Inbike 528 Instruction Manual

INBIKE 528 Bike Computer Instruction

Fuctions



SPD

Speed



ODO Total cycling distance



DST

One-pass cycling distance



MXSMaximum speed



AVSAverage speed



TMOne-pass cycling time



CLK

Clock



SCANAutomatic Cycleplay



BACKLIGHT



SW Stop-watch



CDDCount-down distance



CDTCount-down time



CALConsumed calorie



FATConsumed fat



TEMTemperture



Alter For power shortage

Power saving



‘+’& ‘-‘ Speed comparing



Upkeep reminding



KM/hr M/hr setting



Wheel perimeter setting



Total distance initial value setting



Cycling date sampling



Automotive wake-up

 Installation of Battery

Open the battery lid with a coin. Put in a 3V CR2032 Battery. ( Positive pole upwards)

 Installation of inductor & Magnet

Install the Inductor on the front fork ( Same side as the magnet),Fix the inductor with the

complimentary armor tape, twine the wire on the handlebar.(Fix with armor

tape) ,Adjust the position between the magnet and inductor, make the distance around

1.5mm.(The closer ,the Better) .When fix the magnet, never let the magnet towards the

centre of inductor, make the magnet towards to the upside or downside of the inductor.

 Installation of the computer base

Fix with the armor tape



Installation of the computer

Press the computer into the base, Rotate clockwise.

 Wheel perimeter setting

1. Record the size marked on the wheel , find out the perimeter by referring to the

follow chart

2. Draw a spot on the wheel, then push the bike, The distance is the wheel perimeter when

the spot runs a circle.

Press the right button to change the number, Press left button to confirm and set the next
parameter.

The wheel perimeter must be accurate.

 Km/hr / M/hr selection

After setting the perimeter of wheel. Press left button to
select speed unit. Press right button to alter Km/hr or M/hr

 Weight setting

Acquiescent weight unit is K(kg), Press right button to switch
KG(kilogram) or L (pound), press left button to confirm. Press
left button to adjust the weight number. Press left button to
enter the upkeep remind setting page.

 Upkeep remind setting

Acquiescent remind number is 200(Km/M) , You could adjust
the number by pressing right button. When the total cycling
distance reaches, The wrench symbol will flicker. press the
right button 3 seconds to remove the recorded number.

All initial setting have completed till this step, Your cycling
date will be recorded

 Function switching

Press right button to switch the mode.

ODO – DST – MEX – AVS – TM – SW – CDD – CDT – CAL – FAT – TEM – SCAN - CLOCK