INCRA X-Y Marker User Manual

to insure perfect accuracy.
on the T-Bar before retightening
firmly against the indexing lip
place the end of the Marker
the thumbscrews, be sure to
assembled. If you ever loosen
Your X-Y Marker comes fully

Adjusting the T-Bar:

metal scribe in any one of the holes.
by twisting a .5mm pencil or sharp
any square corner, then make your mark
on your workpiece against two edges of
For marking: Place the X-Y Marker

© 2010 Taylor Design Group, Inc.

INCRA is a Registered Trademark of Taylor Design Group, Inc.

Taylor Design Group, P.O. BOX 810262, Dallas, TX 75381

Manufactured by:

Stainless Steel

through the hole with a hammer.
rule by pounding the point
DO NOT damage your precision
plastic, brass or aluminum.
materials such as wood, paper,
a precisely located “dimple” in soft
Use finger pressure ONLY to mark
through the holes can be used.
center punch sharp enough to fit
Center Punch: Any scribe or
To mark with a Metal Scribe or
fine point ready for marking.
one of the holes to give it an ultra
twist the lead once or twice in any
First, sharpen the pencil, then
To mark with a Wooden Pencil:
pencil in a hold to mark a dot.
pencil vertically and twist the

Mechanical Pencil: Just hold the
To mark with a 0.5mm

A NEW Concept in Precision Steel Rules

Measures from two perpendicular
edges in one operation

Locate drill centers fast and easy

Great for positioning cabinet door
knobs and handles

One or both T-Bars can be removed for
single edge referencing or flat work

When accuracy counts … INCRA RULES !

6” x 3” Precision

X-Y Marker

Put YOUR Mark on Precision

Micro-fine
guide holes
locate your
mark exactly
on target.

www.incra.com