Impact RST-001 User manual

RST-001

impact

lighting equipment and accessories

Posing Stool

ASSEMBLY INSTRUCTIONS

Parts List

1 – seat cushion
1 – mounting plate
4 – 1/2˝ screws
1 – pneumatic cylinder
1 – pedestal base
5 – pedestal feet

seat cushion

Step One

mounting
plate

1/2˝ screws

Remove all the parts from the carton and make
certain you have all the items in the parts list
above and in the correct quantity.

Step Two

Insert the pedestal feet into the pedestal base.
Be sure all feet are inserted securely.

pneumatic
cylinder

pedestal
base

Step Three

Insert the pneumatic cylinder into the
pedestal base.

Step Four

Attach the mounting plate to the seat
cushion using the four 1/2˝ screws.
Tighten the screws firmly.

Step Five

Push the mounting plate and the seat
cushion down onto the pneumatic cylinder
until it is secure.

To adjust the seat height, pull up on the lever and
either push down on the seat to lower or pull up
to raise the height. Make certain all screws are
tightened fully before using this stool.

pedestal
feet

www.impactstudiolighting.com