Ikelite 6110.93 Instruction Manual
Digital Housing
instruction manual
for
Sony
DSC-V3
Housing
#6110.93
Ikelite Digital Housing
Lift
Push For ward
Lid Snap Lock
Lid
Hook
O' Ring
Mounting
Bolt
Mounting
Tray
Lid
Hook
External Strobe
Connection
O'ring
Housing Back
Housing Hot
Shoe Connector
Camera
Hot Shoe
Camera
L
ens Po r t
Night Framing
M
ode
Dial
S
hutter
Release
FRONT VIEW
Lid
Snap
Q
uick Release
Button
S
trobe
M
ount
Rubber
Handles
T
ray
Shutter
Release
BACK VIEW
O'ring
External
Strobe Connector
L
id
Snap
Menu
Focus
LCD
Zoom
CF Card
P
ower
Jog Dial
Exposure
Focus
AE Lock
Delete
Control
Button
instruction manual
Housing #6110.93 for Sony DSC-V3
Congratulations on your purchase of an Ikelite Digital Camera
Housing. Ikelite has over 30 years of experience in the underwater
photographic and lighting market. Our products are designed and
built in the USA by Ikelite for both the professional and amateur
photographer.
The clear housing permits instant visual inspection of the camera
and all sealing surfaces as well as complete monitoring of controls
and camera LCD screens.
Ikelite Digital Housings are slightly negative in salt water for
stability. This housing has been water pressure tested at the
factory. Housing is pressure tested to 200’ (60m).
2
OOppeenniinngg tthhee HHoouussiinng
Lid Snaps have a
LLoocck
g
k
.
To open, push Lid Snap
Lock forward and lift as
shown. Keep pressure
on the Lid Snap so it
does not fly open
quickly.
Some lid snaps have a
lot of spring tension
once they go over center, have a firm grip on the lid snap. Lid
Snaps may be opened one at a time.
IInnssttaalllliinngg tthhee CCaammeerra
Install a fully charged battery
a
into the camera before
camera to the housing’s mounting tray.
Remove the back from
the housing. The
mounting tray for the
camera is secured to the
housing back. Position
the camera
and secure it with the
mounting bolt which
threads into the camera's
tripod socket.
CCAAUUTTIIOONN:
on the tray
:
Some camera tripod
socket threads
cross thread or over tighten as you may damage the camera
tripod socket threads.
are plastic. The mounting bolt is metal.
3
securing the
Do not
FFllaasshh CCoonnnneeccttiioon
n
When using an external strobe connect the housings Hot Shoe
Connection, slide the connector into the hot shoe of the camera
from the back as shown. Slide the connector forward until it
stops. This can be done after the camera is mounted to the
mounting tray.
Only remove the External Strobe Connector's waterproof cap
when a sync cord is going to be connected.
IInnssttaalllliinngg CCaammeerraa iinn HHoouussiinng
g
When installing the camera into the the housing, pull up on the
CF Control in the housing front so it clears the camera. You may
have to turn the CF Control to clear the Mode Dial on the top
of the camera during installation.
4
Loading...