INDESIT BI WMIL 91484 UK Daily Reference Guide
Quick Guide
1
2
3
THANK YOU FOR BUYING A INDESIT PRODUCT
In order to receive a more complete assistance,
please register your product on
www.indesit.com/register
CONTROL PANEL
1. ON/OFF button
2. START/PAUSE button with indicator light
3. WASH CYCLE PROGRESS indicator lights
4. DOOR LOCKED indicator light
5. FUNCTION buttons with indicator lights
6. CHILDLOCK button with indicator light
7. DELAY TIMER button
8. SPIN button
9. TEMPERATURE button
10. WASH CYCLE knob
11. PUSH & GO button
Before using the appliance carefully read the Safety Instruction.
Before using the machine, it is imperative that the transport bolts are removed.
For more detailed instructions on how to remove them, see the Installation Guide.
1
2
4
3
GB
5
WASH CYCLE TABLE
Maximum load 8 kg
Power input in o mode 0,5 W / in left-on mode 8 W
Temperature
Wash cycle
Setting Range 2 3
1 Cotton 30° 30°C
2 Synthetics 30° 30°C
3 Colours 30°C
4 Delicates 30°C
5 Rapid 30’ 30°C
6 Cotton (2) 40°C
7 Synthetics (3) 40°C
8 Mixed 40°C
– 30°C
– 30°C
– 30°C
– 30°C
– 30°C
– 60°C
– 60°C
– 40°C
9 Eco 40-60 (1) 40°C 40°C
10 White Cotton 60°C
11 Sport 40°C
12 20°C 20 °C
13 Wool 40°C
14 Anti odour 40°C
– 90°C
– 40°C
- 20 °C
– 40°C
– 40°C
Rinse + Spin – – 1400 9,0 0:55 –
Spin + Drain * – – 1400 9,0 0:10 – – – – – – – –
Required dosage Optional dosage
6 Eco Cotton (4)
The cycle duration indicated on the display or instruction manual is an estimate based on
standard conditions. The actual duration may vary in relation to several factors, such as
the temperature and pressure of the incoming water, ambient temperature, amount of
detergent, load quantity and type, load balancing and any additional options selected. The
values given for programmes other than the Eco 40-60 programme are indicative only.
1) Eco 40-60 - Test wash cycle in compliance with EU Ecodesign regulation 2019/2014. The
most ecient programme in terms of energy and water consumption for washing normally
soiled cotton laundry.
For all testing institutes:
2) Long cotton cycle: set cycle 6 at a temperature of 40°C.
3) Long synthetics cycle: set cycle 7 at a temperature of 40°C.
60 °C 60 °C 1400 9,0 4:00
40 °C 40 °C 1400 9,0 3:55
Maximum
spin
(r.p.m.)
Maximum
load
(kg)
1000 4,5 1:40
1000 4,5 1:30
1000 4,5 1:35
0 1,0 1:20
800 4,5 0:30
1400 9,0 3:55
1400 4,0 2:55
1400 9,0 1:45
1351 9,0 3:40
1351 4,0 2:50
1351 2,0 2:10
1400 9,0 2:45
600 3,5 1:35
1400 9,0 1:50
800 2,0 1:25
1000 3,5 1:45
Duration
(h : m)
11
10
Detergents and
Additives
Wash
Fabric
softener
Recommended
Powder Liquid
detergent
–
–
–
–
–
9
–
–
–
–
–
– – – – – –
Note: for the Eco 40-60 program in the WASH CYCLE TABLE the value of the maximum
eective spin is shown.
* By selecting the cycle and excluding the spin cycle, the washing machine will drain only.
** After programme end and spinning with maximum selectable spin speed, in default
programme setting.
4) Eco Cotton - Test wash cycles in compliance with regulations 1061/2010. Set “6” wash cycle
at a temperature of 40°C or 60°C to access this cycles.
7
8
Residual
tion kWh
dampness %(**)
Energy consump-
– – – –
– – – –
– – – –
– – – –
71 0,20 45 27
49 1,10 95 40
35 0,75 55 43
– – – –
54 0,86 54 38
54 0,68 54 37
54 0,46 40 34
49 0,90 90 55
– – – –
49 0,16 90 22
– – – –
– – – –
54 0,80 56 –
49 1,10 95 –
Total water l
6
Laundry
temperature °C
PRODUCT DESCRIPTION
1. Top
2. Detergent dispenser drawer
3. Control panel
4. Handle
5. Porthole door
6. Drain pump
7. Adjustable feet (4)
DETERGENT DISPENSER DRAWER
1.
