INCRA Router Table Stands Addendum User Manual

w w w. in c ra .c o m

Side Winder Side Crank Installation on INCRA
Router Table Stands

Note: This addendum replaces Fig/Step 10 & Fig/Step 11 of the Woodpecker provided mounting instructions.
Please follow all assembly instructions of the original manual up to Fig/Step 10 before using this addendum.

If your INCRA router table stand is already assembled you will first need to remove the table top and remove the
front top stretcher. Remove the lower 1/4-20 x 1/2” hex bolt from the left end of the stretcher, Fig. 1. Loosely
attach the Side Winder Crank’s side panel to the stretcher using the provided 1/4-20 x 7/8” hex bolt, washer
and square nut. Place another 1/4-20 x 7/8” hex bolt with washer
through the lower hole on the Crank’s side panel and add the large
gold washer to the fastener before loosely threading on the square
nut, Fig. 2.

Re-assemble the stretcher to the stand sliding all 3 of the square
nuts on the left end of the stretcher into the t-slot in the leg.
Make sure the Crank’s
side panel is parallel

Fig.2

to the leg before
tightening all of the
mounting bolts,
Fig. 3.

Fig.1

Remove front

stretcher and remove

lower hex bolt from

left end

®

Using the remaining
hole in the side
panel as a guide,
drill a 9/32” hole
through the front
stretcher, Fig. 4.

Large washer

Square

nuts

1/4-20x7/8

hex bolt with

washers

this bolt only

Place a flat washer
on the remaining 1/4-20 x 7/8” hex bolt and insert through the
hole on the side panel. Add a split lockwasher and a square nut
then tighten the assembly in place, Fig. 5.

Continue with Fig/Step 12 in the Side Winder Owner’s Manual.

Fig.4 Fig.5

Drill 9/32”

hole through

stretcher

Fig.3

Re-assemble Stretcher to Stand

Square nuts

captured in

T-Slot on Leg

1/4-20x7/8

hex bolt with

washer.

Secure with

lockwasher

and

square nut

Manufactured by:

Taylor Design Group, Inc.

P.O. BOX 8102 62 Dallas, TX 753 81
www.in c ra .co m

INCRA is a Registered Trademark of Taylor Design Group

©2009 Taylor Design Group, Inc.

INCR A Tools are pro tect ed by one o r more o f the f ollowing U S pate nts:
#4, 793, 604, #4 ,93 0,2 21, #5 ,195,73 0, #5 ,275,074 , #5, 423 ,360, # 5,716, 04 5, #6 ,23 7,457,
#6,5 57,601, #6,67 2,190. Other p aten ts gr ante d or pen ding. rev.11.03.10

MADE IN THE

USA