INDESIT D63 User Manual

Safety Is a Good Habit to Get Into

NOTICE
Carefully read the instruct ions contained in t his manual, as
they provide important inf ormation w hich is essential t o safe
and proper installation, use and maint enance of the
appliance.

This appliance complies w ith the follow ing EEC
directives:

- 73/ 23/ EEC of 19/ 02/73 (Low Voltage) and subsequent
modifications;

- 89/ 336/ EEC of 03/ 05/ 89 (Electromagnetic Compatibilit y)
and subsequent modifications.

1.Caref ully dispose of the packing material.

2.After removing t he packing, check to make sure t hat the

appliance is not damaged. If in doubt, cont act a qualified
prof essional.

3.The dishwasher must only be used by adult s for the w ashing

of household dishes and cooking ut ensils.

4.Fundament al rules to follow when using the appliance:

- Never t ouch t he dishwasher w hen barefoot or w ith w et
hands or feet;

- W e discourage t he use of ext ension cords and multiple
socket s;

- During installation, the pow er supply cord must not be

excessively or dangerously bent o r flattened;

- If t he appliance is not operating properly or main t enance
must b e performed, d isconnect the appliance from the pow er
supply.

5.Keep detergents ou t of t he reach of children, w ho must

also be kept away from the dishw asher w hen it is open.

6.This appliance cannot be installed outdoors, not even if

the area in w hich it is installed is covered by a roof; it is also
very dangerous to leave it exposed to the rain and element s.

7.Do not touch t he heating element during or af t er a w ash

cycle.

8.Do not lean or sit on t he door when it is open, as this

could overt urn the dishw asher.

9.If the appliance malfunctions, turn off w ater supply to the

appliance and disconnect t he plug from t he w all socket.
Then, consult the section entitled, " Troubleshoot ing." If you
cannot resolve t he prob lem, contact a service centre.

10.Appliances w hich are no longer being used m ust be m ade

inoperable by cutting t he pow er supply cord and removing
the door lock.

To maint ain the EFFICIENCY and SAFETY of
this appliance, w e recommend:

l use only the M ANUFACTURER Service
l use only ORIGINAL Spare Parts

Close-up View (control panel)

E

B

A

ON - OFF Button

ON - OFF Light

Handle For Opening Door

H

F

I

C

D

"INTENSIVE 65°C" Butt on

"HALF LOAD" Button

Low Salt Indicator Light

Knob For Selecting Cycles

Low Rinse Aid Indicator Light

1

GB

Close-up View (Interior)

J

E

G

F

H

I

L

K

Upper Rack

Top Sprayer Arm

Rack Height Adjustor

Low er Rack

Bottom Sprayer Arm

Salt Container Cap

Washing Filter

Detergent and Rinse Aid Dispenser

Technical characteristics

Width cm. 60

Depth cm. 60

GB

Height cm. 85

Capacity 12 standard place sett ings

M ains water pressure 20 KPa÷ 1M Pa (0,2 ÷10 bar)

Pow er voltage See data plate

Total absorber pow er See data plate

Fuse See data plate

2

Salt ......

Salt

The hardness of t he w ater varies from place to place. If
hard w ater is used in the d ishw asher, deposits w ill f orm on
the dishes and utensils.
The appliance is equipped w ith a special softener that uses
a salt specifically designed to eliminate lime and minerals
from t h e w ater.

Loading the Salt into t he Softener

Always use salt intended for use w it h dishw ashers.
The salt container is locat ed beneath t he low er rack and
should be f illed as follow s:

1. Remove the lo w er rack and then unscrew and remove
the cap from the salt container;

2. If you are f illing the cont ainer for t he first time, f ill it w ith
w ater;

3. Place the end of t he funnel (supplied) into the hole and
int roduce about 2 kg of salt. It is normal f or a small amount
of water t o come out of the salt container.

4. Carefully screw the cap back on.

Adjusting Salt Consumpt ion

The dishw ash er is designed to
allow f or adjusting the amount
of salt consumed based on the
harness of t he w ater used. This
is intend ed to optimize and cus­tom ize the level of salt consump­tion so t hat it remains at a mini­mum.
Your Local Wat er Board can
supply the degree of hardness of
the w ater
in your area.
To adjust salt consumption, proceed as follow s:

1) Unscrew t he cap from t he salt cont ain er.

2) There is a rin g on t he con t ainer w ith an arrow on it (see
figure t o t he side), if necessary, rot at e t he ring in t he ant i­clockwise direction from t he "_" sett ing t ow ards the " +"
sign, based on t he hardness of t he w ater being used.
It is recommended t hat adjustm ents be made in accord­ance w ith the f ollow ing schema:

The salt container must be filled w hen the "low salt"
indicator light (located on the control panel) comes
on.

Warning: To prevent rust from forming, w e advise you t o

load t he salt before start ing a w ash cycle.

Water Hardness

Salt

Clarke

degrees

0 ¸ 14 0 ¸ 17 0 ¸ 1,7 / 0 /

14¸ 36 18 ¸ 44 1,8 ¸ 4,4 "-" 20 60

36 ¸ 71 45 ¸ 89 4,5 ¸ 8,9 M ED 40 40

>71 > 89 > 8,9 "+" 60 25

°dH mmol/ l

Selector
position

consu­mption

(grams/­cycle)

Autono­my

(cycles\2­kg)

3

GB

Detergent and Rinse Aid ....

Detergent

Detergent specifically intended for use w ith dishw ashers must
be used. The dispenser must be ref illed bef ore t he start o f
each w ash cycle f ollow ing the instruct ions provided in the
" Wash Cycle Table." The detergent dispenser is locat ed on
the inside panel of t h e door.

Loading the detergent

To open lid " A" , press button " B" . The cleaning detergent
should be introdu ced into the t w o containers " C" and " D"
up t o the rim .
Af ter pouring in t he detergent, replace t he lid, pressing dow n
until it clicks.

A

D

22

gr.

8

C

gr.

Rinse Aid

This product makes dishes sparkle and help s them to dry
w ithout spot ting. The dispenser is located on the inside panel
of the door and should be filled after every 80 w ash cycles
(or w hen the rinse aid indicator light comes on f or those
models with this featu re).

Loading the Rinse Aid

To open t he dispenser, turn t he " C" cap in the anti-clockw ise
direction and t hen pour in the rinse aid, making sure not t o
overf ill. The am ount of rinse aid used for each cycle can be
regulated by t urning t he " F" dose adjustor, located beneath
the " C" cap, w ith a screwdriver. There are 6 dif f erent
sett ings; the normal dosage setting is 3.

Important :

Proper dosage of t he rinse aid improves drying.
If drops of w at er remain on t he dishes or spot t ing occurs,
the dosage adjustor should be turned to a higher sett ing. If
the dishes have w hite streaks, turn t he dosage adjustor t o a
low er setting.

B

Dishwasher detergent in t ablets is now available on the
market , in w hich case you should place one tablet int o
container " D" and replace t he lid.

Those Institut es which carry out comp arat ive t ests should
keep to the dosage indications contained in the w ash cycle
table.

Notice: To facilitate closing t he cover, remove any
excess detergent on t he edges of t he dispenser.

C

F

GB

4