IMO Go Quick Setup Manual

QUICK
SET UP GUIDE
Mobile WiFi Router
1. Schematic Diagram of Router:
Indicator Description
ID appearance
Interface Specification
ITEM
INTRODUCTION
indicator
2
1
Power buon
long press (3 seconds) to start on / off
the device
Sleep mode short press (less than 2 seconds) to exit Sleep
Equipment work properly, and the LCD screen backlight is turned on, Display SSID number andWIFI password short press (less than 2 seconds)
3
WPS buon
short press (3 seconds) to open the WPS mode
4
USB interface
Connect the USB cable to power adapter or PC/Laptop
3
Baery indicator
Network Mode indicator
WiFi indicator
SMS indicator
(U)SIM card installation instruction
Open the back cover, remove the baery.
Insert (U)SIM card into the slot.
Reset button
short press (less than 1 seconds) equipment to restart
long press (more than 2 seconds) to restore the factory settings
2. Operating environment :
Item
Descripon
OS
Windows Windows XP 64bit\32bit(SP3),Vista 64bit\32bit(SP2),7,8,10
Mac
OS X 10.6 and Later
Browser
Internet Explorer
Internet Explorer 9.0 or higher
Safari
Safari 4.0 or higher
3. Indicator Specification:
Status Information
Category Icon
Display
Baery indicator
Green light: the battery is fully charged. Green slow flash: the battery is charging. Red long light: ultra low voltage battery, may be automatically shut down. Put out: sleep, shut down.
Network Mode indicator
Green long light: 4G network Blue long light: 3G or 2G network
Red long light: smart card failure, or PIN code verificaon
failure, or no signal. Put out: shutdown, standby, sleep.
WiFi indicator
Green long light: WIFI working.
Green flash: WPS secure connecon is being built. Green slow flash five seconds: WPS secure connecon
successfully established.
Put out: WIFI off, shut down.
SMS indicator
Green slow ash: box is full Green long light: new sms. Put out: sleep, shut down.
4. Activate Client:
Open the browser, and then enter the IP address hp://192.168.1.1 device interface will open in your browser. Client default username / password: admin
5. Interface Introduction:
Client Home page information is divided into two parts:
1. Status information display and advanced settings area.
2. Informaon Tips Quick Setup area.
Icons and functions defined:
Status informaon display and advanced sengs area.
Icon Explanation
CONNECTION
SETTINGS
ABOUT
WiFi Config
STATUS
ADMIN
DISK
APN
Status Information Description
Network signal
Signal display
Connecon Status
Connected
Connected
Connected
Unconnected
Roaming
Roaming On
Baery
Baery power display
Connect the device power adapter or PC using a USB connecon
Informaon Tips Quick Setup area
No. Explanation
1
Home
2
Language sengs
3
Logout
4
Network connecon status
5 Baery status
6 SSID
7
SMS status
8 WIFI users
9 Roaming
4G
3G
2G
6. Safety Prcautions:
Read the safety precauons carefully to ensure the correct and safe use of your wireless device.
Do not switch on your device when the device use is prohibited or when
the device use may cause interference or danger.
Follow the rules or regulaons in hospitals and health care facilies.
Switch o your device near medical apparatus.
Switch o your device in an aircra. The device may cause interference
to control signals of the aircra.
Switch o your device near high-precision electronic devices. The device
may aect the performance of these devices.
Do not aempt to disassemble your device or its accessories. Only
qualied personnel are allowed to service or repair the device.
Do not place your device or its accessories in containers with strong
electromagnec eld.
Do not place magnec storage media near your device. Radiaon from
the device may erase the informaon stored on them.
Do not put your device in a high-temperature place or use it in a place
with flammable gas such as a gas staon.
Keep your device and its accessories away from children. Do not allow
children to use your device without guidance.
Use approved baeries and chargers only to avoid explosion.
Observe the laws or regulaons on device use. Respect others’ privacy
and legal rights when using your device.
Recommend that you use the equipment in this environment: Temperature: 0to 35. Humidity: 5% to 95%.
Recommend that you save the environment: Temperature: -10 to 45. Humidity: 5% to 95%.
Loading...