Iluv i110 User Manual

i110 User’s Manual

The device complies with part 15 of Fcc Rules .Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired operation

The changes or modifications not expressly approved by the party responsible for compliance could void the user’s

authority to operate the equipment.

1、 SPECIFICATION。

z Bluetooth Core: Bluetooth V1.2 compliant

z Bluetooth Profile: A2DP, AVRCP

z Operating Frequency: 2.4-2.4835GHz

z Security Features: 128-bit Encryption

z Transmitting Rate: 721Kbps (Max)

z Wireless Technology: FHSS

z Communication Distance: Class 2, up to 33ft (10m)

Brief Introduction of Functions.

i110 Bluetooth Dongle has two operating modes：TX and RX。It has a mode selection switch for shifting modes

and a pairing button for operating pairing.

TX is transmitting mode. By Bluetooth, it can transmit the analog audio signals from acoustic mainframe to other

Bluetooth receiving devices (e.g. Bluetooth stereo headset).

RX is receiving mode. It can receive stereo music from Bluetooth devices, which support A2DP profile (e. g. PC

or Mobile phone supporting Bluetooth). Meanwhile, it can amplify and output the music through acoustic

mainframe.

2、 States and Indicator

3、 Pairing button’s operation

State Standby Pairing Connecting Connecting

Successful

Short-press Pairing

button

Connecting Connecting N/A N/A

Long-press Pairing

Button

Paring N/A Pairing Pairing

Note : Short-Press is less than 1 second.

Long-press is 3 seconds.

4. TX Mode.

z Plug i110 to mainframe and make it electrified, it will come in default standby mode. Then the blue LED

will flash slowly.

z Long press pairing button in pairing state, then pair and connect it with other Bluetooth stereo audio

receiving devices (e.g., Bluetooth headset) until red and blue LED blinking alternately. The blue LED is keep

on when paired and connected successfully.

z I110 will store the information of the last paired devices. Even if turned off or disconnected with Bluetooth

devices, it needs no repairing when reconnected. Just use the following connecting functions, then it will be

ok.

1) At standby state, short press i110 pairing button to connect the last paired device until blue LED flash.

When connected, blue LED light on.

2) If Bluetooth stereo headset has paired with i110, when the headset is turned on, it will automatically

connect i110.

3) If the Bluetooth stereo headset has no automatic connecting function, then press its Play/Pause key to

perform its connecting function.

4) If Bluetooth headset is beyond its effective range, it will disconnect with i110. Then it needs reconnect.

Make sure that the distance between i110 and headset is within effective communication range. Then short press i110’s

pairing button or Play/Pause button on Bluetooth headset to connect them.

z ill0 supports AVRCP profile. When plugged into mainframe, can use Bluetooth headset to remote control

mainframe play. (Note: Because difference products have different software, it is natural that parts or all of
their remote control functions maybe invalid)。

4、 RX Mode.

z Plug i110 to mainframe and make it electrified, it will come in default standby mode and begin to connect

State Blue LED Red LED

Power off Off Off

Standby flash slowly：flash 1 times every 5s Off

Paring

Flash 1times in 100ms，then standby state after

3 minutes.

Flash 1times in100ms，then standby state after

3 minutes

Connecting

Flash 1times in100ms，then standby state after

10 seconds

Off

Connecting

successful

Long On Off