ILP CONVERTAFLOOD CFS-36W-U Series, CONVERTAFLOOD CFS-36W-U-40, CONVERTAFLOOD CFS-36W-U-50 Installation Instructions Manual

ILP – Industrial Lighting Products, LLC

519 Codisco Way, Sanford, FL 32771

Phone: [phone] Fax: [phone]

www.ilp-inc.com

INSTALLATION INSTRUCTIONS

36W CONVERTAFLOOD

MODEL:

CFS-36W-U-XX

(Note: Replace XX with 40 or 50 based on CCT of LED, may be followed by BLK, BRZ, or WHT)

Model number list:

Item

Model

Input Voltage

Input Watts

Weight

A

CFM-36W

100-277VA

36W

4.8 lbs.

1. Introduction

◼

This LED Flood uses the latest in lighting technology for long life, low maintenance,

and easy adaptability.

◼

This driver allows operation on nominal 100V-277V, 50-60Hz AC supply without any variation in

light output.

◼

Suitable for use in the following locations:

•

Min. Ambient Temp: -22°F (-30°C)

•

Max Ambient Temp: 104°F (+40°C)

•

Suitable for mounting in Wet Locations

•

Suitable for mounting within 1.2m (4 ft.) of the ground.

Warning:

To avoid the risk of fire, explosion, or electric shock, this product shall be installed, inspected,
and maintained by a qualified electrician, in accordance with all applicable electrical codes.

Warning:

To avoid electric shock:

•Allow product to cool before servicing.

•Be certain electrical power is OFF before and during installation or maintenance.

•Luminaire must be connected to a wiring system with equipment-grounding conductor.

Warning:

To avoid explosion:

•Make sure the supply voltage is the same as the rated luminaire voltage.

•Do not operate in ambient temperatures above those indicated for the luminaire.

ILP – Industrial Lighting Products, LLC

519 Codisco Way, Sanford, FL 32771

Phone: [phone] Fax: [phone]

www.ilp-inc.com

2. Installation

Step 1
Mount the fixture to any metal 1/2” NPS female threaded connection (supplied by others) and securely
attach via the 1/2" Lock Nut (FIG.1). Please mount the fixture prior to making wiring connections.

Step 2
Open the back cover by using the provided tool to loosen the security closure screw (FIG.1), hold and
compress fixture lightly while depressing the cover opening latch. Make any dimming adjustments via
the dimmer knob (FIG.2) and if the photocell is to be used make sure the switch is on the “YES” position
(FIG.2).

Step 3
Close the back cover and tighten the security closure screw using the provided tool to approx. 10 ft lbs.

3. Electrical Connections

Step 1
Make the necessary wiring connections (FIG.3).

After installation, please

➢ Ensure the lighting fixture is firmly secure to its mount.
➢ Ensure wires are connected correctly before applying power.

To complete installation, turn power ON, check for proper operation of luminaire.

FIG.3

FIG.1

FIG.2