U
s er
U
ser
U
User
serM
1.ButtonsandConnections
2.ChargingwithInChargeHomeBT
2.1CharginganiPod/iPad/iPhone
N OT
i.WhenyouplugInChargeHomeBTintotheWalloutlet,TheLEDwillNOT
ii.WhenaUSBDeviceispluggedintotheUSBsocket,upto2.1Aofpowerwillbesupplied
immediately.
NOT
NOTturnon.
M
a nual
M
anual
Manual
anual
3.ConnectingtoBluetooth
3.1ConnectingtoInChargeHomeBTviaBluetooth
i.Holddowntheʻsyncʼbuttonfor2seconds,thiswillallowtheBluetoothdevicetobediscovered.
ii.TheLEDwillbegintoslowlyFlashBlue.
iii.Then,theUserselects"InChargeHomeBT"fromtheBluetoothListontheirdevice.Ifthedevice
requiresapairingcode,use"0000".
iv.Oncethedevicehassuccessfullypaired,therewillbeanaudibleʻbeepʼsenttothestereoandthe
LEDwillstopflashingandstaysolidblue.
v.Iftheunitisnotpairedafterfiveminutes,theLEDwillturnoff.
vi.InChargeHomeBTwillrememberthedevicethatitispairedwith,andlinktoiteachtimethat
InChargeHomeBTispoweredonand/orthedeviceisinrange.
PlayingAudiooverBluetooth
4.
4.1PlayingwirelessAudiooverBluetooth
i.TheusermusthavetheirradiosettoAUXandthe3.5mmcableproperlyconnected.
ii.Usetheaudiodevicetocontrolplaybackfeaturessuchasplayorpause.
U
ser
M
U
ser
U
U ser
ser M
5. Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
anual
M
anual
M anual
anual
RF Exposure Statement
To maintain compliance with FCC ’ s RF Exposure guidelines, This equipment should be
installed and operated with minimum distance between 20cm the radiator your body: Use
only the supplied antenna.
This device complies with industry canada licence-exempt RSS standard(s). Operation is
suject to the following two conditions:(1) this device may not cause interference, and(2) this
device must accept any interference, including interfernce that may cause undesired operation
of the device.