PCM-3353
AMD LX800/LX600 PC/104-Plus SBC, CRT,
LVDS, TTL, Ethernet, USB, COM, CFC
Clear CMOS
Fast Ethernet
Backlight power
LVDS LCD
USB 1/2
PATA
USB 3/4
KB/MS GPIO2 GPIO1 RS-422/485
Power in
Backlight power
TTL LCD
Parallel Port
RS-232 1/2/3/4
SMBus
Specifications
CPU AMD Geode™ LX800 500 MHz/AMD Geode™ LX600 366 MHz
Processor System
Memory
Display
Ethernet
Audio Chipset Realtek ALC203
Watchdog Timer
Storage
Internal I/O
Expansion PC/104-Plus slot 1
Power
Environment
Physical Characteristics
Frequency 500 MHz / 366 MHz
L2 Cache 128 KB
System Chipset AMD CS5536
BIOS Award 4-Mbit
Technology DDR 333/400 MHz
Max. Capacity 1 GB
Socket 1 x 200-pin SODIMM
Chipset AMD Geode LX800 / LX600
VRAM Optimized Shared Memory Architecture up to 64 MB system memory
LVDS Supports up to 1600 x 1200 x 32 bpp at 60 Hz 18/ 24-bit (JEIDA format) single channel LVDS Panel
CRT
TTL LCD Supports up to 1600 x 1200 x 32 bpp at 60 Hz for 24-bit single channel TFT Panel
Dual Display CRT+TTL, CRT+LVDS
Speed 10/100/1000 Mbps
Controller Intel 82541PI
Connector Box Header
CompactFlash Compact Flash socket (Type I)
PATA 1 Channel
USB 4 x USB 2.0
Serial
Parallel (LPT) 1, IEEE 1284, EPP, and ECP compatible
SMBus 1
Keyboard/Mouse 1
GPIO 8-bit general purpose input/output
Power Type AT
Power Supply Voltage 5V ± 5% only to boot up (12 V is optional for LCD inverter and add on card)
Power Consumption
(Typical)
Power Consumption
(Max, test in HCT)
Power Management APM1.2
Battery Lithium 3 V / 196 mAH
Operational 0 ~ 60° C (32 ~ 140° F) (Operational humidity: 40° C @ 85% RH non-condensing)
Non-Operational -40° C ~ 85° C and 60° C @ 95% RH non-condensing
Dimensions (L x W) 96 x 115 mm (3.8" x 4.5")
Weight 0.162 kg (0.357 lb) (with heat-sink)
Height Top Side: 11.45 mm; Bottom Side: 10.6 mm
Supports up to 1920 x 1440 x 32 bpp at 85 Hz
Supports up to 1600 x 1200 x 32 bpp at 100 Hz
Output System Reset
Programmable counter from 1 ~ 255 minutes/ seconds
3 RS-232 from COM1/3/4, 1 RS-232/422/485 from COM2 (ESD protection for RS-232: Air gap ±15kV,
Contact ±8kV)
LX800: 1.35 A @ +5 V, 0.1 A @ +12 V
LX800: 1.51 A @ +5 V, 0.1 A @ +12 V
Features
AMD low power LX800 500 MHz/LX600 366 MHz processor
24-bit TFT LCD interface, 18/ 24-bit (JEIDA format) LVDS display
PC/104-plus Expansion
Supports up to 4 COM ports, 4 USB ports
Supports Embedded Software API and Utility
Software APIs:
Utilities:
BIOS flash
Watchdog GPIOH/W MonitorSMBus
Monitoring
Backlight
On/Off
Brightness
PC/104 CPU Modules
All product specifications are subject to change without notice Last updated : 9-May-2011
Board Diagram
PCM-3353
PC/104
expansion
PCI to ISA Bridge
PATA
CompactFlash
8-bit
GPIO
LCD
Connector
24-bit LVDS
Transmitter
PCI-104
expansion
PCA9554
24 Bit TTL
SMBus
BIOS
3 RS-232
1 RS-232/422/485
Watchdog
AMD LX800/LX600
AMD Geode
LPC Bus
PCI BUS
CS5536
Super I/O
SCH3114
Analog RGB
DDR400
USB 2.0
AC-Link
PS/2 KB/MS
LPT
CRT connector
DDR SDRAM
SODIMM Socket
Intel 82541PI
USB 2.0 x 4 port
ALC203
Ordering Information
Part No. CPU Memory CRT LVDS TTL GbE USB 2.0 RS-232
RS-232/
422/485
LPT/FDD Audio Expansion
PCM-3353F-L0A2E AMD LX800 SODIMM Yes 18/24-bit 24-bit 1 4 3 1 Yes Yes PC/104+ Passive 0 ~ 60° C
PCM-3353F-J0A2E AMD LX600 SODIMM Yes 18/24-bit 24-bit 1 4 3 1 Yes Yes PC/104+ Passive 0 ~ 60° C
PCM-3353Z-512A2E AMD LX800
PCM-3353Z2-512A2E AMD LX800
512 MB
Bundle
512 MB
Bundle
Yes 18/24-bit 24-bit 1 4 3 1 Yes Yes PC/104+ Passive -20 ~ 80° C
Yes 18/24-bit 24-bit 1 4 3 1 Yes Yes PC/104+ Passive -40 ~ 85° C
Note: Wide temperature range version has been bundled with industrial grade memory module
Packing List
Part No. Description Quantity
PCM-3353 SBC
Startup Manual
Utility CD
1700000898 VGA cable D-SUB 15P(F)/12P-1.25 mm 15 cm 1
1700000918 Audio cable 10 cm 1
1700003491 AT power cable 1 x 8P-2.0/B4P-5.08 x 2 15 cm 1
1700060202 Cable 6P-6P-6P PS/2 KB & Mouse 20 cm 1
1700260250 LPT Port cable 25P to 26P 2.0 mm 25 cm 1
1701100202 LAN Flat Cable IDC10P 2.0 mm/RJ-45 20 cm 1
1701400181 COM 4 ports Flat Cable 18 cm IDC40P 2.0 mm 1
1701440350 IDE cable 44P/44P/44P 35CM 1
1703040157 RS-422/485 W/D-SUB COM 4P 15 cm 1
1703060053 PS2 Cable 6P (MINI-DIN)-6P (Wafer 2.0 mm) 6 cm 1
1703100121 USB 2Ports cable 10P 12 cm IDC 2.0 mm 1
9660104000 PC/104 screw and copper post package 1
1960005764 Heatsink for PCM-3353 (80.44 x 77.97 x 7.82 mm) 1
Optional Accessories
Part No. Description
1653130421 PCI-104 connector 120pin (Long pin)
165313222B PC/104 connector 64-pin (Long pin)
165312022B PC/104 connector 40-pin (Long pin)
1960037701N000 CF retainer for anti-vibration
Embedded OS/API
Embedded OS/API Part No. Description
WinCE
Win XPE
QNX V6.4.1/ 6.3.2
Linux Ubuntu V9.10
Software API 205E000019 SUSI 3.0 SW API for ESBC B: 20091116 XP
2070000729 Image PCM-3353 CE 5.0 Pro Plus Eng
