
PCM-9343
DM&P Vortex86DX-1.0 GHz 3.5" SBC, Ultra Low
Power, Onboard Memory, Dual LAN, PC/104
NEW
Specifications
CPU DM&P Vortex86DX 1.0 GHz, supports floating Point Unit (FPU)
Processor System
Memory
Display
Ethernet
WatchDog Timer
Storage
Rear I/O
Internal I/O
Expansion PC/104 slot PC/104 Expansion(8/16-Bit ISA)
Power
Environment
Physical Characteristics
Frequency 1.0 GHz
L2 Cache 256 KB
System Chipset DM&P Vortex86DX + SMI SM712
BIOS Award integrated 16 Mbit ROM in SOC
Technology DDR2 333 MHz SDRAM on board
Max. Capacity 512 MB
Onboard memory Onboard 256 MB or 512 MB
Chipset SMI SM712 2D graphics chip
VRAM 4 MB internal memory
Graphics Engine
LVDS Supports up to 1024 x 768 @ 24-bit LVDS LCD Panel
VGA Supports up to 1024 x 768 @ 85 Hz
TTL LCD Supports up to 1024 x 768 @ 24-bit TFT LCD Panel
Dual Display CRT + TTL, CRT + LVDS
Speed
Controller
Connector RJ-45 on LAN1, box header on LAN2
CompactFlash
SATA 1
SPI Flash Optional onboard 4MB SPI Flash Disk (Supported by request)
Serial 1 (COM1 supports RS-232)
Ethernet 1 (10/100 Mbps LAN1)
KB/Mouse 1
VGA 1
Reset Button 1
USB 4 x USB 2.0
Serial
Parallel(LPT) 1
GPIO 16-bit GPIO
I2C 1
Power Type AT
Power Supply Voltage Single +5V boot up, (+12V for LCD, ISA)
Power Consumption (Typical)
Power Consumption
(Max, test in HCT)
Battery Lithium 3 V / 210 mAH
Operational 0 ~ 60° C (32 ~ 140° F)
Non-Operational
Dimensions (L x W) 146 x 102 mm (5.7" x 4")
Weight 0.85 kg (1.87 lb), weight of total package
62.5 MHz single clock/cycle engine (EM+)
86 MHz single clock/cycle engine (EM4+)
Designed to accelerate DirectDraw
10/100 Mbps on LAN1
10/100 Mbps on LAN2
LAN1: 10/100 Mbps on DM&P Vortex86DX
LAN2: 10/100 Mbps on Realtek RTL8110SC
Internal: 2 sets,
32.768 kHz frequency source to count a 24-bit counter so the time range is from 30.5μ sec to 512 sec with resolution 30.5μ sec
Supports CompactFlash card TYPE I/II (Primary Master IDE Channel)
Supports 2 channels Ultra-DMA 100
3 COM (COM2, COM3, COM4)
COM2 supports RS-232/422/485
COM3/COM4 supports RS-232
PCM-9343L-S6A1E: 5V : 0.44A
PCM-9343F-S6A1E: 5V : 0.81A
PCM-9343FG-S6A1E: 5 V : 1.03A
PCM-9343L-S6A1E: 5V : 0.746 A
PCM-9343F-S6A1E: 5V : 1.09 A
PCM-9343FG-S6A1E: 5 V : 1.18 A
Operating: 0 ~ 60° C (32 ~ 140° F) (Operating humidity: 40° C @ 85% RH non-condensing)
Non-Operating: -40° C ~ 85° C and 60° C @ 95% RH non-condensing
Features
DM&P Vortex86DX, onboard DDR2 memory up to 512 MB
Display type: CRT, 24-bit LVDS, 24-bit TTL
Supports Floating Point Unit, total power consumption 4 ~ 6 Watts
Dual Lan: 10/100 LAN1 and 10/100 LAN2, supports PC/104 (8-bit/16-bit ISA)
expansion
Supports embedded software APIs and utilities, OS: DOS, WinCE, WinXPE
and Linux
Software APIs:
Backlight On/Off
GPIOBrightnessI2C
Embedded
Security ID
Utilities:
Watchdog
BIOS flash
eSOS
Flash Lock
3.5" Single Board Computers
All product specifications are subject to change without notice Last updated : 05-Aug-2010

Board Diagram
ISA Bus
10/100 LAN Connector x 1
MAC+PHY
USB 2.0
Connector x 4
4 port USB 2.0
PCI Bus
LPT
Connector x 1
COM
(COM2: RS232/422/485)
(COM1/3/4: RS-232)
Connector x 4
16Mbit
SPI BIOS
PS2 KB/MS
Connector x 1
RTL8110SCL
Ethernet
10/100 LAN
Connector x 1
24-bit LVDS
Connector x 1
4 MB
SPI EEROM
(Optional)
256MB/512MB
DDR2 on board
SATA
PC/104
VGA
Connector x 1
24-bit TTL
Connector x 1
NS DS90C385A
CRT
TTL
CF
ACARD
IDE to SATA
16-bit GPIO
DM&P Vortex86DX
SMI 712
PCM-9343
Ordering Information
Part No.
