Imation, the Imation logo, SuperDisk and the SuperDisk logo are trademarks of
Imation Corporation. iMac, Macintosh, and the Mac OS logo are trademarks of
Apple Computer, Inc.
This guide shows how to install and use the Imation SuperDisk USB Drive on an
Apple Macintosh computer.
Limited Warranty
LIMITED WARRANTY AND LIMITATION OF REMEDIES: Imation warrants that this
product is free from defects in material and manufacture at the time of purchase. If
any such defect appears within twelve (12) months from the date of purchase,
Imation’s entire liability is either a) repair, or b) replacement of the product, or c)
refund of the purchase price of the product, which must be returned to Imation with
proof of purchase. This warranty does NOT apply to product failure resulting from
misuse, abuse, accident, neglect or mishandling, improper adjustment or
maintenance, incorrect environments or wear from ordinary use. IMATION SHALL
NOT BE LIABLE FOR ANY INDIRECT, SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL LOSS OR DAMAGE (INCLUDING WITHOUT LIMITATION
DAMAGES FOR LOSS OF PROFITS, SAVINGS OR DATA) IN ANY WAY RELATED
TO THE PRODUCT.
This does not exclude claims for personal injury. Some legal systems do not allow
limitations on how long an implied warranty lasts or the exclusion or limitation of
incidental or consequential damages, so the above limitation or exclusion may not
apply to you. This warranty gives you specific legal rights, and you may also have
other rights which vary depending upon the legal system which is applicable to your
purchase and/or use of this product.
Laser Safety
The Imation SuperDisk drive contains a Class 1 laser that produces visible laser light
at an intensity of up to 7 milliwatts (at 633 nanometers). Special precautions have
been taken in the design of the disk drive to ensure that the operator will not be
exposed to the laser light. Avoid looking directly into the laser beam path or any
reflection of it. Laser light of this intensity can cause serious eye damage.
Imation August 1998i
Page 5
Complies with IEC 825-1 and EN60825-1 as a Class 1 LASER Product.
Class 1 Laser products are not classified as being hazardous. However, to ensure
safety consistency over the entire product life cycle, the following precautions should
be considered:
1. Use of controls or adjustment of procedures other than those specified
herein may result in hazardous radiation exposure.
2. The drive is designed to be incorporated within the Imation external
enclosure. It is not designed to be used without an enclosure.
3. Do not open the external drive housing. There are no user adjustments
nor maintenance parts inside.
United States FCC Information
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receive is connected.
• Consult the dealer or an experienced radio or television technician for help.
iiImation August 1998
Page 6
Canadian Notice
This class B digital apparatus meets all requirements of the Canadian InterferenceCausing Equipment Regulations.
Avis Pour Le Canada
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement
sur le matériel brouilleur du Canada.
Imation August 1998iii
Page 7
European Electrical Conformity
This equipment fully complies with the European CE requirements specified in the
EMC Directive 89/336/EEC and the Low Voltage Directive 73/23/EEC. See the
following Declaration of Conformity:
Declaration of Conformity
98/336/EEC,73/23/EECApplication of Council Directive(s)
EN55022, EN60950Standard(s) to which Conformity is declared
EN50082-1
IEC1000-4-2
IEC1000-4-3
IEC1000-4-4
Manufacturer’s Name:Imation Enterprises Corp.
Manufacturer’s Address:1 Imation Place
Oakdale, MN 55128-3414
European Location of Declaration of Conformity
Imation Deutschland GmbH
Hammfelddam 11*D-41460 Neuss
Type of Equipment:Information Technology Equipment
This is to serve as official notification to our European Partners that the following
product fully complies with the European CE requirements specified in the EMC
directive 89/336/EEC and the Low Voltage Directive 73/23/EEC.