2070001612 CE6.0 Pro GX3 4 COM V1.0 ENG
2070005769 CE6.0 Pro GX3 2 COM V1.1 JPN
2070009905 Image XPE WES2009 PCM-3353 A2 V4.0 ENG
2070009906 Image XPE WES2009 PCM-3353 A2 V4.0 24MUI
Thermal
Solution
Operational
Temp.
Online Download
www.advantech.com/products
Value-Added Software Services
Software API: An interface that defines the ways by which an application program may request services from libraries and/or operating systems. Provides not only the underlying
drivers required but also a rich set of user-friendly, intelligent and integrated interfaces, which speeds development, enhances security and offers add-on value for Advantech platforms.
It plays the role of catalyst between developer and solution, and makes Advantech embedded platforms easier and simpler to adopt and operate with customer applications.
Software APIs
Control Monitor
General Purpose Input/Output is a flexible parallel interface
that allows a variety of custom connections. It allows users
to monitor the level of signal input or set the output status to
switch on/off a device. Our API also provides Programmable
GPIO
SMBus
I2C
GPIO, which allows developers to dynamically set the GPIO
input or output status.
SMBus is the System Management Bus defined by Intel®
Corporation in 1995. It is used in personal computers and
servers for low-speed system management communications.
The SMBus API allows a developer to interface a embedded
system environment and transfer serial messages using the
SMBus protocols, allowing multiple simultaneous device
control.
I2C is a bi-directional two wire bus that was developed by
Philips for use in their televisions in the 1980s.
The I2C API allows a developer to interface with an embedded
system environment and transfer serial messages using the I2C
protocols, allowing multiple simultaneous device control.
Watchdog
Hardware
Monitor
Hardware
Control
Display Power Saving
The Brightness Control API allows a developer to interface with
an embedded device to easily control brightness.
Brightness
Control
CPU Speed
A watchdog timer (WDT) is a device that performs a specific
operation after a certain period of time if something goes wrong
and the system does not recover on its own.
A watchdog timer can be programmed to perform a warm boot
(restarting the system) after a certain number of seconds.
The Hardware Monitor (HWM) API is a system health
supervision API that inspects certain condition indexes, such as
fan speed, temperature and voltage.
The Hardware Control API allows developers to set the PWM
(Pulse Width Modulation) value to adjust fan speed or other
devices; it can also be used to adjust the LCD brightness.
Make use of Intel SpeedStep technology to reduce power power
consumption. The system will automatically adjust the CPU
Speed depending on system loading.
Refers to a series of methods for reducing power consumption in
computers by lowering the clock frequency. These APIs allow the
user to lower the clock from 87.5% to 12.5%.
Backlight
The Backlight API allows a developer to control the backlight
(screen) on/off in an embedded device.
System
Throttling
Software Utilities
The BIOS Flash utility allows customers to update the flash
ROM BIOS version, or use it to back up current BIOS by
copying it from the flash chip to a file on customers’ disk. The
BIOS Flash utility also provides a command line version and
BIOS Flash
Embedded
Security ID
Monitoring
All product specifications are subject to change without notice Last updated : 9-May-2011
API for fast implementation into customized applications.
The embedded application is the most important property of
a system integrator. It contains valuable intellectual property,
design knowledge and innovation, but it is easily copied! The
Embedded Security ID utility provides reliable security functions
for customers to secure their application data within embedded
BIOS.
The Monitoring utility allows the customer to monitor system
health, including voltage, CPU and system temperature and fan
speed. These items are important to a device; if critical errors
happen and are not solved immediately, permanent damage may
be caused.
eSOS
Flash Lock
The eSOS is a small OS stored in BIOS ROM. It will boot up in
case of a main OS crash. It will diagnose the hardware status,
and then send an e-mail to a designated administrator. The
eSOS also provides remote connection: Telnet server and FTP
server, allowing the administrator to rescue the system.
Flash Lock is a mechanism that binds the board and CF card
(SQFlash) together. The user can “Lock” SQFlash via the Flash
Lock function and “Unlock” it via BIOS while booting. A locked
SQFlash cannot be read by any card reader or boot from other
platforms without a BIOS with the “Unlock” feature.
Loading...