NOTE:
Please read all instructions
carefully before using this
product
Safety Notice
Hardware Identifier
Assembly Instruction
Parts List
Warranty
Ordering Parts
POWERHOUSE
Bi-Level Dumbbell Rack
DBR 90
Model
DBR 90
Retain This
Manual for
Reference
06-25-01
OWNER'S
MANUAL
14777 DON JULIAN RD., CITY OF INDUSTRY, CA 91746
IMPEX FITNESS PRODUCTS
Tel: (800) 999-8899 Fax: (626) 961-9966
www.impex -fitness.com
info@impex -fitness.com
TABLE OF CONTENTS
BEFORE YOU BEGIN...................................................................................... 1
IMPORTANT SAFETY NOTICES..................................................................... 2
HARDWARE IDENTIFIER.....…....................................................................... 3
ASSEMBLY INSTRUCTIONS........................................................................... 4
EXPLODED DIAGRAM.........................................................................………. 8
PARTS LIST...................................................................................................... 9
WARRANTY.................................................................................................…. 10
ORDERING PARTS.......................................................................................… 10
BEFORE YOU BEGIN
Thanks for selecting the POWERHOUSE Dumbbell Rack DBR90 by IMPEX
FITNESS PRODUCTS. For your safety and benefit, we committed to provide you
complete customer satisfaction. If you have any questions, or find there are missing
or damaged parts, we guarantee you complete satisfaction through direct
assistance fro our factory. To avoid unnecessary delays, please call our TOLLFREE customer service number. Our Service Agents will provide immediate
assistance to you.
Toll-Free Customer Service Number
1-800-999-8899
Mon. – Fri. 9 a.m. – 5 p.m. PST
www.impex-fitness.com
info@impex-fitness.com
1
IMPORTANT SAFETY NOTICE
PRECAUTIONS
This exercise machine is built for optimum safety. However, certain precautions apply whenever you
operate a piece of exercise equipment. Be sure to read the entire manual before you assemble or
operate your machine. In particular, note the following safety precautions:
1. Keep children and pets away from the machine at all times. DO NOT
leave children unattended in the same room with the machine.
2. Only one person at a time should use the machine.
3. If the user experiences dizziness, nausea, chest pain, or any other abnormal
symptoms, STOP the workout at once. CONSULT A PHYSICIAN
IMMEDIATELY.
4. Position the machine on a clear, leveled surface. DO NOT use the machine
near water or outdoors.
5. Keep hands away from all moving parts.
6. Always wear appropriate workout clothing when exercising. DO NOT wear
robes or other clothing that could become caught in the machine. Running
or aerobic shoes are also required when using the machine.
7. Use the machine only for its intended use as described in this manual. DO
NOT use attachments not recommended by the manufacturer.
8. Do not place any sharp object around the machine.
9. Disabled person should not use the machine without a qualified person or
physician in attendance.
10. Before using the machine to exercise, always do stretching exercises to
properly warm up.
11. Never operate the machine if the machine is not functioning properly.
WARNING: BEFORE BEGINNING ANY EXERCISE PROGRAM, CONSULT YOUR PHYSICIAN.
THIS IS ESPECIALLY IMPORTANT FOR INDIVIDUALS OVER THE AGE OF 35 OR PERSONS
WITH PRE-EXISTING HEALTH PROBLEMS. READ ALL INSTRUCTIONS BEFORE USING
ANY FITNESS EQUIPMENT. IMPEX INC. ASSUMES NO RESPONSIBILITY FOR PERSONAL
INJURY OR PROPERTY DAMAGE SUSTAINED BY OR THROUGH THE USE OF THIS
PRODUCT.
SAVE THESE INSTRUCTIONS.
2
3
ASSEMBLY INSTRUCTION
Tools Required to Assemble the Machine: Two Adjustable Wrenches
NOTE: It is strongly recommended this machine be assembled by two or more people to
avoid possible injury.
STEP 1 (See Diagram 1)
A.) Connect the Left Upright Beam (#3) to the Stabilizer (#1). Secure it with a Bracket (#7), four M10 x
3 ¼” Carriage Bolts (#10), ∅ ¾” Washers (#12), and M10 Aircraft Nuts (#13).
B.) Repeat the above procedure A to Connect the Right Upright Beam (#2) to the Stabilizer (#1).
DIAGRAM 1
4
STEP 2 (See Diagram 2)
A.) Connect the two Uprights with one Fix ed Rack (#4) on the top level. Align the holes then Secure
them with two M10 x 2 ¾” Carriage Bolts (#11), ∅ ¾” Washers (#12), and M10 Aircraft Nuts (#13) on
each end of the Rack. Do not tighten the nuts and bolts yet.
