Infrared Portable Space Heater
1500 Watts with
Two Heat Settings
Thermal Cutoff Protection
Tip-Over Switch
Room Temperature
LED Display
Precision Temperature
Control
Easy Push-Button Controls
Remote Control
Advanced Dual Heating System (ADHS)
Owner’s Manual
PLEASE READ AND
SAVE THESE INSTRUCTIONS
CONGRATULATIONS!
he iLIVING Heater you have just purchased is a safe
and powerful heater, designed to heat a room after a few minutes of
operation. The far-infrared Quartz-PTC heating system is an excellent
WARNING!
To reduce the risk of fire, electric shock, or personal injury, read
all the instructions before using this heater. This appliance is intended for
household or personal use only as described in this manual. Any other use
including but not limited to commercial, agricultural, or outdoor use, is not
recommended by the manufacturer and may cause fire, electric shock, injury
and/or damages. The use of attachments, accessories or extension cords not
recommended or sold by iLIVING may cause hazards and void the warranty.
system for safely heating whole rooms, while saving on heating bills than the
other heaters.
Additionally, this heater includes an overheat protection system, and an inlet air
overheat protection system designed to ensure your safety.
This heater does not reduce humidity or oxygen in your home or office giving
you and your family better health!
Before using your iLIVING heater, please take a few minutes to read these
instructions, review the product limited warranty.
Thank you!
CAUTION- High temperature! Keep electrical cords, drapery, and other
furnishings at least 3 feet (0.9 m) from the front and rear of the heater.
IMPORTANT
INSTRUCTIONS
When using this appliance, basic precautions should always be followed to
reduce the risk of fire, electric shock and injury to persons.
1. Read all the instructions before using this heater.
2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot
surfaces. Keep combustible materials, such as furniture, pillows, bedding,
papers, clothes and curtains at least 3 feet (0.9 m) from the front of the
heater and away from the sides and rear.
3. Extreme caution is necessary when any heater is used by or near children
or persons with physical challenges and whenever the heater is left
operating and unattended.
4. Do not operate the heater with a damaged cord or plug, or after the heater
malfunctions, has been dropped, or damaged in any manner. Return the
heater to an authorized service facility for examination, electrical or
mechanical adjustment, or repair.
5. Do not use outdoors.
6. This heater is not intended for use in bathrooms, laundry areas or similar
locations. Never locate the unit where it may fall into a bathtub or other
water container.
7. Do not run the cord under carpeting and do not cover the cord with throw
rugs, runners or the like. Arrange the cord away from traffic areas to avoid
a tripping hazard.
8. To disconnect the heater, turn controls to OFF, then remove the plug from
outlet.
9. Do not insert or allow foreign objects to enter any ventilation or exhaust
opening as this may cause an electric shock, fire or damage to the heater.
10. Connect to properly grounded outlets only.
11. To prevent a possible fire, do not block air intakes or exhaust openings in
any manner. Do not use on soft surfaces, like a bed, where openings may
become blocked. Use the heater on flat, dry surfaces only.
12. A heater has hot and arcing or sparking parts inside. Do not use the heater
in areas where gasoline, paint or flammable liquids are used or stored.
13. Use this heater only as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electric shock or injury
to persons.
14. Never clean this heater while it is plugged in. Do not immerse in water. To
disconnect, turn control to OFF, then remove the plug from the outlet by
grasping it and pulling it from the outlet. Never yank on the cord.
15. Always unplug the heater when it is not in use.
16. Always plug heater directly into a wall outlet/receptacle. Never use with an
extension cord or relocatable power tap (outlet/power strip).
17. It is normal for the heater’s plug and cord to feel warm to the touch. A plug
or cord which becomes hot to the touch or becomes distorted in shape may
be a result of a worn electrical outlet. Worn outlets or receptacles should be
replaced prior to further use of the heater. Plugging this heater into a worn
outlet may result in overheating of the power cord or fire.
18. Make sure the plug is fully inserted into an appropriate receptacle. Be
15.5 in. (H) X 11.0 in. (W) X 13.0 in. (D)
mindful that receptacles also deteriorate due to aging and continuous use.
Check periodically for signs of overheating or deformations of the plug. If
any overheating or deformation occurs, immediately discontinue using the
heater and contact iLIVING Heater Authorized Service Center.
19. CHECK YOUR HEATER CORD AND PLUG CONNECTIONS. Faulty wall
outlet connections or loose plugs can cause the outlets or plug to overheat.
During use, please check frequently to determine if your plug outlet or
faceplate is HOT! If it is hot, discontinue using the heater and/or make
certain a qualified electrician checks and replaces the faulty outlet(s).
CAUTION: This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the appliance
by a person responsible for their safety.
SAVE THESE INSTRUCTIONS
Product Specifications
Special Features
LED Display – When the unit is plugged in, the LED display will show the room
temperature. At ECO mode, it will display the set value 2 minutes after the
desired temperature is set.
Overheat Cut-Off Protection System –This heater includes a protection system
that cuts off the unit if it overheats for any reason.
Inlet Air Overheat Protection System – This heater will automatically cut off if
the inlet air duct becomes obstructed and causes the unit to overheat.
Safety Tip-Over Switch – The iLIVING Heater is designed to cut off
automatically when tipped in any direction. Place the heater on a flat, smooth,
stable surface to prevent the heater from tipping over again. When returned to
a normal upright position, the heater is ready for use again. This is a safety
feature to avoid the possibility of fire should the unit be tipped accidentally.
Advanced Dual Heating System (ADHS) - iLIVING Heater is the first to feature
Important: This heater comes with a
grounded (three-prong) plug. The
grounded plug must be used with a
grounded outlet. Do not use an
adapter in a two-slot wall outlet unless
the ground plug of the adapter
properly connects to a building ground.
Using the heater without a properly
grounded outlet or adapter could
result in an electric shock hazard.
The cord has a plug as shown at A in
the following figure. An adapter, as
shown at C, is available for
connecting three-blade
grounding-type plugs to two-slot
receptacles. The green grounding lug
extending from the adapter must be
connected to a permanent ground
such as a properly grounded outlet
box. The adapter should not be used
if a three-slot grounded receptacle is
available.
a dual heating system for maximum heat transfer rate. It combines the energy
efficiency of infrared heat with the comfort of convection heat to heat your room
fast and comfortably—without hot spots and cold spots.
Features
A. “Cool-Touch” cabinet E. MODE button
B. POWER button F. LED temperature display
C. Decrease temperature button G. Standby ON/OFF button
D. Increase temperature button H. Power LED
Operating Instructions
1. Plug the power supply cord into a grounded wall outlet. (120VAC,
60Hz)