Impco ITK-1 User Manual
ITK-1 Test Kit
User’s Manual
PPI-109-REV. B IMPCO Technologies Inc. April, 2008
3030 South Susan St. Page 1 of 12
Santa Ana, CA 92704
www.impcotechnologies.com
Figure #1
April, 2008 IMPCO Technologies Inc. PPI-109-REV. B
Page 2 of 12 3030 South Susan St.
Santa Ana, CA 92704
www.impcotechnologies.com
Chapter I
ITK-1 Test Kit Contents
The ITK-1 Test Kit contains all items listed in table #1. If your kit is missing any component, or has any
damaged items, please call your IMPCO distributor for instructions.
ITEM DESCRIPTION QTY USED
1 Bushing, Model J 1 B3-26
2 Fitting, 1/8” NPT / 3/16” HS Nip Brass 1 F4-4
3 Hose, 3/16” ID Vacuum, Bulk 8 feet H1-11
4 Test Kit Gauge, 0-5 PSI 1 TG-005
5 Test Kit Gauge, 0-10” WC 1 TG-010
6 Test Kit Gauge, 200 PSI 1 TG-0200
7 Fitting, ¼ UNF, ¼ HS Vac Nip 1 F4-2
8 Fitting, 1/8” NPT ¼” HS 90O El Nylon 1 F4-8
9 Gauge, Secondary Lever Height 1 G2-2
10 Case, Plastic 1 C9-25849-003
11 Test Plug 1 P3-51214-001
12
(Not Shown)
ITK-1 User’s Manual 1 PPI-109
Table #1
IMPCO PART
NUMBER
PPI-109-REV. B IMPCO Technologies Inc. April, 2008
3030 South Susan St. Page 3 of 12
Santa Ana, CA 92704
www.impcotechnologies.com
Chapter II
Tool Usage Instructions
A. High Pressure Gauge (TG-0200):
This pressure gauge is used for input fuel pressure readings. Connectivity depends entirely upon
your application. Do not connect the gauge where the delivery pressure will exceed 200 PSI.
B. Differential Pressure Test Gauges (TG-005 & TG-010):
• Both the TG-005 (0-5 PSI) and the TG-010 (0-10” WC) are differential pressure gauges. This
means they can be used to measure the difference in pressures between two separate areas or
they can be used to measure either positive pressure or negative pressure (vacuum).
TG-005
• Before using either of the differential pressure test gauges, they should to be calibrated against a
manometer or a
Remove the front cover by unscrewing it in a counter-clockwise direction. You may need to use
a pair of channel lock style pliers (be careful as the cover is made of plastic). DO NOT use any
clamping tool on the body of the gauge.
April, 2008 IMPCO Technologies Inc. PPI-109-REV. B
Page 4 of 12 3030 South Susan St.
known calibrated gauge. To calibrate a gauge:
Santa Ana, CA 92704
www.impcotechnologies.com
TG-010
Loading...