impact Luxbanx Duo LB-QL300 Instructions Manual

LB-QL300 Luxbanx Duo Softbox
INSTRUCTIONS
1
Introduction
Thank you for choosing Impact.
The Impact Luxbanx Duo LB-QL300 is designed to control and soften light for your specific photographic needs. Duo softboxes are compatible with continuous light sources (including quartz, tungsten, HMI and other “hot” lights, as well as LED or fluorescent lights) and flash (strobe) lighting sources. Hot lights with a maximum wattage of 300 can be used with this softbox. Do not use any hot light source with an energy output of more than 300 watts with this softbox.
This versatile softbox has a front surface of 16” × 22”″. A speed ring (not included) is required to mount the softbox to a light. A front diffuser can be attached using touch fasteners for a softer, more diffuse light. When removed, it allows the Luxbanx Duo’s textured silver interior to produce a more intense light with increased contrast and less light loss than a standard white softbox.
Warnings
• Warning sign (exclamation triangle) (U+26A0)
• Please read and follow these instructions, and keep this manual in a safe place.
• Keep this unit away from water and any flammable gases or liquids.
• Use only with lights of the recommended wattage.
• Handle the unit with care.
• Keep this unit away from children.
• Use parts provided by the manufacturer only.
• Make sure the item is intact and no parts are missing.
• All photos in this manual are for illustrative purposes only.
2
Overview
Box Contents
• Softbox fabric shell
• Four flex rods
• Spare flex rod
• Front diffuser
• Carrying case
• User manual
Please follow these instructions carefully when assembling your LB-QL300 softbox.
There are three parts to your Luxbanx:
• The softbox fabric shell
• Four flex rods
• External front diffuser
A speed ring (not included) is required in order to mount the Luxbanx softbox to a light. Speed rings are available separately.
3
Luxbanx Assembly Instructions
1. Insert the small tip of a flex rod through the guide loop along the seam of the softbox fabric shell. Insert the tip into the anchoring pocket at the front end of the softbox. The large tip of the flex rod should be positioned at the rear of the softbox fabric shell. Repeat this step with the remaining flex rods.
4
2. With the speed ring’s reflector mount facing away from the softbox, insert the end of a flex rod into a rod hole in the speed ring.
Loading...
+ 8 hidden pages