FCC WARNINGS
• Warning: Changes or modications to this unit not expressly
approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
ADDITIONAL WARNINGS
• WARNING: To prevent re or shock hazards, do not expose
this unit to rain or moisture.
• WARNING : Where the mains plug or appliance coupler is
used as the disconnect device, such disconnect device shall
remain readily operable.
• Lithium batteries, like all rechargeable batteries, are
recyclable and should be recycled or disposed of according
to state and local guidelines. They should never be disposed
of in normal household waste, and they should never be
incinerated, as they might explode. Contact your local
government for disposal or recycling practices in your area.
• WARNING: This product may contain chemicals known
to the State of California to cause birth defects, or other
reproductive harm (California Prop 65). Wash hands after
handling.
• This product meets and complies with all Federal regulations.
• To avoid hearing damage, make sure that the volume on
your music player is turned down before connecting your
headphones. After placing headphones in/on your ears,
gradually turn up the volume until you reach a comfortable
listening level.
International Support
To download this User’s Guide in English, Spanish,
or French, or to get answers to frequently asked
questions, visit the support section at:
www.iLiveElectronics.com
Para descargar este Manual del Usuario en Inglés,
Español y Francés, o para obtener respuestas a
preguntas frecuentes, visite la sección de apoyo en:
www.iLiveElectronics.com
Pour télécharger ce guide de l’utilisateur en Anglais,
Espagnol ou Français, ou pour obtenir des réponses
à des questions fréquemment posées, consultez la
rubrique d’assistance sur:
www.iLiveElectronics.com
Contact Information
Website: www.iLiveElectronics.com
Email Support: prodinfo@dpiinc.com
Email Parts: partsinfo@dpiinc.com
Phone Support: 1-888-999-4215
Warranty
For Warranty Information and the most
up-to-date version of this User’s Guide, go to:
www.iLiveElectronics.com.
Made
Green
Protect for Today
Sustain for Tomorrow
Specications are subject to change without notice.
Copyright © 2016 Digital Products International (DPI, Inc.)
All other trademarks appearing herein are the property
of their respective owners.
Wireless Stereo Headset
User’s Guide for Model IAEB25-1791-01
Features
Overview & Controls
Battery Power
Pairing a Bluetooth Device
Playing Audio Wirelessly
• Supports Bluetooth
• Supports prole A2DP (Advanced Audio
Distribution Prole)
• Digital volume control
• Built-in microphone
• Micro-USB port for battery recharge
• Wireless range: 33 feet
• DC battery power: built-in rechargeable lithium
ion battery
• Battery life: approx. 4 hrs at 100% volume
6 hrs at 50%
Includes
• 3 pairs of eartips: 1 small, 1 medium, 1 large
• Micro-USB to USB cable
• Hard carrying case
Power Switch
(side)
Micro-USB
Power Port
Volume +/−
Play/Pause/Speakerphone/Pair
Press and hold to pair
Press to play or pause the current track.
Press to answer an incoming call.
Mic
(side)
1. Using a Micro-USB to USB cable (included),
connect to the USB port of a powered on
computer or USB power adaptor to charge the
unit. Charge fully before use.
Initial charge time is approximately 2 hours.
The LED indicator will display a red light when
charging, and turn blue when fully charged.
LED Indicators
Note: The Play/Pause/Speakerphone/Pair button
doubles as the LED Indicator.
Status Indicators
Power On Flashing blue light
Low Battery Flashing red light
Charging Red light
Finished Charging Light OFF
Pairing Wireless Flashing red and blue lights
1. Power on the unit by sliding the Power Switch
to the ON position, and press and hold the
Play/Pause/Speakerphone/Pair button for
approximately 7 seconds. When pairing, remain
within 3 feet of the unit.
2. Using the controls on your Bluetooth device,
select IAEB25 in your Bluetooth settings to pair. If
your device requests
a password, enter the default password
0 0 0 0 .
3. Refer to the user’s manual for your specic device
for instructions on pairing and connecting
Bluetooth devices. After initial pairing, the unit
will stay paired unless unpaired manually by the
user or erased due to a reset of the device.
If your device should become unpaired or you nd it
is unable to connect, repeat the above steps.
1. Use the controls on the connected Bluetooth
Device to select a track.
2. To play or pause the selected track, use the
controls on the connected Bluetooth Device
or press the Play/Pause/Speakerphone/Pair
button.
3. Audio played through the connected Bluetooth
device will now be heard through the speakers.
Using the Speakerphone
1. To accept a call, press the Play/Pause/
Speakerphone/Pair button, or use the controls
on the connected phone.
2. To end a call, press the Play/Pause/
Speakerphone/Pair button, or use the controls
on the connected phone.
3. To re-dial the last dialed number, press the Play/
Pause/Speakerphone/Pair button twice.