetics
Refresh
A short programme suitable for refreshing bres and
garments by means of fresh air. Do not use with garments
that are still wet. It can be used on with any load size but is
more eective with small loads. The cycle duration is about 20
minutes.
OPTIONS BUTTONS
These buttons serves to personalise the selected programme
according to personal requirements.
Not all options are available for all programmes. Some options
are incompatible with the ones previously set. The buzzer and/or
blinking indicators will signal the incompatibility. If the option is
available, the option indicator will stay on. Some options may be
kept in the memory of the programme if selected in the previous
drying.
OPTIONS
After selecting the programme, the various options can be
set, if necessary.
Start delay
This option allows you to set the delay of the cycle start. Press
the corresponding button several times to obtain the required
delay. After having reached the max. settable time, the option is
reset by pressing the button again. An indicator on the control
panel signals the time being selected. After having pressed the
button Start/Pause, the machine signals the remaining time for the
cycle start. In case of door opening, after closing, it is necessary to
press the button Start/Pause.
Key lock
This option makes all machine controls inaccesible, except
the button On/O. When the machine is on:
• to activate the option, keep the button pressed until the
indicator goes on.
• to disable the option, keep the button pressed until the indicator
goes o.
This option remains in memory if selected in the previous drying.
Crease care
This option add a crease treatment at the end of the cycle by
means of a periodic rotation of the drum (duration up to 10 hours).
It is particularly suitable when it is not possible to remove the
laundry as soon as the drying ends. If this option is used together
with the Start Delay, the crease treatment is added also in the
Start Delay phase. This option remains in memory if selected in
the previous drying.
Specials
Delicates kg 2 Time 45'
For drying delicate laundry requiring a gentle treatment.
Wool kg 1 Time 100'
Programme for drying wool clothing. It is advisable to turn
the garments inside out before drying. Leave to dry naturally the
heaviest edges that are still damp.
Sport kg 4 Time 90'
For drying sports garments made of synthetics or cotton
blends.
Dry Time
These programmes can be used in order to set the drying time.
Loading...