B.) Connect the two Uprights with one Adj ustable Rack (#5) on the top level. Align the Rack width by
positioning the smallest dumbbell on the rack. Secure the rack with one M10 x 2 ¾” Carriage Bolt
(#11), ∅ ¾” Washer (#12), and M10 Aircraft Nut (#13) on each end.
DIAGRAM 2
5
STEP 3 (See Diagram 3)
A.) Connect the two Uprights with one Fixed Rack (#4) on the lower level. Align the holes then Secure
them with two M10 x 2 ¾” Carriage Bolts (#11), ∅ ¾” Washers (#12), and M10 Aircraft Nuts (#13) on
each end of the Rack. Do not tighten the nuts and bolts yet.
B.) Connect the two Uprights with one Adjustable Rack (#5) on the lower level. Align the Rack width by
positioning the smallest dumbbell on the rack. Secure the rack with one M10 x 2 ¾” Carriage Bolt
(#11), ∅ ¾” Washer (#12), and M10 Aircraf t Nut (#13) on each end.
C.) Securely tighten all the nuts and bolts previously installed.
DIAGRAM 3
6
STEP 4 (See Diagram 4)
A.) Insert a Weight Plate Holders (#6) into the hole on the side of the Left Upright Beam. Secure it with
a M10 x ¾” Allen Bolt (#9) and ∅ ¾” Washer (#12).
B.) Slide an Olympic Sleeve (#16) onto the Holder. Attach a Spring Clip (#14) onto the Holder.
C.) Repeat the above two steps to install the other three Posts.
DIAGRAM 4
7
8
Parts list
KEY NO. DESCRIPTION Q’ty
1 Stabilizer 2
2 Right Upright Beam 1
3 Left Upright Beam 1
4 Fixed Rack 2
5 Adjustable Rack 2
6 Weight Plate Holder 4
7 Bracket 2
8 Square End Cap 8
9 M10 x ¾” Allen Bolt 4
10 M10 x 3 ¼” Carriage Bolt 8
11 M10 x 2 ¾” Carriage Bolt 12
12 ∅ ¾” Washer 24
13 M10 Aircraft Nut 20
14 Spring Clip 4
15 Cone-shaped End Cap 4
16 Olympic Sleeve 4
9
IMPEX INC.
LIMITED WARRANTY
IMPEX Inc. ("IMPEX") warrants this product to be free from defects in workmanship and material,
under normal use and service conditions, for a period of two years on the Frame from the date of
purchase. This warranty extends only to the original purchaser. IMPEX's obligation under this
Warranty is limited to replacing or repairing, at IMPEX's option.
All returns must be pre-authorized by IMPEX. Pre-authorization may be obtained by calling IMPEX
Customer Service Department at 1-800-999-8899. All freights on products returned to IMPEX must
be prepaid by the customer. This warranty does not extend to any product or damage to a product
caused by or attributable to freight damage, abuse, misuse, improper or abnormal usage or repairs
not provided by an IMPEX authorized service center or for products used for commercial or rental
purposes. No other warranty beyond that specifically set forth above is authorized by IMPEX.
IMPEX is not responsible or liable for indirect, special or consequential damages arising out of or in
connection with the use or performance of the product or other damages with respect to any
economic loss, loss of property, loss of revenues or profits, loss of enjoyments or use, costs of
removal, installation or other consequential damages or whatsoever natures. Some states do not
allow the exclusion or limitation of incidental or consequential damages. Accordingly, the above
limitation may not apply to you.
The warranty extended hereunder is in lieu of any and all other warranties and any implied
warranties of merchantability or fitness for a particular purpose is limited in its scope and duration to
the terms set forth herein. Some states do not allow limitations on how long an implied warranty
lasts. Accordingly, the above limitation may not apply to you.
This warranty gives you specific legal right. You may also have other rights which vary from state
to state. Register on-line at www.impex-fitness.com
IMPEX INC.
14777 Don Julian
City of Industry, CA 91746
ORDERING REPLACEMENT PARTS
Replacement parts can be ordered by calling our Customer Service Department toll-free at 1-800-
999-8899 during our regular business hours: Monday through Friday, 9 am until 5 pm Pacific
standard time.
info@impex-fitness.com
When ordering replacement parts, always give the following information.
1. Model
2. Description of Parts
3. Part Number
4. Date of Purchase
10
Loading...