Impulse PCM-4153 User Manual

AMD LX800 PC/104-Plus SBC, Onboard Memory/ Flash, CRT, TTL, Extended Temp. -40 ~ 85° C
Battery Pin
Clear CMOS
Fast Ethernet 2
Fast Ethernet 1
USB
USB
IDE
Line-out
Power connector
RS422/485Line-in/MICKB/MS
Inverter connector LCD connector Standby power
connector
4 COM ports
LPT connector
Specifications
CPU AMD Geode™ LX800, 500 MHz
Processor System
Memory
Display
Ethernet
Audio Chipset Realtek ALC203
Watchdog Timer
Storage
Internal I/O
Expansion PC/104-Plus slot 1
Power
Environment
Physical Characteristics
Frequency 500 MHz L2 Cache 128 KB System Chipset AMD Geode LX800, with AMD CS5536 BIOS Award 4-Mbit Technology DDR 333 MHz Max. Capacity 512 MB Onboard memory 512 MB Chipset AMD Geode LX800 VRAM Optimized Shared Memory Architecture up to 64 MB system memory
CRT
TTL LCD Supports up to 1600 x 1200 x 32 bpp at 60 Hz for 24-bit single channel TFT Dual Display CRT+TTL Speed 10/100 Mbps
Controller
Connector Box Header
PATA 1 Channel Onboard Flash 1 GB (up to 4 GB) USB 4 x USB 2.0
Serial
Parallel (LPT) 1, IEEE 1284, EPP, and ECP compatible SMBus 1 Keyboard/Mouse 1 GPIO 8-bit general purpose input/output
Power Type AT Power Supply Voltage 5V ± 5% only to boot up (12 V is optional for LCD inverter and add on card) Power Consumption (Typical) 1.35A @ +5V, 0.1 A @ +12V Power Consumption (Max, test in HCT) Power Management ACPI/APM1.2 Operational 0 ~ 60° C (32 ~ 140° F) (Operational humidity: 40° C @ 85% RH non-condensing) Non-Operational -40° C ~ 85° C and 60° C @ 95% RH non-condensing Dimensions (L x W) 96 x 115 mm (3.8" x 4.5") Weight 0.162 kg (0.357 lb) (with heat-sink) Height Top Side: 11.45 mm; Bottom Side: 10.6 mm
Supports up to 1920 x 1440 x 32 bpp at 85 Hz Supports up to 1600 x 1200 x 32 bpp at 100 Hz
Fast Ethernet1: Intel 82551ER Fast Ethernet2: Intel 82551ER
Output System Reset Programmable counter from 1 ~ 255 minutes/ seconds
3 RS-232 from COM1/3/4, 1 RS-232/422/485 from COM2 (ESD protection for RS-232: Air gap ±15kV, Contact ±8kV)
1.51A @ +5V, 0.1 A @ +12V
Features
 AMD low power LX800 500 MHz processor
 Supports extended temperature range -40 ~ 85° C
 PC/104-plus expansion
 Onboard 1 GB Flash and onboard DDR 333MHz 512 MB memory
 Supports embedded software APIs and utilities
Software APIs:
Utilities:
BIOS flash
Watchdog GPIOH/W Monitor BrightnessSMBus
Monitoring
Backlight On/Off
PC/104 CPU Modules
All product specifications are subject to change without notice Last updated : 9-May-2011
PCM-4153
Board Diagram
PC/104
expansion
Onboard 1GB flash
8-bit GPIO
LCD
PCI to ISA Bridge
PCI-104
expansion
PATA
GPIO
CMOS
18/24 Bit TTL
Master
IDE / DMA33
Slave
SMBus
BIOS
3 RS-232
1 RS-232/422/485
Watchdog
LPC Bus
AMD Geode
LX800
PCI BUS
AMD Geode
CS5536
Super I/O SCH3114
Analog RGB
DDR400
USB 2.0
AC-Link
PS/2 KB/MS
LPT
CRT
DDR SDRAM
On-board 512MB
Fast Ethernet 1
Intel 82551ER
Fast Ethernet 2
Intel 82551ER
USB 2.0 x 4 port
ALC203
Ordering Information
Part No. CPU
PCM-4153F-L0A2E
PCM-4153FZ-L0A2E
PCM-4153FZ2-L0A2E
AMD LX800
AMD LX800
AMD LX800
Onboard Memory
512 MB Yes 18/24 bit 2 4 3 1 Yes Ye s 1 GB Yes PC/104+ Passive 0 ~ 60° C
512 MB Yes 18/24 bit 2 4 3 1 Yes Ye s 1 GB Yes PC/104+ Passive -20 ~ 80° C
512 MB Yes 18/24 bit 2 4 3 1 Yes Ye s 1 GB Yes PC/104+ Passive -40 ~ 85° C
CRT TTL
Fast Ethernet
USB2.0 RS-232
Packing List
Part No. Description Quantity
1700000898 VGA cable D-SUB 15P(F)/12P-1.25 mm 15 cm 1 1700000918 Audio cable 10 cm 1700003491 AT power cable 1 x 8P-2.0/B4P-5.08 x 2 15 cm 1 1700060202 Cable 6P-6P-6P PS/2 KB & Mouse 20 cm 1 1700260250 LPT Port cable 25P to 26P 2.0 mm 25 cm 1 1701100202 LAN Flat Cable IDC10P 2.0 mm/RJ-45 20 cm 1 1701400181 COM 4 ports Flat Cable 18 cm IDC40P 2.0 mm 1 1701440350 IDE cable 44P/44P/44P 35 cm 1 1703040157 RS-422/485 W/D-SUB COM 4P 15 cm 1
1703060053
1703100121 USB 2-port cable 10P 12 cm IDC 2.0 mm 1 9660104000 PC/104 screw and copper post package 1
1960005764
PCM-4153 SBC Startup Manual Utility CD
PS2 Cable 6P (MINI-DIN)-6P (Wafer 2.0 mm) 6 cm
Heatsink for PCM-4153 (80.44 x 77.97 x 7.82 mm)
1
1
RS-232/ 422/485
LPT KB/MS
Onboard Flash
Audio Expansion
Optional Accessories
Part No. Dexcription
1653130421 PCI-104 connector 120-pin (Long pin) 165313222B PC/104 connector 64-pin (Long pin) 165312022B PC/104 connector 40-pin (Long pin)
Embedded OS/API
Embedded OS/API Part No. Description
WinCE
Win XPE
QNX V6.3.2/ 6.4.1
Software API 205E000019
2070000729 Image GX3 CE 5.0 Pro Plus Eng 2070001612 CE 6.0 Pro GX3 4 Com V1.0 ENG 2070001576 XPE FP2007 GX3 (LX800) V3.0 ENG
2070003216
2070003557
XPE FP2007 GX3 Group V3.1 ENG (717.22 MB) XPE FP2007 GX3 Group V3.0 CHS (641.41 MB)
