INDESIT IDVL 75 BR.9 UK User Manual
Instruction manual
GB
English
TUMBLE DRYER
Contents
Installation, 2
Warnings, 4
Care and maintenance, 6
Description of the tumble dryer, 7
How to carry out a drying cycle, 9
Programmes and options, 10
Laundry, 13
Troubleshooting, 14
Assistance, 15
www.indesit.com
This symbol reminds you to read this
instruction manual.
! Keep this manual at hand for immediate reference whenever
necessary. Always store this manual close to the tumble dryer and
remember to pass it on to any new owners when selling or tran-
sferring the appliance, so they may familiarise with the warnings
and suggestions herein contained.
! Read these instructions carefully: the following pages contain
important information on installation and useful suggestions for
operating the appliance.
1
Installation
m
B
A
GB
Where to install the tumble dryer
If the dryer is installed below a worktop,
ensure there are 10 mm
between the upper panel of the dryer and any
objects above it, and 15
mm between the sides
of the machine and the
walls or furniture units
adjacent to it. This ensures adequate air circulation. Make sure the air
inlets on the rear panel are not blocked or
obstructed.
Ventilation
This appliance gently dries laundry by taking in cold, clean
and relatively dry air, heating it and passing it through the
fabric. To facilitate the drying process, damp air is expelled
at the rear, through a ventilation hose. When the dryer is in
use, there has to be adequate ventilation to avoid a back
flow of gases into the room from appliances burning other
fuels, including open fires.
Mobile ventilation system
When using the tumble dryer with the mobile ventilation
system, a ventilation hose must be connected. The hose
should be securely fastened to the ventilation hole at
the rear of the appliance (see “Description of the tumble
dryer”). We recommend the hose is connected to an outlet
near the tumble dryer, if possible. If it cannot be installed
in a permanent spot, the tumble dryer will still function
perfectly well if the ventilation hose is passed through a
partially-opened window.
Make sure you do not point the ventilation hose towards
the air inlet, which is located on the rear of the appliance.
The ventilation hose should not exceed a maximum
length of 2.4 metres; it should also be shaken frequently
to remove any fluff, dust or water deposits inside it. Make
sure you do not crush the hose. The hose supplied has an
oval section to aid installation.
Fixed ventilation kit
We recommend the ventilation hose is connected to a
ventilation kit for windows or doors, available from the
retailer which originally sold you the appliance or from your
local spare parts stockist.
air coming out is not impeded.
Areas A and B should be checked frequently, to prevent
the accumulation of fluff or debris, particularly if the tumble
dryer is used very often. The hose adaptor must be fitted
correctly, in order to prevent damp air from coming back
into the room.
Ventilation hole
The ventilation hole should be directly behind the dryer in
order to keep the hose as short as possible.
Make sure you do not push the tumble dryer too far
backwards, as this could lead to the ventilation hose being
crushed, bent or even disconnected.
There should be no cuts, kinks or “U”-shaped bends
in the hose, as these could impede ventilation or trap
condensation.
The end of the hose must be facing downwards, in order to
prevent the hot, damp air from forming condensation in the
room or the tumble dryer.
Make sure that the tumble dryer is adequately ventilated,
and that the end of the ventilation hose is not pointing
towards the air inlet pipe on the rear of the appliance.
The ventilation hose must always be fitted to ensure
optimum performance.
The hose will need to be
expanded to be fitted and
clamped.
Make sure that the ventilation
hose, air inlet vents, and outlets
are not obstructed or blocked.
Do not let the tumble dryer
recirculate exhaust air.
Improper use of the tumble
dryer may result in fire hazards.
Ventilation
The air emitted by the tumble dryer must not be expelled in
the same duct as used for the fumes produced by different
appliances which burn gas or other fuels.
Do not discharge the exhaust air into an extraction system
or any duct with an extractor fan. This will affect the way
the thermal controls operate and can result in a fire hazard.
Make sure that the room in which the
tumble dryer is installed is not damp, and
that it is adequately ventilated.
Wall ventilation hole
1. Leave an opening in the wall.
2. Make the hose as short and
straight as possible, in order
to prevent any moisture from
condensing and leaking back
into the appliance.
2
3. The hole in the wall must
also be straight and pointing
downwards, so that the flow of
We do not recommend that the dryer is
installed in a cupboard but the dryer must
never be installed behind a lockable door,
a sliding door or a door with a hinge on the
opposite side to that of the dryer door.
The appliance must be installed with the
rear surface placed against a wall.
Electrical connections
After installing the tumble dryer in its permanent position,
make sure it is level; check its side-to-side levelling first,
block to support it while you adjust the two front feet, up or
drum before operating it and remove any dirt accumulated
Before plugging the appliance into the socket, check the following:
Make sure your hands are dry.
The socket must have an earth connec-
tion.
The socket must be able to withstand the
machine’s maximum power output as indicated on the rating plate (see Description of
the tumble dryer).
The power supply voltage must fall within
the values indicated on the rating plate (see
Description of the tumble dryer).
Do not use extension leads. Do not pull
the power supply cable. Do not use multiple
plug adaptors if the appliance is fitted with a
plug. For appliances with fitted plug, if the
plug is not suitable for you socket outlet,
contact a qualified technician.
Levelling the tumble dryer
The tumble dryer should be installed level in order to
operate correctly.
followed by front-to-back.
If the tumble dryer is not perfectly level, use a wooden
down as necessary.
Before you start your dryer
Once the tumble dryer is installed, clean the inside of the
GB
The dryer must not be installed outdoors,
even if the space is sheltered.
Once installed, the dryer’s electrical wire
and plug must be within reach.
The power cord must not be bent or
squashed.
If the plug being replaced is a nonrewirable type, then the cut-off plug must be
disposed of safely. DO NOT leave it where it
can be inserted into a socket and create a
shock hazard.