Model: SuperDisk USB Drive for Macintosh
Sincerely,
Stuart Adcock
• Auto switching power supply and cord (100-240V, 50/60 Hz)
• USB interface cable
• Mac OS 8.1 (or higher) installation CD-ROM
• 1 Macintosh format SuperDisk diskette
2. To use this SuperDisk drive you need an iMac or other Macintosh with all of the
following:
• Mac OS 8.1 (or higher) with USB system extensions
• available USB port
• CD-ROM drive
• 16 MB of RAM
• 5 MB of available hard disk space
Imation August 19981-1
Page 10
1. iMac SuperDisk Overview
3. To make sure you get the highest performance from your SuperDisk drive:
• Always place your SuperDisk drive on a flat level surface when in use.
• Always use horizontally.
• Never remove a diskette from your SuperDisk drive while the activity
indicator (green LED) is lit or blinking.
• For maximum performance, insist on Imation SuperDisk Diskettes for
Macintosh!
4. To keep up-to-date with product and software news, register your drive on-line by
following the links at:
http://www.imation.com/register/
Imation August 19981-2
Page 11
2. Installation
2. Installation
This equipment employs a visible Class 1 (7 milliwatts) laser beam. Laser radiation
may be present when the drive operates without panels or covers installed.
Use of controls or adjustments, or performance of procedures other than those
specified herein, may result in eye damage.
If your SuperDisk drive does not work, never remove the case. Covers shall be
removed by authorized service personnel only.
Installation Procedure
1. Connect the USB cable to rear of drive. Squeeze the cable end together to
separate the prongs. Then push the cable firmly onto the connector on the
drive. Release the sides to lock the cable to the drive.
Imation August 19982-1
Page 12
2. Installation
2. Insert the CD-ROM into the drive tray with the printed side up and close the
CD-ROM drive tray.
3. Click on the CD icon and wait for the CD window to open.
4. Double-click on the SuperDisk Installer icon in the CD window, then follow the
instructions on the screen. This copies the drivers and extensions to the
appropriate place in the system folder.
Imation August 19982-2
Page 13
2. Installation
5. Plug the power cord (round end) into the rear of the drive and plug the other end
of the power cord into the power outlet.
6. Plug the USB cable into one of the available USB ports on the computer.
7. Insert the SuperDisk diskette provided with this drive into the SuperDisk drive.
Imation August 19982-3
Page 14
2. Installation
8. Once the diskette is in place, the SuperDisk diskette icon will display on your
desktop.
Installation is complete. You are ready to use your Imation SuperDisk drive.
If you experience problems, refer to the Troubleshooting section (page 5-1), check
the Readme file provided on the CD-ROM or contact Imation Technical Support.
Imation August 19982-4
Page 15
3. Operating the SuperDisk Drive
3. Operating the SuperDisk Drive
Once you insert a SuperDisk or HD diskette into your drive, the diskette icon on your
desktop operates just like your hard disk icon. You can drag-and-drop files to the
diskette icon to move or copy files or folders. Just double-click on the icon to see the
files and folders on the diskette.
Ejecting Diskettes
• There are two normal ways to eject a diskette:
1. drag the icon to the trash icon
or
2. press the “open apple z” key and “e” at the same time
• If a disk is damaged or defective, or if the diskette icon does not appear when
you have a diskette in the drive, push the eject button on the front of the drive to
eject the diskette. Note: If the icon appears on your desktop, the eject button
will not eject the diskette.
Imation August 19983-1
Page 16
3. Operating the SuperDisk Drive
• Emergency - If the diskette appears stuck or the drive does not have power,
straighten out a paper clip, insert it into the small hole in the center of the eject
button, and push it in until the diskette ejects.
√ NOTE
Never attempt to eject a diskette while the green activity light is blinking. This
interrupts data flow and corrupts information.
General Usage Information
The drive uses the latest USB technology and is fully hot-pluggable to the iMac or
other USB-enabled Macintosh. You do not need to turn off or reboot the computer
to attach and use the SuperDisk Drive.
