Quick Start Guide
Version 1.0.0
Packing List Product Appearance
Device*1 QSG*1 Power Adapter*1
Reset/WPS Button
Quick Installation Board*1
Screw Package*1 USB*1
Installation Position Map*1
Micro SD Card Slot
Note:
To reset, long press for 10 seconds till the light is off; to enable WPS, just press the button.
LED Indicator
Network Port
Power
Lens
Microphone
Built-in Speaker
The following table shows more information about status of indicator light
Device StatusIndicator Light Status
Spinning red
Spinning green
Flashing yellow
Flashing green
Blue light stably on
Flashing blue
Flashing red
Booting
Device malfunction
Failed to boot up
Booting completed
Waiting for Wi-Fi configuration
WiFi connection process
Device has been configured with WiFi, but it
failed to work normally
WPS pairing
Wi-Fi connection succeeded
Operate normally
Device upgrade
SD card malfunction
Operation by Imou App
Device Installation
Disclaimer
This quick start guide is for reference only. Minor difference might be
found inuser interface.
All the design and software here are subject to change without prior
writtennotice.
All trademarks and registered trademarks mentioned are the
properties of their respective owners.
-
Please visit our website or contact your local service engineer for
more information.
-
If there is any uncertainty or controversy,please refer to our final
explanation.
Step 1
Power on your camera with power adapter.
Step 2
Connect your smartphone to your Wi-Fi network, scan the
QR on the packing box to download and install Imou App.
Device
Add Device
Note:
-If you have more cameras, please follow step 4 to add them one by one.
-If you want to change the Wi-Fi signal, please reset the camera to factory default and repeat step 4 to add the camera.
Scan Setup
WiFi Name
Step 3
Run Imou App, and register account for first use.
Step 4
Follow the steps below to add your camera .
Setup
Next
Setup
Admin password
OK
Add Successfully
Live View
Note:
Before installation, please make sure the installation environments
can at least support 3x weight of the device.
Wall
Expansion Bolt
Installation Board
Screw
Device
To install the device, do the following.
Step1 Drill holes on the wall and install the expansion bolts into
the drilled holes.
Step2 Fix the installation board with screws onto the wall.
Spin the device to get locked onto the installation board.
Step3