The electric cord must be regularly
checked. If the supply cord is damaged, it
must be replaced by service agent. (see
Service).
The manufacturer denies any
responsibility should any of these rules not
be followed.
during transportation.
If in doubt about any of the above consult
a qualified electrician.
3
Warnings
GB
! This appliance has been designed and built according to
international safety standards. These warnings are given
for safety reasons and must be followed carefully.
General safety
•This appliance can be used by children
aged from 8 years and above and
persons with reduced physical, sensory or
mental capabilities or lack of experience
and knowledge if they have been given
supervision or instruction concerning
use of the appliance in a safe way and
understand the hazards involved.
• This tumble dryer has been designed for
home, and not professional, use.
• Do not touch the appliance while barefoot
or with wet hands or feet.
• Unplug the machine by pulling on the plug,
not the cord.
•Children should be supervised to ensure
that they do not play with the dryer.
•Cleaning and user maintenance shall not
be made by children without supervision.
•Children of less than 3 years should be
kept away from the appliance unless
continuously supervised.
• The appliance must be installed correctly
and have proper ventilation. The air intake
vents behind the machine, the outlet
vents and the vent tube should never be
obstructed (see Installation).
• Never direct the vent tube outlet towards
the air intake at the back of the machine.
• Never allow the tumble dryer to recycle
exhaust air.
• Never use the dryer on carpeting where
the pile height would prevent air from
entering the dryer from the base.
• Check to see if the dryer is empty before
loading it.
•
The back of the dryer could become very
hot. Never touch it while in use.
• Do not use the dryer unless the filter, is
securely in place (see Maintenance).
• Do not overload the dryer (see Laundry for
maximum loads).
• Do not load items that are dripping wet.
• Carefully check all instructions on clothing
labels (see Laundry).
• Do not tumble dry large, very bulky items.
• Do not tumble dry acrylic fibres at high
temperatures.
• Do not turn off the dryer when there are still
warm items inside.
• Clean the filter after each use (see
Maintenance).
• Do not allow lint to collect around the dryer.
• Never climb on top of the dryer. It could
result in damage.
• Always follow electrical standards and
requirements (see Installation).
• Always buy original spare parts and
accessories (see Service).
To minimise the risk of fire in your tumble
dryer, the following should be observed:
• Tumble dry items only if they have been
washed with detergent and water, rinsed
and been through the spin cycle. It is a fire
hazard to dry items that HAVE NOT been
washed with water.
• ●Do not dry garments that have been
treated with chemical products.
• Do not tumble dry items that have
been spotted or soaked with vegetable
or cooking oils, this constitutes a fire
hazard. Oil-affected items can ignite
spontaneously,especially when exposed
to heat sources such as a tumble dryer.
The items become warm, causing
an oxidisation reaction with the oil,
Oxidisation creates heat. If the heat
cannot escape, items can become hot
enough to catch fire. Piling, stacking or
storing oil-effected items can prevent heat
from escaping and so create a fire hazard.
If it is unavoidable that fabrics containing
vegetable or cooking oil or those that have
been contaminated with hair care products
be placed in a tumble dryer they should
first be washed with extra detergent - this
will reduce, but not eliminate the hazard.
They should not be removed from the
dryer and piled or stacked while hot.
• Do not tumble dry items that have
previously been cleaned in or washed in,
soaked in or soiled with petrol/gasoline,
dry cleaning solvents or other flammable
or explosive substances. Highly flammable
substances commonly used in domestic
environments including cooking oil,
acetone, denatured alcohol, kerosene,
spot removers, turpentine, waxes and wax
removers. Ensure these items have been
washed in hot water with an extra amount
of detergent before being dried in the
tumble dryer.
4
• ●Do not tumble dry items containing foam
!
rubber (also known as latex foam), or
similarly textured rubber like materials.
Foam rubber materials can, when heated,
produce fire by spontaneous combustion.
• ●Fabric softener or similar products should
not be used in a tumble dryer to eliminate
the effects of static electricity unless the
practice is specifically recommended by
the manufacturer of the fabric softener
product.
• Do not tumble dry undergarments that
contain metal reinforcements eg. bras
with metal reinforcing wires. Damage to
the tumble dryer can result if the metal
reinforcements come loose during drying.
• Do not tumble dry rubber, plastic articles
such as shower caps or babies waterproof
covers, polythene or paper.
• Do not tumble dry rubber backed articles,
clothes fitted with foam rubber pads,
pillows, galoshes and rubber coated tennis
shoes.
• Remove all objects from pockets such as
lighters and matches.
Maximum load sizes: maximum 7 kg
Power consumption
o-mode (Po) - Watts 0.14
left-on mode (Pl) - Watts 0.14
Programs Kg kWh Minutes
Standard cotton*
Standard cotton
Synthetics 4 1.48 50
* This is the reference program for the energy label
and suitable to dry normal wet cotton laundry. This
is the most ecient programme in terms of energy
consumption for drying wet cotton laundry.
7 3.92 129
3.5 2.16 75
GB
WARNING: Never stop the dryer before the
end of the drying cycle unless all items are
quickly removed and spread out so that the
heat is dissipated.
Save energy and respect the environment
• Wring out all items to eliminate excess water before
tumble drying (if you use a washing machine first, select
a high spin cycle). Doing this will save time and energy
during drying.
• Always dry full loads - you save energy: single items or
small loads take longer to dry.
• Clean the filter after each use to contain energy
consumption costs (see Maintenance).
WARNING
Use a Flexible metal vent tube.
Do not use a plastic vent tube.
Do not block or obstruct the tube in installation.
Failure to follow these instructions can result in death
or fi re.
Fire Hazard
5
Loading...