ILP CFL-110W Series, CFM-52W Series, CFS-36W-U Series, CFM-52W-U Series, CFM-85W-U Series Installation Instructions Manual

ILP – Industrial Lighting Products, LLC

519 Codisco Way, Sanford, FL 32771

Phone: [phone] Fax: [phone]

www.ilp-inc.com

CONVERTAFLOOD REFLECTOR

INSTALLATION INSTRUCTIONS

MODELS:

CFS-36W-U-XX
CFM-52W-U-XX or CFM-85W-U-XX
CFL-110W-U-XX or CFL-150W-U-XX

(Note: Replace XX with 40 or 50 based on CCT of LED, may be followed by BLK, BRZ, or WHT)

Part Number List:

(Note: The NEMA 7x6 reflector comes Standard on the Convertaflood. Replacements are available.)

1. Introduction

◼

The CF Family LED Floods use easy replaceable snap-in type reflectors to customize

to your lighting needs.

MODEL

REFLECTOR PART NUMBERS

NEMA 3X3

NEMA 4X4

NEMA 5X5

NEMA 7x6

CFS-36W

-

N44/S

N55/S

N76/S

CFM-52W

N33/M52

N44/M52

N55/M

N76/M

CFM-85W

-

N44/M85

N55/M

N76/M

CFL-110W or CFL-150W

N33/L

N44/L

N55/L

N76/L

Warning:

To avoid the risk of fire, explosion, or electric shock, this product shall be installed, inspected,
and maintained by a qualified electrician, in accordance with all applicable electrical codes.

Warning:

To avoid electric shock:

•Allow product to cool before servicing.

•Be certain electrical power is OFF before and during installation or maintenance.

•Luminaire must be connected to a wiring system with equipment-grounding conductor.

Warning:

To avoid LED damage:

•Please do not touch the LED when replacing the reflector. Touching the LED may result in
damage or failure of the LED.

ILP – Industrial Lighting Products, LLC

519 Codisco Way, Sanford, FL 32771

Phone: [phone] Fax: [phone]

www.ilp-inc.com

2. Installation

Step 1
Open the back cover by using the provided tool to loosen the security closure screw, hold and compress
fixture lightly while depressing the cover opening latch. (FIG.1)

Step 2
Remove existing reflector by tilting the reflector forward until the tabs release than slightly pull outward
to remove the reflector. (FIG.2)

Step 3
Replace reflector by tilting the reflector forward and dropping into the bottom tabs. slightly push forward
till the reflector snaps in the remaining tabs. (FIG.3)

Step 4
Close the back cover and tighten the security closure screw using the provided tool to approx. 10 ft lbs.

After installation, please

➢ Ensure the lighting fixture is firmly secure to its mount.
➢ Ensure wires are connected correctly before applying power.

To complete installation, turn power ON, check for proper operation of luminaire.

FIG.3

FIG.1

FIG.2