iKeyless FDSSG000 User Manual

Remote Layout

FDSSL-G000

User manual

2019/05/28

Five Function Buttons

1. Remote Start

2. Lock

3. Unlock

4. Trunk

5. Panic

iKeyless LLC Confidential May 2019

Operation

Make sure you are within range of the vehicle before using the remote.

● Press Lock to lock all doors.

● Press Unlock to unlock the driver’s door. Press Unlock again within 5 seconds to unlock

all doors.

● Press the Trunk button twice to open the trunk.

● Press and Hold the Panic button for longer than 0.5 seconds to sound the vehicle’s

Panic Alarm.

● Press any button to stop the Panic Alarm
Note: The exact behavior in response to each button press may vary depending on the vehicle.
Consult the vehicle manual for more information.

Pairing Instructions

This Smart key requires industry standard equipment to program and pair to your vehicle.
Please contact a licensed locksmith to pair this key to your vehicle. For help or assistance,
please contact technical support at: 1-844-KEY-USA with any questions related to the remote
functions of this key.

Battery Replacement

If the battery needs to be replaced:

1. Slide the switch on the back of the remote to remove the emergency key.

2. Use the emergency key to pry the two halves of the remote apart at the space next to

where they key was removed from.

3. Replace the battery with a CR2032 cell with the “+” side facing down into the plastic.

4. Press the two shell halves back together and replace the emergency key.

FCC Regulatory Statement

Model: FDSSL-G000
FCC ID: X32-FDSSG000
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Consult the dealer or an experienced radio/TV technician for help.

Warning: Changes or modifications to this device not expressly approved by iKeyless, LLC could void the user’s authority to operate the
equipment.

IC Regulatory Statement

Model: FDSSL-G000
IC: 8797A-FDSSG000
CAN ICES-3 (B)/NMB-3(B)

iKeyless LLC Confidential May 2019