2.
Compartment 1:
3.
Do not insert detergent in this compartment.
Compartment 2: Washing detergent (powder
or liquid)
Compartment 3: Additives (fabric softener, etc.)
4.
The fabric softener must never exceed the
“max” level indicated on the central pin.
5.
! Use powder detergent for white cotton
garments, for pre-washing, and for washing at
6.
temperatures over 60°C.
! Follow the instructions given on the detergent
packaging.
7.
WASH CYCLES
Follow the instructions on the symbols of the garment’s wash
care label. The value indicated in the symbol is the maximum
recommended temperature for washing the garment.
Cotton 30°
A 30°C cycle for cotton garments. It allows for reducing electricity
consumption for heating the water while guaranteeing good washing
performance. Suitable for lightly soiled garments.
Synthetics 30°
A 30°C cycle for synthetic garments. It allows for reducing electricity
consumption for heating the water while guaranteeing good washing
results. Suitable for lightly soiled garments.
Colours
A 30°C cycle that helps to preserve colours, suitable for cotton or
synthetic coloured garments. It allows for reducing electricity
consumption for heating the water while guaranteeing good washing
results. Suitable for lightly soiled garments.
Delicates
Suitable for washing very delicate garments. It is advisable to turn the
garments inside out before washing them. For best results, use liquid
detergent on delicate garments. For washing silk items and curtains,
select cycle 4 and activate the option.
Rapid 30’
For washing lightly soiled garments in a short time. Not suitable for wool,
silk and garments to be washed by hand.
Cotton
Suitable for washing towels, underwear, table cloths, etc. made of
resistant linen and cotton that are moderately to heavily soiled.
Synthetics
Suitable for washing moderately soiled garments made of synthetic
bres (e.g. polyester, polyacrylic, viscose, etc.) or mixed synthetic-cotton
bres.
Mixed
A 40°C cycle for washing cotton and synthetic garments together.
Suitable for lightly soiled underwear.
Eco 40-60
For washing normally soiled cotton garments declared to be washable at
40 °C or 60 °C, together in the same cycle. This is the standard cotton
programme and the most ecient in terms of water and energy
consumption.
White Cotton
For heavily soiled whites and resistant colours.
Sport
A cycle designed for washing lightly soiled sports clothing (tracksuits,
shorts, etc.); for best results, we recommend not exceeding the
maximum load indicated in the “Wash Cycle Table”. We recommend
using liquid detergent and adding the amount suitable for a half-load.
20 °C
For washing lightly soiled cotton garments, at a temperature of 20 °C.
Wool - Woolmark Apparel Care - Blue:
The “Wool” wash cycle is approved by the Woolmark Company for
washing wool garments classied as “hand-washable”, provided that the
wash complies with the instructions appearing on the garment’s label
and with those provided by the manufacturer of this
washing machine (M1318).
Anti odour
Use this cycle (for synthetic fabrics) to wash garments
with bad odours (e.g. smoke, sweat, fried food). The cycle
is designed to remove bad odours while preserving the fabric bres.
Rinse + Spin
Designed for rinsing and spinning.
Spin + Drain
Designed to spin and drain the water.
Eco Cotton
For washing normally soiled cotton garments. At 40°C and 60°C.
WASH CYCLE PHASE INDICATOR LIGHTS
Once the desired wash cycle has been selected and has begun, the
indicator lights switch on one-by-one to indicate which phase of the
cycle is currently in progress.
Wash
Rinse
Spin
Drain
End of Wash Cycle
DOOR LOCKED INDICATOR
When lit, the symbol indicates that the door is locked. To prevent any
damage, wait until the symbol turns o before opening the door.
To open the door while a cycle is in progress, press the START/PAUSE
button; if the indicator light is o, the door can be opened.
FIRSTTIME USE
Once the appliance has been installed, and before it is used for the rst
time, run a wash cycle with detergent and no laundry, by setting the
“Auto-Clean” cycle.
DAILY USE
Prepare the laundry by following the suggestions appearing under the
“TIPS AND SUGGESTIONS” section.
