Impala Linear Corporation ILC6660IK Datasheet

Ordering Information* TA= 40°C to = 85°C
ILC6660IK 8-pin SOIC
The ILC6660 monolithic, charge-pump voltage inverter con­verts a +1.5V to +5.5V input to a corresponding -1.5V to -5.5V output. Using only two low-cost capacitors, the charge pump's 100mA output replaces switching regulators, eliminating inductors and their associated cost, size, and EMI. Greater than 90% efficiency over most of its load-current range com­bined with a typical operating current of only 120µA provides ideal performance for both battery-powered and board-level voltage conversion applications. The ILC6660 can also dou­ble or split the output voltage of an input powered supply or battery, providing +9.5V or +2.3V at 100mA from a +5V input.
A frequency control (FC) pin selects either 5kHz typ or 50kHz typ (30kHz min) operation to optimize capacitor size and qui­escent current. The Oscillator frequency can also be driven with an external clock. The ILC6660 is available in both 8-pin DIP and small-outline packages in commercial and extended temperature ranges.
ILC6660
CMOS Monolithic Voltage Converter
Impala Linear Cor poration
Impala Linear Corporation
1
(408) 574-3939
www.impalalinear.com
May 2000
ILC6660 1.8
Advance
+
INVERTED NEGATIVE
VOLTAGE
OUTPUT
1 2
3
4
8 7
6
5
FC
CAP+
ILC6660
VSS
CAP-
+V
IN
1.5V to 5.5V
SYNC
LV
VSH
VOLTAGE INVERTER
V+
C2 100µF to 470µF
C1 100µF to 470µF
R
L
• 0.5V Typ Loss at 100mA Load
• Low 120µA Operating Current
• 5.0Typ Output Impedance
• Guaranteed R
OUT
< 10for C1 = C2 = 100µF
• Inverts, Doubles or Splits Input Supply Voltage
• Selectable Oscillator Frequency: 5kHz/50kHz
• 90% Typ Conversion Efficiency at 100mA l
OUT
• 8-pin SOIC package.
• Laptop Computers
• Medical Instruments
• Interface Power Supplies
• Hand-Held Instruments
• Operational-Amplifier Power Supplies
+V
IN
2.5 TO 5.5V
100µF to 470µF
C1
+
DOUBLED
POSITIVE
VOLTAGE
OUTPUT
1
2
3 4
8 7
6
5
FC
CAP+
ILC6660
VSS
CAP-
SYNC
LV
VSH
POSITIVE VOLTAGE DOUBLER
V+
+
C2 100µF to 470µF
General Description
Features
Applications
Typical Circuits
+
SPLIT POSITIVE VOLTAGE
OUTPUT
1 2
3
4
8 7
6
5
FC
CAP+
ILC6660
VSS
CAP-
V
IN
2.5V to 5.5V
SYNC
LV
VSH
POSITIVE VOLTAGE SPLITTER
V+
C1 100µF to 470µF
C2 100µF to 470µF
+
CMOS Monolithic Voltage Converter
Impala Linear Corporation
2
(408) 574-3939
www.impalalinear.com
May 2000
ILC6660 1.8
Advance
1 2 3 4
8 7 6 5
FC
CAP+
VSS
CAP-
VSH
LV
SYNC
V+
SOIC
ILC6660
Pin-Package Configurations
Pin Functions ILC6660
Pin Number
Pin Name
Inverter
Splitter
Doubler
1
FC
Frequency Control for Internal Oscillator, FC open, f
OSC
=5kHz typ; FC = V+, f
OSC
=
50kHz typ. FC has no effect when SYNC pin is driven
externally.
Same as Inverter
Same as Inverter
2
CAP+
Charge-Pump Capacitor, Positive Terminal
Same as Inverter
Same as Inverter
3
VSS
Power-Supply Ground Input
Power-Supply PositiveVoltage Output
Power-Supply Positive Voltage Input 4
CAP-
Charge-Pump Capacitor, Negative Terminal
Same as Inverter
Same as Inverter 5
VSH
Output, Negative Voltage
Power-Supply Ground Input
Power-Supply Ground Input
6
LV
Low-Voltage Operation Input. Tie LV to VSS when input voltage is less than 2V. Above 2V, LV must be left open.
LV must be left open for all input voltages
LV must be left open for all input voltages.
7
SYNC
Oscillator Control Input. SYNC is connected to an internal 15pF capacitor. An external Oscillator may be connected to overdrive SYNC via a 2…5nF capacitor.
SYNC shall not be connected to ground.
Same as inverter, however, do not use SYNC in voltage­splitting mode
Same as inverter, however, do not use SYNC in voltage­doubling mode.
8
V+
Power-Supply Positive Voltage Input
Positive Voltage Input
Positive Voltage Output
Loading...
+ 3 hidden pages