INDESIT OS B 100 (RU) User Manual

EN

INSTRUCTIONS FOR USE

IMPORTANT SAFETY INSTRUCTIONS

• WARNING: to avoid a hazard due
to instability, positioning or fixing of
the appliance must be done in
accordance with the manufacturer
instructions.

• WARNING: keep the appliance
ventilation openings clear of
obstruction.

• WARNING: do not damage the
appliance refrigerant circuit pipes.

• WARNING: Do not use
mechanical, electric or chemical
means other than those
recommended by the Manufacturer
to speed up the defrost process.

• WARNING: Do not use or place
electrical devices inside the
appliance compartments if they are
not of the type expressly authorised
by the Manufacturer.

Information: This appliance does
not contain CFCs. The refrigerant
circuit contains R134a (HFC) or
R600a (HC) (see the rating plate
inside the appliance).

• Appliances with Isobutane
(R600a): isobutane is a natural gas
without environmental impact, but is
flammable. Therefore, make sure
the refrigerant circuit pipes are not
damaged. Keep special attention in
case of damaged pipes emptying
the refrigerant circuit.

The amount of space (the volume of
the room) must be 1 m3 per each 8 g
of R600a refrigerant in the product.
The amount of refrigerant contained
in your specific product is indicated
on the rating plate (identification
plate) inside the product.

• This product may contain
Fluorinated Greenhouse Gases
covered by the Kyoto Protocol; the
refrigerant gas is inside a
hermetically sealed system.
Refrigerant gas: R134a has a Global
Warming Potential of (GWP) 1300.

• C-Pentane is used as blowing
agent in the insulation foam and it is
a flammable gas. Pay special
attention during disposal
operations.

• This appliance is intended to be
used in household and similar
applications such as

- staff kitchen areas in shops,
offices and other working
environments;

- farm houses and by clients in
hotels, motels and other residential
type environments;

- bed and breakfast type
environments;

- catering and similar non-retail
applications

• Do not store explosive substances
such as aerosol cans with a flammable
propellant in this appliance.

INSTRUCTIONS FOR USE

• This appliance can be used by
children aged from 8 years and
above and persons with reduced
physical, sensory or mental
capabilities or lack of experience
and knowledge if they have been
given supervision or instruction
concerning use of the appliance in a
safe way and understand the
hazards involved.

• Cleaning and user maintenance
shall not be made by children
without supervision.

• To avoid the risk of children
becoming trapped and suffocating,
do not allow them to play or hide
inside the appliance.

• It must be possible to disconnect
the appliance from the power
supply by unplugging it if plug is
accessible, or by means of an
accessible multi-pole switch
installed upstream of the socket in
conformity with national safety
standards.

• Plug the appliance into a
grounding socket: the appliance
must be correctly connected to an
approved earthing system.

• Do not use single/multi adapters
or extension cords.

• During installation, make sure the
appliance does not damage the
power cable.

• Do not pull the appliance power cable.

• The appliance must be handled
and installed by two or more
persons.

• Installation and maintenance including
replacement of the supply cord must be
carried out by the manufacturer or a
qualified technician, in compliance with
the manufacturer’s instructions and the
local safety regulations in force. In order
to avoid a hazard do not repair or
replace any part of the appliance
including the supply cord, unless
specifically stated in the user manual.

• The product is designed for indoor
use only. At any circumstances, do
not use the refrigerator out of it.

• Do not touch the refrigerator with
wet hands.

• The re-enable of the device (for
example, if you accidentally turned
it off) is carried out in 5-10 minutes.

1. Packing

SAFEGUARDING THE ENVIRONMENT

The packing material is 100% recyclable and bears
the recycling symbol . For disposal, comply with
the local regulations. Keep the packing materials
(plastic bags, polystyrene parts, etc.) out of the reach
of children, as they are a potential source of danger.

2. Scrapping/Disposal

The appliance is manufactured using recyclable
material.

This appliance is marked in compliance with
European Directive 2002/96/EC on Waste Electrical
and Electronic Equipment (WEEE). By ensuring the
correct disposal of this appliance, you can help
prevent potentially negative consequences for the
environment and the health of persons.

The symbol on the appliance, or on the

INSTRUCTIONS FOR USE

accompanying documents, indicates that this
appliance should not be treated as domestic waste
but must be taken to a special collection centre for the
recycling of electrical and electronic equipment.
When scrapping the appliance, make it unusable by
cutting off the power cable and removing the doors
and shelves so that children cannot easily climb inside
and become trapped.
Scrap the appliance in compliance with local
regulations on waste disposal, taking it to a special
collection centre; do not leave the appliance
unattended even for a few days, since it is a potential
source of danger for children.
For further information on the treatment, recovery and
recycling of this product, contact your competent local

BEFORE USING THE APPLIANCE

To ensure best use of your appliance, carefully
read the operating instructions which contain a
description of the product and useful advice.
Keep these instructions for future reference.

1. After unpacking the appliance, make sure it is not

damaged and that the door closes properly. Any

Transportation and storage rules

Packaged product should be stored at a relative
humidity of 80% in closed rooms (indoors) with
natural ventilation.
If the product is not used in a long period of time, it
must be unplugged from the electrical network. Also
you need to remove all products, defrost it and clean
all the cameras. The doors after cleaning should be
left slightly opened in order to prevent the appearance
of bad odor.
The product must be transported in vertical position
(in operating postion) and fastened securely in any
type of roofed transport.
Do not expose the product to impact loads.

INSTALLATION

• Be careful not to damage the floors (e.g. parquet)

when moving the appliance.

• Make sure the appliance is not near a heat source.

• Install and level the appliance on a floor strong
enough to take its weight and in a place suitable for
its size and use.

• The appliance is arranged for operation in places
where the temperature comes within the following
ranges, according to the climatic class given on the
rating plate. The appliance may not work properly if it
is left for a long time at a temperature outside the
specified range.

PRECAUTIONS AND GENERAL RECOMMENDATIONS

office, the household waste collection service or the
shop where you purchased the appliance.

Declaration of conformity

• This appliance has been designed for preserving
food and is manufactured in compliance with
Regulation (CE) No. 1935/2004.

• This appliance has been designed, manufactured
and marketed in compliance with:

- safety objectives of the “Low Voltage” Directive
2006/95/CE (which replaces 73/23/CEE and
subsequent amendments);

- the protection requirements of Directive “EMC”
2004/108/EC.

damage must be reported to the dealer within 24
hours of delivery of the appliance.

2. Wait at least two hours before switching the
appliance on, to ensure that the refrigerant circuit is
fully efficient.

3. Clean the inside of the appliance before using it.

Climatic Class Amb. T. (°C)

SN From 10 to 32

N From 16 to 32

ST From 16 to 38

• Make sure the voltage specified on the rating plate
corresponds to that of your home.

Connection to the power grid/electrical network
(to the mains)

Refrigerator is made by the 1 class degree of
protection from the electric shock and is connected to
the mains power via a two-pole socket outlets.
Before plugging make sure that:

- the mains voltage corresponds with the
specifications on the label (220-240V);

- the third ground prong of the electrical socket is
directly connected to the ground wire of the supply
mains cable (connecting wire must be rated for a
current of at least 10A);

- socket and the plug of the same type; If the plug does
not fit the socket, the socket should be replaced with
the corresponding plug of the supply cord (operation
must be performed by a qualified electrician).

T From 16 to 43