Impulse rBOX610 User Manual

rBOX610

Robust Din-rail Fanless Embedded System with RISC-based (iMX-287) Processor 4 COM, 2 CAN Bus and DIO

NEW

Wireless (3G/GPRS)

4 COM

Front view

LED indicators (power, alarm, ready/active, COM, wireless)

RISC-based Module (iMX-287) Processor

Features

Fanless design

●

RISC-based module (iMX-287) processor

●

128MB DDR2 SDRAM onboard

●

1 eMMC 4 GB onboard

●

1 SDHC socket for storage expansion (easy to access)

●

4 COM ports

●

2 CAN bus

●

RTC battery function

●

LED indicators

●

SNMP V1/V2c

●

Wide range DC power input (12 - 48V) with terminal block

●

Ready-to-run embedded Linux operating system

●

Wide temperature operation of -40°C ~ +70°C

●

Console port

2 CANBus

Power DC-In

SDHC slot SIM sot

DIO (4-In/4-Out)

Isolation

Extended

Temperature

Fanless Low PowerEN60950-1 IP40 UL508

Introduction

rBOX610 cost-effective din-rail fanless embedded system utilizes the low power RISC-based module (iMX-287) processor and is designed to withstand temperatures ranging from -40°C to +70°C for using in extreme operating environment and industrial automation applications.

rBOX610 features 4 RS-232/422/485 serial ports, dual LANs, 4 digital input channels, 4 digital output channels, 2 CAN bus and 1 eMMC onboard 4 GB & 1 x SDHC socket for storage expansion (easy to access) in a compact, IP40 protected, industrial-strength robust case. Two power paths input minimize the risk of data loss in the event of a single power failure. Its vertical din-rail form factor makes it easy to install the system in a small cabinet. Due to the RISC-based architecture, rBOX610 will not generate a lot of heat while being operated. The ready-to-run rBOX610 is specially designed for remote control/monitoring management applications like unmanned control room, industrial machine, automatic parking lot, traffic cabinet and more.

Hardware Specifications

Standard Color Sliver-Black Construction Extruded aluminum and heavy-duty steel, IP40 CPU iMX-287, ARM9 16-bit RISC CPU, 454 MHz System Board Q7M100 System Memory 1 x DDR2 128 MB SDRAM onboard System I/O Outlet

Serial Port 4 x RS-232/422/485 (COM 1 ~ 4)

COM 1~3 with TX/RX/RTS/CTS signals RS-232/422/485 interface select by software

LAN 2 x 10/100Mbps Ethernet

Magnetic isolation protection 1.5KV

321

Din-rail kit

Rear view

System I/O Outlet

* All specifications and photos are subject to change without notice.

USB 1 x USB 2.0

CAN 2 CAN 2.0 B (Phoenix connector, non-

DIO 1 x DIO (4-IN/4-OUT)

Console Port DB9 connector

RTC Battery onboard

Power Input 2 power paths with terminal block Alarm Contact One relay output with current

Easy-to-access interface

USB power distribution control by software

isolation) Meets ISO 11898 standard Software control termination resistor 120 ohm can high speed up to 1Mbit/s for transmit/receive

DI : Input channels : 4, source type Input voltage : 0 to 30VDCDigital input levels for dry contacts :

-Logic level 0: close to GND

-Logic level 1: open Digital input levels for wet contacts :

-Logic level 0: +10V to +24V (DI to COM-)

-Logic level 1: +3V max. DO : Output channels : 4, sink type Output current: Max. 200 mA per channel On-state voltage : 24VDC nominal, open collector to 30V Optical isolation protection 2 KV

For user setting with debug

Provides power for the internal real time clock & calendar Ideal for vibration environment & reduces maintenance efforts

0.5A@30VDC

Hardware Specifications Software Specifications

System I/O Outlet

Wireless 1 x Mini Card (supports USB interface on

3G/GPRS) 1 x SIM socket by outside access and is

easy plug/pull Watchdog Timer WDT 1: one step is 1 sec, 255 levels LEDs System Power, Alarm, Ready/Active, COM (TX,

RX), Wireless

Alarm DC PWR1 or PWR2 is lost

Storage 1 x eMMC 4 GB onboard (for boot disk)

Supports 1 x SDHC Card (easy-to-access, for store only.)

Installation Din-rail

Wall mount

Power Supply

2 power paths Power Input Range 12-48VDC Power Protection DC Version:

OVP (Over voltage protection)

UVP (Under voltage protection)

Reverse protection Operating Temperature -40°C ~ +70°C (-40°F ~ +158°F) Storage Temperature -45°C ~ +85°C (-49°F ~ +185°F) Humidity 5% ~ 95% Vibration Endurance 5G @ 10-150Hz, amplitude 0.35ms Weight (net/gross) TBD Dimensions 55 mm (2.16") (W) x 155 mm (6.10") (D) x 110 mm (4.33") (H) EOS Support Linux (Pre-installed) Certification FCC Part 18

Heavy Industrial CE

Ordering Information

Standard

rBOX610-FL Robust Din-rail fanless embedded system with Q7-RISC

Module (iMX-287), 4 COM, 2 CAN & DIO (-40°C ~ +70°C)

Optional

Wall mount kit Wireless (3G/GPS or WiFi) module for rBOX series

Dimensions

OS: Linux Host OS/ Development OS : Ubuntu 10.04 LTS

Toolchain/ Cross compiler : Freescale LTIB Kernel : 2.6.35.3 (with Freescale and Axiomtek hardware modified patch)

Support protocol types ICMP.

TCP/IP, UDP,DHCP,Telnet,SNMP,HTTP,HTTPS,SSL,SMTP,ARP, NTP,DNS,PPP,PPPOE,FTP.TFTP

Support software types Serial Server:

Support TCP Server/TCP Client/UDP/Pair/VC Support IP filter Support 32 TCP connections Support QOS

Modbus gateway: Support Modbus TCP/Modbus RTU/Modbus ASCII Support IP filter Support 32 connections Support TCP for multiple com port Support QOS

Setting configuration SNMP:

Support V1/V2C/V3 Support SNMP Private MIB Support read/write

http /https: Support SSL Support Import/export Support FW update

Remote Manager Remote Log

Email SNMP Support Trap

Serial Port Redirector for windown

XP/2003 32-64/Win7 32-64/Vista 32-64/2008 32-64 Real com(visual com) Centralized management Import/Export for real com

HW’s lib Wifi:

Support detecting signal strength Support setting AP connection Support setting web,wpa,wpa2 Support Search AP

DI/DO: Support Read-DI/write DO

CAN: Support Open/write /read/Close

3G: Support setting number connection Support User name/password Support detecting signal strength

GPS: Support detecting signal strength Support satellite positioning

Watch Dog Timer: Support setting enable Support setting clean Support setting timer

COM: Support setting RS-232/422/485

Default Reading: Support default reading for MAC, IP, Model

Overview

Embedded

Systems

Embedded

Systems for

Transportation

Embedded

Field

Controllers

Embedded

MicroBoxes

Industrial

Barebone

Systems

Industrial

Chassis

Backplanes

Power

Supplies

Peripherals &

Accessories

axiomtek.com

322