Rapid programming
- Open the door. Load the laundry while making sure not to exceed the
maximum load quantity indicated in the cycle table.
- Pull out the detergent dispenser drawer and pour the detergent into
the relevant compartments as described in “DETERGENT DISPENSER
DRAWER section”.
- Close the door.
- Press the PUSH & GO button to start the wash cycle.
Traditional programming
- Turn the washing machine on by pressing the ON/OFF button. All the
indicator lights will light up for a few seconds, then only the lights
corresponding to the settings for the selected wash cycle will remain lit;
the START/PAUSE indicator light will also ash.
- Open the door. Load the laundry while making sure not to exceed the
maximum load quantity indicated in the Wash Cycle Table.
- Pull out the detergent dispenser drawer and pour the detergent into the relevant
compartments as described in “DETERGENT DISPENSER DRAWER” section.
- Close the door.
- Set the WASH CYCLE knob to the desired cycle.
- Modify the temperature and/or spin: pressing the button allows for
gradually reducing the temperature down to the cold wash level (20°C).
The spin speed may be progressively reduced by pressing the button,
until it is completely excluded (the “ ” setting. If these buttons are
pressed again, the maximum values are restored.
- Select the desired wash cycle.
- Select the desired options.
- Press the START/PAUSE button to start the wash cycle; the relative
indicator light will light up steady green and the door will lock (
indicator light on).
PAUSING A CYCLE
To pause the wash cycle, press the START/PAUSE button again; the
indicator light will ash . If the indicator light is not lit, the door may be
opened. To start the wash cycle from the point at which it was
interrupted, press the START/PAUSE button again.
OPENING THE DOOR, IF NECESSARY
Once a cycle starts, the indicator light turns on to signal that the door
cannot be opened. While a wash cycle is running, the door remains locked.
To open the door while a cycle is under way, for example, to add or remove
garments, press the START/PAUSE button to pause the cycle; the
indicator light will ash . If the indicator light is not lit, the door may be
opened. Press the START/PAUSE button again to continue the cycle.
CHANGING A RUNNING WASH CYCLE
To change a wash cycle while it is in progress, pause the washing machine
using the START/PAUSE button (the relative indicator light will ash ),
then select the desired cycle and press the START/PAUSE button again.
! To cancel a cycle that has already begun, press and hold the ON/OFF button.
The cycle will be stopped and the machine will switch o.
END OF THE CYCLE
Once the cycle terminates the indicator light will light up; when the
indicator light switches o, the door may be opened. Open the door,
unload the laundry and switch o the machine. If you do not press “ON/
OFF” button, the washing machine will switch o automatically after
about a 10 minutes. Close the water tap, open the door and unload the
washing machine. Leave the door ajar to allow the drum to dry.
FUNCTIONS
- If the selected option is not compatible with the set wash cycle, the
indicator light will ash and the option will not be activated.
- If the selected option is not compatible with another previously
selected option, the indicator light will ash accompanied by a buzzer,
and only the latter option will be activated; the indicator light
corresponding to the activated option will turn on.
Stain removal
This option allows for selecting the type of dirt so as to optimally adjust
the cycle for removing the stains. The following types of dirt can be
selected:
- Food: for stains caused by foodstus and beverages, for example.
- Work: for grease and ink stains, for example.
- Outdoor: for mud and grass stains, for example.
! The wash cycle duration varies according to the type of selected dirt.
Extra rinse
By selecting this option, the eciency of the rinse is increased and
optimal detergent removal is guaranteed. It is particularly useful for
sensitive skin.
Easy iron
By selecting this function, the wash and spin cycles will be modied in
order to limit the formation of creases. At the end of the cycle the
washing machine’s drum will rotate slowly; the EASY IRON and START/
PAUSE indicator lights will ash and the phase will remain lit
steady. To end the cycle, press the START/PAUSE button or the EASY
IRON button.
Delay start
To set a delayed start for the selected cycle, press the corresponding
button repeatedly until the desired delay period has been reached
(3h-6h-9h). When the button is pressed for the fourth time, the option
will deactivate.
Once the START/PAUSE button has been pressed, the delay time can
only be modied by decreasing it until the set cycle is launched.
Temperature
Each wash cycle has a pre-dened temperature. To modify the
temperature, press the button.
Spin
Each wash cycle has a pre-dened spin speed. To modify the spin speed,
Loading...