AC power input: requires an AC/DC power
adapter (included)
LINE IN USB CHARGER
DC IN 5V
RESET
IBB683B Bluetooth Boombox
Warning: Changes or modications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• The apparatus shall not be exposed to dripping or splashing and that no
objects lled with liquids, such as vases, shall be placed on apparatus.
L’appareil ne doit pas être exposé aux écoulements ou aux éclaboussures et aucun
objet ne contenant de liquide, tel qu’un vase, ne doit être placé sur l’objet.
• Main plug is used as disconnect device and it should remain readily operable during
intended use. In order to disconnect the apparatus from the mains completely, the
mains plug should be disconnected form the mains socket outlet completely.
La prise du secteur ne doit pas être obstruée ou doit être facilement
accessible pendant son utilisation. Pour être complètement déconnecté de
l’alimentation d’entrée, la prise doit être débranchée du secteur.
• Battery shall not be exposed to excessive heat such as sunshine, re or the like.
Les piles ne doivent pas être exposées à de forte chaleur, tel qu’à la
lumière du soleil, au feu ou autres choses de semblable.
• Caution marking is located at the rear or bottom of the apparatus.
Attention marquage est situé sur le paneau arrière ou inférieur de l’unité.
• The marking information is located at the rear or bottom of apparatus.
Le marquage est situé sur le paneau arrière ou inférieur de l’unité.
1. Read these Instructions.
2. Keep these Instructions.
3. Heed all Warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings. Install in
accordance with the manufacturer’s instructions.
8. Do not install near any heat sources such as
radiators, heat registers, stoves, or other apparatus
(including ampliers) that produce heat.
9. Do not defeat the safety purpose of the polarized
or grounding - type plug. A polarized plug has two
blades with one wider than the other. A grounding
type plug has two blades and a third grounding
prong. The wide blade or the third prong are
provided for your safety. When the provided plug
does not t into your outlet, consult an electrician
for replacement of the obsolete outlet.
10. Protect the power cord from being walked on or
pinched particularly at plugs, convenience receptacles,
and the point where they exit from the apparatus.
11. Only use attachments/accessories
specied by the manufacturer.
12. Use only with a cart, stand, tripod, bracket, or table
specied by the manufacturer, or sold with the
apparatus. When a cart is used, use caution when
moving the cart/apparatus combination to avoid injury
from tip-over. Unplug this apparatus during lightning
storms or when unused for long periods of time.
13. Refer all servicing to qualied
service personnel. Servicing
is required when the apparatus
has been damaged in any way,
such as power-supply cord or
plug is damaged, liquid has been
spilled or objects have fallen
into the apparatus, the apparatus
has been exposed to rain or
moisture, does not operate
normally, or has been dropped.
• CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE
BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
• WARNING:To reduce the risk of re or electric shock, do
not expose this apparatus to rain or moisture.
• AVERTISSEMENT: Pour réduire le risque d’incendie ou de choc
électrique, ne pas exposer cet appareil sous la pluie et l’humidité.
• CAUTION: Use of controls or adjustments or performance of procedures
other than those specied may result in hazardous radiation exposure.
• WARNING: Changes or modications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
• WARNING:Do not place this unit directly onto furniture surfaces with any type of soft, porous,
or sensitive nish. As with any rubber compound made with oils, the feet could cause marks
or staining where the feet reside. We recommend using a protective barrier such as a cloth or a
piece of glass between the unit and the surface to reduce the risk of damage and/or staining.
• WARNING: Use of this unit near uorescent lighting may cause interference
regarding use of the remote. If the unit is displaying erratic behavior move
away from any uorescent lighting, as it may be the cause.
• CAUTION:Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
• PRÉCAUTION: Danger d’explosion si les piles sont remplacées de façon incorrect.
Remplacer les piles seulement par le même type de pile ou l’équivalent.
• WARNING: There is a danger of explosion if you attempt to charge standard
Alkaline batteries in the unit. Only use rechargeable NiMH batteries.
