Incon TS-LLD 1 Replacement Parts Manual

INTELLIGENT CONTROLS INC http://www.intelcon.com
74 INDUSTRIAL PARK RD SACO ME 04072 U S A

Replacement Parts Instructions 0000231A.DOC

Changing the TS-LLD 1 microfarad Line Filter Capacitor

Parts Required:

1. TS-LLD Installation Manual

Install the 1uF Line Filter
Capacitor (INCON PN LSSP-LF)
Between L1 & L2

(INCON P/N 000-1359)

2.

Line Filter Cap (LSSP-LF)

Tools Required:

N L1 L2

1. Flat-bladed & Philips head
screwdrivers (assorted sizes)

2.

Multimeter with test probes (set to read voltage at 120 VAC)

DANGER Electrical shock hazards!
Turn off and lock-out the submersible
pump power source (terminated at
L1 and L2), and the pump relay power
source (terminated at S2, from the
dispenser switch) BEFORE working
on this equipment. Failure to turn off
these power sources will result in
severe injury or death.

Old Line Filter – Removal Steps:

1.

DANGER 240 V AC is present ! …disconnect electrical power as described

in the TS-LLD CU Installation & Wiring and in the Safety Chapter of that manual.

2.

Open / remove the submersible pump relay box cover.

3.

Use the multimeter to make sure NO VOLTAGE IS PRESENT from N to any

other terminal inside the relay box.

4.

Remove the old Line Filter Capacitor (INCON P/N 020-0028).

New Line Filter – Installation:

Follow the Safety Instructions, the installation steps for the new CU enclosure

to install the new line filter capacitor, and the After Installation Steps /
Testing (as detailed in the TS-LLD Installation Manual).

Discard the old Line Filter Capacitor

Contact INCON Technical Service Department for any additional help. Call toll free
at 1-800-984-6266.

—

E-mail: [e-mail] FAX [phone] TEL [phone] PAGE 1 of 1

[e-mail] FAX [phone] TEL [phone]

❖

—