SUSI 3.0 SW API for ESBC B: 20091116 XP
Thermal Solution
Operating Temp.
Online Download
www.advantech.com/products
Value-Added Software Services
Software API: An interface that defines the ways by which an application program may request services from libraries and/or operating systems. Provides not only the underlying drivers required but also a rich set of user-friendly, intelligent and integrated interfaces, which speeds development, enhances security and offers add-on value for Advantech platforms. It plays the role of catalyst between developer and solution, and makes Advantech embedded platforms easier and simpler to adopt and operate with customer applications.
Software APIs
Control Monitor
General Purpose Input/Output is a flexible parallel interface that allows a variety of custom connections. It allows users to monitor the level of signal input or set the output status to switch on/off a device. Our API also provides Programmable
GPIO
SMBus
I2C
GPIO, which allows developers to dynamically set the GPIO input or output status.
SMBus is the System Management Bus defined by Intel® Corporation in 1995. It is used in personal computers and servers for low-speed system management communications. The SMBus API allows a developer to interface a embedded system environment and transfer serial messages using the SMBus protocols, allowing multiple simultaneous device control.
I2C is a bi-directional two wire bus that was developed by Philips for use in their televisions in the 1980s. The I2C API allows a developer to interface with an embedded system environment and transfer serial messages using the I2C protocols, allowing multiple simultaneous device control.
Watchdog
Hardware
Monitor
Hardware
Control
Display Power Saving
The Brightness Control API allows a developer to interface with an embedded device to easily control brightness.
Brightness
Control
CPU Speed
A watchdog timer (WDT) is a device that performs a specific operation after a certain period of time if something goes wrong and the system does not recover on its own. A watchdog timer can be programmed to perform a warm boot (restarting the system) after a certain number of seconds.
The Hardware Monitor (HWM) API is a system health supervision API that inspects certain condition indexes, such as fan speed, temperature and voltage.
The Hardware Control API allows developers to set the PWM (Pulse Width Modulation) value to adjust fan speed or other devices; it can also be used to adjust the LCD brightness.
Make use of Intel SpeedStep technology to reduce power power consumption. The system will automatically adjust the CPU Speed depending on system loading.
Refers to a series of methods for reducing power consumption in computers by lowering the clock frequency. These APIs allow the user to lower the clock from 87.5% to 12.5%.
Backlight
The Backlight API allows a developer to control the backlight (screen) on/off in an embedded device.
System
Throttling
Software Utilities
The BIOS Flash utility allows customers to update the flash ROM BIOS version, or use it to back up current BIOS by copying it from the flash chip to a file on customers’ disk. The BIOS Flash utility also provides a command line version and
BIOS Flash
Embedded Security ID
Monitoring
All product specifications are subject to change without notice Last updated : 9-May-2011
API for fast implementation into customized applications.
The embedded application is the most important property of a system integrator. It contains valuable intellectual property, design knowledge and innovation, but it is easily copied! The Embedded Security ID utility provides reliable security functions for customers to secure their application data within embedded BIOS.
The Monitoring utility allows the customer to monitor system health, including voltage, CPU and system temperature and fan speed. These items are important to a device; if critical errors happen and are not solved immediately, permanent damage may be caused.
eSOS
Flash Lock
The eSOS is a small OS stored in BIOS ROM. It will boot up in case of a main OS crash. It will diagnose the hardware status, and then send an e-mail to a designated administrator. The eSOS also provides remote connection: Telnet server and FTP server, allowing the administrator to rescue the system.
Flash Lock is a mechanism that binds the board and CF card (SQFlash) together. The user can “Lock” SQFlash via the Flash Lock function and “Unlock” it via BIOS while booting. A locked SQFlash cannot be read by any card reader or boot from other platforms without a BIOS with the “Unlock” feature.
Loading...