PCM-9343L-S6A1E 256 MB - - - 1 - Yes 1 1 1 2 1 - PC/104 - Yes Passive 0 ~ 60° C
PCM-9343F-S6A1E 256 MB 24-bit 24-bit Yes 1 - Yes 1 1 3 4 1 1 PC/104 - Yes Passive 0 ~ 60° C
PCM-9343FG-S6A1E 512 MB 24-bit 24-bit Yes 1 1 Yes 1 1 3 4 1 1 PC/104 - Yes Passive 0 ~ 60° C
PCM-9343FGZ-S6A1E 512 MB 24-bit 24-bit Yes 1 1 Yes 1 1 3 4 1 1 PC/104 - Yes Passive -20 ~ 80° C
Onboard
Memory
TTL LVDS CRT
Packing List
Part No. Description Quantity
1700008894 SATA 7P 30 cm cable x 1
1700060202 PS2 6P x 2 20 cm cable x 1
1700100250 COM3/4 IDE D-SUB 25 cm cable x 2
1701140201 COM2 IDE D-SUB 20 cm cable x 1
1700260250 LPT IDE 26P D-SUB 25 cm cable x 1
1703100121 USB 2 x 5P-2.0 12 cm W/BKT cable x 1
1700002142 LAN IDE 2.0 15 cm cable x 1
PCM-9343 SBC
Startup Manual
Utility CD
10/100
10/100
LAN1
LAN2
Buzzer LPT
RS-232/
422/485
Online Download
RS-232
USB
CF SATA Expansion
2.0
ATX
Power
AT
Power
Thermal
Solution
Operational
Temp.
Optional Accessories
Part No. Description
1703150102 SATA 10 cm Power cable
Embedded OS/API
Embedded OS/API Part No. Description
WinCE 5.0 2070009764 CE 5.0 Pro PCM-9343 V1.3 ENG
WinCE 6.0 2070009537 Image CE 6.0 Pro PCM-9343 V1.3 ENG
Win XPE 20070009528 Image XPE for PCM-9343
Software API 2056343000
www.advantech.com/products
SUSI 3.0 SW API for PCM-9343
B:20100122 XP

Value-Added Software Services
Software API: An interface that defines the ways by which an application program may request services from libraries and/or operating systems. Provides not only the underlying
drivers required but also a rich set of user-friendly, intelligent and integrated interfaces, which speeds development, enhances security and offers add-on value for Advantech platforms.
It plays the role of catalyst between developer and solution, and makes Advantech embedded platforms easier and simpler to adopt and operate with customer applications.
Software APIs
Control Monitor
General Purpose Input/Output is a flexible parallel interface
that allows a variety of custom connections. It allows users
to monitor the level of signal input or set the output status to
switch on/off a device. Our API also provides Programmable
GPIO
SMBus
I2C
GPIO, which allows developers to dynamically set the GPIO
input or output status.
SMBus is the System Management Bus defined by Intel®
Corporation in 1995. It is used in personal computers and
servers for low-speed system management communications.
The SMBus API allows a developer to interface a embedded
system environment and transfer serial messages using the
SMBus protocols, allowing multiple simultaneous device
control.
I2C is a bi-directional two wire bus that was developed by
Philips for use in their televisions in the 1980s.
The I2C API allows a developer to interface with an embedded
system environment and transfer serial messages using the I2C
protocols, allowing multiple simultaneous device control.
Watchdog
Hardware
Monitor
Hardware
Control
Display Power Saving
The Brightness Control API allows a developer to interface with
an embedded device to easily control brightness.
Brightness
Control
CPU Speed
A watchdog timer (WDT) is a device that performs a specific
operation after a certain period of time if something goes wrong
and the system does not recover on its own.
A watchdog timer can be programmed to perform a warm boot
(restarting the system) after a certain number of seconds.
The Hardware Monitor (HWM) API is a system health
supervision API that inspects certain condition indexes, such as
fan speed, temperature and voltage.
The Hardware Control API allows developers to set the PWM
(Pulse Width Modulation) value to adjust fan speed or other
devices; it can also be used to adjust the LCD brightness.
Make use of Intel SpeedStep technology to reduce power power
consumption. The system will automatically adjust the CPU
Speed depending on system loading.
Refers to a series of methods for reducing power consumption in
computers by lowering the clock frequency. These APIs allow the
user to lower the clock from 87.5% to 12.5%.
Backlight
The Backlight API allows a developer to control the backlight
(screen) on/off in an embedded device.
System
Throttling
Software Utilities
The BIOS Flash utility allows customers to update the flash
ROM BIOS version, or use it to back up current BIOS by
copying it from the flash chip to a file on customers’ disk. The
BIOS Flash utility also provides a command line version and
BIOS Flash
Embedded
Security ID
Monitoring
API for fast implementation into customized applications.
The embedded application is the most important property of
a system integrator. It contains valuable intellectual property,
design knowledge and innovation, but it is easily copied! The
Embedded Security ID utility provides reliable security functions
for customers to secure their application data within embedded
BIOS.
The Monitoring utility allows the customer to monitor system
health, including voltage, CPU and system temperature and fan
speed. These items are important to a device; if critical errors
happen and are not solved immediately, permanent damage may
be caused.
eSOS
Flash Lock
3.5" Single Board Computers
All product specifications are subject to change without notice Last updated : 05-Aug-2010
The eSOS is a small OS stored in BIOS ROM. It will boot up in
case of a main OS crash. It will diagnose the hardware status,
and then send an e-mail to a designated administrator. The
eSOS also provides remote connection: Telnet server and FTP
server, allowing the administrator to rescue the system.
Flash Lock is a mechanism that binds the board and CF card
(SQFlash) together. The user can “Lock” SQFlash via the Flash
Lock function and “Unlock” it via BIOS while booting. A locked
SQFlash cannot be read by any card reader or boot from other
platforms without a BIOS with the “Unlock” feature.