• WARNING: The remote control’s button cell battery contains mercury. Do
not put in the trash, instead recycle or dispose of as hazardous waste
• WARNING:Lithium batteries, like all rechargeable batteries are recyclable and should be
recycled or disposed of in normal household waste. Contact your local government for disposal
or recycling practices in your area. They should never be incinerated since they might explode.
• WARNING: Shock hazard - Do Not Open.
• AVIS: RISQUE DE CHOC ÉLECTRIQUE - NE PAS OUVRIR
Mains plug is used as disconnect device and it should remain readily operable during
intended use. In order to disconnect the apparatus from the mains completely, the
mains plug should be disconnected form the mains socket outlet completely.
La prise du secteur est utilisé pour déconnecter le système.
La prise du secteur ne doit pas être obstruée ou doit être facilement
accessible pendant son utilisation. Pour être complètement déconnecté de
l’alimentation d’entrée, la prise doit être débranchée du secteur.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc) batteries.
No mezcle baterías viejas y nuevas.
No mezcle baterías alcalinas, estándar (carbono-zinc) o recargables (ni-cad, ni-mh, etc.).
WARNING: TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT REMOVE
COVER (OR BACK). NO USERSERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE
PERSONNEL.
ATTENTION
RISQUE D' ÉLECTROCUTION
NE PAS OUVRIR
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
The exclamation point within an equilateral
triangle is intended to alert the user to the
presence of important operating and maintenance
(servicing) instructions in the literature
accompanying the appliance.
This symbol indicates that this product
incorporates double insulation between hazardous
mains voltage and user accessible parts.
The lightning ash with arrowhead symbol,
within an equilateral triangle, is intended to alert
the user to the presence of uninsulated “dangerous
voltage” within the product’s enclosure that may
be of sufcient magnitude to constitute a risk of
electric shock to persons.
IMPORTANT SAFETY INSTRUCTIONS
Introduction and Setup
FCC Warnings
Power
Additional Warnings
WARNINGS AND PRECAUTIONS
For Warranty Information and the most up-to-date version of this User’s Guide, go to www.iLiveElectronics.com Customer Service: 1-888-999-4215
Email Support: prodinfo@dpiinc.com, Email Parts: partsinfo@dpiinc.com
Copyright © 2012 Digital Products International (DPI, Inc.) All other trademarks appearing herein are the property of their respective owners. Specications are subject to change without notice.
USER’S GUIDE
V:830-01
POWER SOURCE PAIR PLAY/PAUSE MEMORY TUNE +TUNE – VOLUME SCAN/CLK SET/
DISPLAY
Memory
In FM Radio mode, press the
Memory and Tun/Skip buttons
to cycle through saved presets.
Press & hold to start saving a
station as a preset.
Tun/Skip
In FM Radio mode,
press to tune the
radio. Press and hold
to search for the next
available station.
In Bluetooth mode,
press to skip to the
next track.
Scan/Clk Set/
Display
In FM radio mode,
press & hold to start
the auto scanning for
all FM stations.
In off mode, press and
hold to begin setting
the clock.
Press to momentarily
display the clock if the
LCD screen is off.
Volume
Press to adjust the
volume.
LCD Screen with
Equalizer
Source
Press to switch
between
Bluetooth, Line
In, and FM
Radio modes.
Play/Pause
In Bluetooth mode,
press to play or pause
the current track.
Pair
Press to begin
pairing a
Bluetooth device.
Battery
Indicator
Power
Press to turn
the unit on or
off.
Line In
LINE IN USB CHARGER
DC IN 5V
RESET
USB Charging
Port
IBB683B-830-01-IB.indd 1 4/23/2013 2:42:43 PM
Radio
Tuning the FM Radio
Tuning to a Preset Radio Station
Radio Reception
To download this User’s Guide in English,
Spanish, or French, or to get answers to
frequently asked questions, visit the support
section at: www.iLiveElectronics.com
Para descargar este Manual del Usuario en
inglés, español y francés, o para obtener
respuestas a preguntas frecuentes, visite la
sección de apoyo en www.iLiveElectronics.
com
Pour télécharger ce guide de l’utilisateur en
anglais, espagnol ou français, ou pour obtenir
des réponses à des questions fréquemment
posées, consultez la rubrique d’assistance
sur www.iLiveElectronics.com
International Support
For Warranty Information and the most up-to-date version of this User’s Guide, go to www.iLiveElectronics.com Customer Service: 1-888-999-4215
Email Support: prodinfo@dpiinc.com, Email Parts: partsinfo@dpiinc.com
Copyright © 2012 Digital Products International (DPI, Inc.) All other trademarks appearing herein are the property of their respective owners. Specications are subject to change without notice.
