INCRA Marking Rule User Manual

Page 1
18" Precision Marking Rule
Put YOUR Mark on Precision
Any rule can just measure, but only INCRA guarantees YOUR mark of precision on everything you do!
To mark with a 0.5mm Mechanical Pencil: Just hold
the pencil vertically and draw a short line in one of the slots, or twist the pencil in a hole to mark a dot.
To mark with a Wooden Pencil: First, sharpen the pencil,
then twist the lead once or twice in any one of the holes to give it an ultra fine point ready for marking.
To mark with a Metal Scribe or Center Punch: Any scribe
or center punch sharp enough to fit through the holes can be used. Use finger pressure ONLY to mark a precisely located “dimple” in soft materials such as wood, paper, plastic, brass or aluminum.
DO NOT damage your preci­sion rule by pounding the point through the hole with a hammer.
Precision Marking Rule
Marking:
Place your sharp pencil point or scribe in the desired hole or slot, then make your mark.
Measuring:
Use the scale lines on the edges to make precision measurements.
When accuracy counts … INCRA RULES!
INCRA RULES are available in many other popular styles and lengths.
Manufactured by:
Taylor Design Group P.O. Box 810262 Dallas, Texas 75381
www.incra.com
INCRA is a Registered Trademark of Taylor Design Group, Inc. ©2013 Taylor Design Group, Inc.
Loading...