Ilive IAEB6 V1995-01 User Manual

FCC WARNINGS

• Warning: Changes or modications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

ADDITIONAL WARNINGS

• WARNING: To prevent re or shock hazards, do not expose this unit to rain or moisture.

• WARNING : Where the mains plug or appliance coupler is used as the disconnect device, such disconnect device shall remain readily operable.

• Lithium batteries, like all rechargeable batteries, are recyclable and should be recycled or disposed of according to state and local guidelines. They should never be disposed of in normal household waste and they should never be incinerated, as they might explode. Contact your local government for disposal or recycling practices in your area.

• This product meets and complies with all Federal regulations.

• To avoid hearing damage, make sure that the volume on your music player is turned down before connecting your earbuds. After placing earbuds in/on your ears, gradually turn up the volume until you reach a comfortable listening level.

WARNING : This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www. P65Warnings.ca.gov.

International Support

To download this User’s Guide in English, Spanish, or French, or to get answers to frequently asked questions, visit the support section at:

www.iLiveElectronics.com

Para descargar este Manual del Usuario en Inglés, Español y Francés, o para obtener respuestas a preguntas frecuentes, visite la sección de apoyo en:

www.iLiveElectronics.com

Pour télécharger ce guide de l’utilisateur en Anglais, Espagnol ou Français, ou pour obtenir des réponses à des questions fréquemment posées, consultez la rubrique d’assistance sur:

www.iLiveElectronics.com

Contact Information

Website: www.iLiveElectronics.com Email Support: prodinfo@dpiinc.com Email Parts: partsinfo@dpiinc.com Phone Support: 1-888-999-4215

Warranty

For Warranty Information and the most up-to-date version of this User’s Guide, go to:

www.iLiveElectronics.com.

Made Green

Protect for Today

Sustain for Tomorrow

Specications are subject to change without notice.

All other trademarks appearing herein are the property

of their respective owners.

Wireless Stereo Earbuds

User’s Guide for Model IAEB6 v1995-01

• Supports Bluetooth

• Wireless range: 33 feet

• Supports prole A2DP (Advanced Audio Distribution Prole)

• Voice prompts announce earbud operations

• Digital volume control

• Micro-USB port for battery recharge

• DC battery power: built-in rechargeable lithium ion battery

Includes

• 3 pairs of eartips: 1 small, 1 medium, 1 large

• Micro-USB to USB charging cable

Overview & ControlsFeatures

Initial charge time is approximately 2 hours. Charge fully before use. The low battery indicator will ash for

Volume Up

LED Indicator inside

body of controller

Power + Pair

Press and hold until

ashing red/blue light.

Power ON/OFF

Press and hold for 5 sec.

Play / Pause /

Speakerphone

Press to play/pause audio

or answer/end a phone call.

Volume Down

Microphone

1 minute and a voice will announce “Low Battery,” then the unit will automatically power OFF.

Charging the Battery

• Using a Micro-USB to USB cable (included), connect to the USB port of a powered on computer or USB power adaptor to charge.

Power Status Indicator Light

Power ON Flashing blue light

Low Battery Flashing red light

Charging Solid Red light

Finished Charging Solid Blue light

Initial Bluetooth Connection

1. With the earbuds powered OFF, press and hold until they power ON and the indicator light

begins ashing red and blue. When pairing, remain within 3 feet of the Bluetooth device.

2. Using the controls on your Bluetooth device,

select IAEB6 in the Bluetooth Settings to pair.

If need be, refer to the user’s manual for your specic device for more information.

3. When successfully paired, a voice will announce

“Bluetooth is connected” and the LED indicator will begin slowly ashing blue. Audio from the connected Bluetooth device will now be heard through the earbuds.

4. Use the controls on the connected Bluetooth

device to select and play audio. Use the earbud controls or the connected Bluetooth device to play, pause, and adjust the volume level.

5. After initial pairing, press and hold

approximately 5 seconds. The earbuds will power ON and automatically connect to the Bluetooth device.

Bluetooth Status Indicator Light

Pairing Bluetooth Flashing red and blue lights

Successfully Paired Slowly ashing blue light

for

Using the Speakerphone

1. To accept a call, press the button or use the controls on the connected phone.

2. To end a call, press the controls on the connected phone.

3. To re-dial the last dialed number, press the button twice.

button or use the

Previously Connected Devices

• The earbuds can remember multiple Bluetooth devices and will always try to re-connect to the last device used.

• To re-connect to a dierent device, turn o Bluetooth on unwanted devices, then access the Bluetooth settings menu on the device you wish to use and select IAEB6.

Troubleshooting

If the earbuds should become unpaired or will not connect normally, follow these steps in your device’s Bluetooth Settings Menu.

1. Delete the earbuds (“Forget This Device”).

2. Turn Bluetooth OFF then ON again, and repeat the

Initial Bluetooth Connection steps.