Requires a 3.5mm audio cable (included)
1. Connect the 3.5mm audio cable to the
Line In on the unit and an audio output
on an MP3 player or other audio source.
2. Press the Source button to switch to
Line In mode.
3. Use the native controls on the
connected MP3 player or other audio
source to play and control audio
played through the clock radio.
Line In
Using the Line In
Bluetooth Setup
Pairing a Bluetooth Device for the First Time
1. Power on the unit by pressing the Power
button.
2. Press the Source button to switch to
Bluetooth Mode.
The display will show the Bluetooth logo
ashing.
When pairing, remain within 3 feet of the
unit.
If the unit does not automatically begin to
pair, press the Pair button.
3. Using the native controls on your
Bluetooth device, select the “IBB683” in
your Bluetooth settings to pair.
If your device requests a password, enter
the default password “ 0 0 0 0 ”.
Refer to the user’s manual for your specic
device for instructions on pairing and
connecting Bluetooth devices.
4. When successfully paired, the display will
stop ashing.
After initial pairing, the unit will stay paired
unless unpaired manually by the user or
erased due to a reset of the device.
If your device should become unpaired,
follow the above steps again.
If any pairing issues should occur, un-pair
the unit on your Bluetooth device and
follow the above steps again.
1. Follow the instructions for Pairing a
Bluetooth Device.
2. Use the native controls on the
connected Bluetooth Device to select a
track.
3. To play, pause or skip the selected track,
use the native controls on the connected
Bluetooth Device or press the Play/
Pause or Tun/Skip buttons.
4. Audio played through the connected
Bluetooth device will now be heard
through the speakers.
Playing Audio Wirelessly
Saving a Station as a Preset
1. Press the Source button to switch to FM
Radio mode.
2. Press the Tun/Skip buttons to tune the
radio manually, press and hold to search
for the next available station.
Adjust the position of the Telescopic FM
Antenna to improve FM radio reception.
1. Follow the instructions for Playing the
Radio.
2. Press & hold the Memory button. The
preset number will begin to blink on the
display.
3. Press the Tun/Skip to select a preset
number.
Up to 20 stations may be preset.
4. Press the Memory button to save the
current station to the selected preset.
1. In FM Radio mode, press the Memory and
Tun/Skip buttons to cycle through saved
presets.
Charging
Charging a Device
1. Make sure the unit is plugged into the
wall.
2. Using the appropriate USB charging
cable (not included), connect one end
to the device and the other to the USB
Charging Port on the unit.
Refer to the user’s manual for your
specic device for manufacturers
required charging amperage as well as
determining the appropriate cable for
your device before charging.
3. The device will now charge.
1. If powered on, press the Power button to
turn the unit off.
2. Press and hold the Clock Set button.
3. Press the Tuning+/- buttons to adjust the
hour.
The PM indicator will light when the hour
is set in the PM.
4. Press the Clock Set button.
5. Press the Tuning+/- buttons to adjust the
minute.
6. Press the Clock Set button again to nish
setting the time.
Clock
Setting the Clock
Status Battery Indicator
Fully Charged No light
Charging Red light
Low Battery Flashing red light
Charging the unit
1. Connect the unit to an AC wall outlet.
Charge fully before use.
2. The Battery Indicator will display a red
light when the unit is charging, and turn
off when the unit is fully charged.
Note: Charge the unit at least once a
month to maintain battery integrity even
when not in use.
IBB683B-830-01-IB.indd 2 4/23/2013 2:42:43 PM
Loading...