INCRA Bend Rule User Manual

12" Precision Bend Rule

INCRA RULES!

7 5 1 9 2 2 5 0 6 0 2 5

Put YOUR Mark on Precision

Any rule can just
measure, but only
INCRA guarantees
YOUR mark of
precision on
everything you do!

Easy and Accurate

To mark with a 0.5mm Mechanical
Pencil: Just hold the pencil vertically and

draw a short line in one of the slots, or
twist the pencil in a hole to mark a dot.

To mark with a Wooden Pencil: First,
sharpen the pencil, then twist the lead once
or twice in any one of the holes to give it an
ultra fine point ready for marking.

To mark with a Metal Scribe or Center
Punch: Any scribe or center punch sharp

enough to fit through the holes can be
used. Use finger pressure ONLY to mark a
precisely located “dimple” in soft materials
such as wood, paper, plastic, brass or alu­minum. DO NOT damage your precision
rule by pounding the point through the
hole with a hammer.

Precision Bend Rule

Marking:

Place your mark in the hole or slot at the
desired measurement.

Measuring:

Place the scale as shown for easy viewing
and precise measurements.

Using the vertical scale:

Use the holes in the vertical scale to draw
your mark parallel to the edge.

When accuracy counts …

INCRA RULES are available in many other
popular styles and lengths.

Manufactured by:
Taylor Design Group
P.O. Box 810262
Dallas, Texas 75381

www.incra.com

INCRA is a Registered
Trademark of Taylor
Design Group, Inc.

©2013 Taylor Design Group, Inc.