Imation August 19983-2
Page 17
3. Operating the SuperDisk Drive
Suggested Usage
High-capacity, floppy-compatible: uses both Macintosh and PC format SuperDisk
(120 MB) and standard 3.5" 2HD diskettes.
• Store data and organize those big files with 85 times the capacity of
conventional diskettes.
• Transfer large files and share data with other computers, both Mac and PC.
• Download from the Internet.
• Back Up and restore important files and folders.
• Create Space: Archive files to make space on your hard drive.
• Protect private information on a personal SuperDisk diskette
Imation August 19983-3
Page 18
4. Maintenance
4. Maintenance
It is recommended that the SuperDisk Drive be cleaned after every 40 hours of
operation. The Imation LS120 SuperDisk Head Cleaning Kit is available through
your retailer or on the Imation Internet store (in the US only): www.imation.com
CAUTION
Use only Imation’s LS-120 SuperDisk Head Cleaning Kit. Because of
potential damage to the drive’s head, use of any other head cleaning kit
will void the warranty.
Imation August 19984-1
Page 19
5. Troubleshooting
5. Troubleshooting
If no desktop icon displays after you insert a diskette in the drive, complete the
following checks:
• Make sure you have a diskette in the SuperDisk drive.
• Make sure all cables are securely connected.
• Make sure the computer and drive have power.
• Make sure you are using the cables that came with the drive.
• If it still doesn’t work:
- Eject disk using button on drive.
- Unplug USB connection on computer.
- Unplug drive from power source.
- Reseat USB cable in rear of drive.
- Plug drive back into power source, reconnect to computer, and reinsert
diskette.
Imation August 19985-1
Page 20
5. Troubleshooting
Imation Technical Support
There are several ways to contact Imation for technical support.
For telephone support numbers in other countries and for fax numbers,
please check the readme files on the installation CD and the Imation web
site (www.imation.com), or contact Imation in the United States at:
Other Countries:1-651-704-7229
Telephone support is free for 30 days from first contact. After 30 days, there may be
a basic charge (credit card only) for phone consultations and solutions to installation
and operator problems. This charge is waived if the identified problem is under
warranty coverage. There is no charge for “Where to buy” or general SuperDisk
product information. Please see our free support offerings on the Internet, E-mail,
and Fax Back.
Free support is available with the following:
Internet and FAQs: www.imation.com/superdisk/
E-mail: info@imation.com
Fax Back:1-888-466-3456 (in the US and Canada)
1-415-596-4434 (outside the US and Canada)
Imation August 19985-2
Page 21
6. Specifications
Size
Height2 inches38 mm
Width5.25 inches133 mm
Length7.5 inches190 mm
Power (indoor use only - away from water)
Input100VAC - 240VAC50/60Hz 15W
Output5VDC (Regulated)1A
Temperature Range (use in a non-condensing atmosphere)
Operating40° to 104° F5° to 40° C
Non-operating-22° to 140° F-30° to 60° C
Operating Position: Horizontal Only
Transfer Rate: up to 25 MB per minute with a SuperDisk diskette
6. Specifications
Imation August 19986-1
Page 22
6. Specifications
Diskette Types (3.5 inch)
Diskette TypeMac/PCRead/Write/
Format
SuperDiskMac format√120 MB Mac OS format SuperDisk diskettes
PC format√120 MB PC (IBM) format SuperDisk diskettes
2HDMac format√1.4 MB Mac format 3.5" 2HD diskettes
PC format√1.44 MB IBM format 3.5" 2HD diskettes
2DDMac format∅N/A - SuperDisk drives do not support 800 KB Mac
format 2DD diskettes
PC format√720 KB IBM format 3.5" 2DD diskettes
Diskette Used
√ NOTE
Do not erase (reformat) SuperDisk diskettes to a DOS format using Mac OS PC
Exchange 2.2 or earlier. These versions will not correctly format a DOS (PC)
SuperDisk diskette.
6-2Imation 1998
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.