ImaxRC B6 AC Instruction Manual

Instruction Manual

www.imaxrc.com

Product Introduction

Speci cations

The B6 AC compact charges 2S to 6S Lipo and 1 to15 cell NiMH
battery packs with just the press of a button.Everything is
automatic,so there’s no complicated guesswork.You get a safe,
high-quality charge every time.Tt’s the easiest charger you’ll
ever use!

· Automatic Detection of Battery Cell Count and Capacity

· Automatically Sets Charge Output

· Integrated Cell Voltage Balancer for Lipo Batteries

· Highly Accurate Lipo Balance Charging +/- .01V

· High-Power,High-Performance Charge Circuit

· XH-Style Lipo Balance Ports

· Power Input:DC 11 to 18V / AC 100 to 240V

· LiPo Charge Rate:Up to 5.0 Amps ( 50 Watts Max )

· NiMH Charge Rate:Up to 4.0 Amps

· Power Output:50 Watts

· Charge Rate:Up to 1.5C

· Battery Type:Lipo 2S to 6S(Series) / NiMH to 15 Cells

1

LEDs

Main Output

Balance Ports

DC Input

AC Input

2

DC Input
Power Port

AC Input

Power Port

2S3S4S

+

5S6S

NiMH Status LED

LiPo Status LED

Output Power Ports

Start/Stop/Select Button

XH Balance Ports

OVERVIEW AND CONTENTS

Use the photos below to familiarize yourself with the various

connections and controls of the iMaxrc.

l

When connecting to a DC power source,make suer to ob­serve correct polarity -red to positive and black to negative.
Do not connect both power inputs to the charger at the
same time!

Plug your battery into the output power adapter cord.If you’re
charging a LiPo battery,plug its balance connector into the
matching balance port on the charger,too.

Depending on the power connector on your battery,you may
need to use an adapter or change the connector to match.

2

3

3

Use the information in this section to connect the B6 AC and
your battery.Failure to make the connections correctly can
result in damage to the charger and/or your battery.

Connect the charger to its power source, using either the AC
power cord or the DC power cord provided.When connected
to power, the charger will make a single audible tone and the
LiPo Status LED will illuminate green.

Plug the output power adapter cord into the output power
ports of the charger,making sure to observe correct polarity (
red to red and black to black)

1

LiPo Connection NiMH Connection