Ikelite WD-3 Instruction Manual

WD-3 Wide Angle Conversion Dome

Product Number 6430.3

I n s t r u c t i o n M a n u a l

Thank you for your purchase of Ikelite equipment. Please read this
instruction manual completely before attempting to operate or dive
with this product. Please refer to the back page of this manual to
register your Ikelite product.

Table of Contents

Included in the Box ........................................................................P. 2

Attach WD-3 to 3-inch Flat Port ....................................................P. 3

Customer Support ..........................................................................P. 4

Limited Warranty ............................................................................P. 4

Included in the Box

WD-3 Dome Lanyard

2

Attach WD-3 to 3-inch Flat Port

1. Rotate Thumbscrews counterclockwise so no threads show inside WD-3
Dome.

2. Gently push Dome over front of 3-inch Port.

3. Hand-tighten and snug both Thumbscrews. DO NOT over-tighten.

4. Extended areas of Dome Hood should be at the 12 and 6 o’clock
positions to avoid vignetting.

Dome Hood

WD-3 Dome

Thumbscrew

3-inch Port

3

Customer Support

Ikelite Underwater Systems
Service Department
50 West 33rd St.
Indianapolis, IN 46208 USA

Email: [e-mail]
Phone: [phone]

Limited Warranty

This Ikelite product is warranted against any manufacturing defects for a
period of one (1) year from the original date of purchase. Defective
products should be returned to Ikelite postage paid. Ikelite will, at its sole
discretion, repair or replace s
postage paid. All other claims of any nature are not covered. Except as
mentioned above, no other warranty expressed or implied applies to this

uch products, and will return to customer

Ikelite product.

Ikelite Underwater Systems

50 West 33rd Street

Indianapolis, IN 46208 USA

© 2015 Ikelite Underwater Systems

ikelite.com

6430.3_WD-3_Dome_and_Color_Filter_01-0915