Ikelite 5509.68 Installation Instructions Manual

5509.68 Zoom Sleeve

I N S TA L L AT I O N I N S T R U C T I O N S for

Sigma 8-16mm F4.5-5.6 DC HSM Lens

Diagram A

5509.68 Zoom Sleeve

Sigma 8-16mm Lens

Black Housing Gear

Installation Procedure

1. Install the camera and lens in your Ikelite housing.

2. Place the Zoom Sleeve over the lens and gently wiggle sleeve
down the lens barrel (Diagram A, front page).

3. Push down on top of Zoom Sleeve above Black Housing Gear
while rotating the housing Zoom Control (Diagram C, page 3).
Rotate until Zoom Sleeve Teeth mesh with Black Housing Gear
teeth (Diagram B & C, page 3).

4. Using your thumbs, gently push down around the entire top of
the Zoom Sleeve perimeter until it is properly seated in the
housing opening (Diagrams B & C, page 3).

5. Install housing port. Refer to your Ikelite housing manual for
proper port installation.

6. Check function by rotating housing Zoom Control (Diagram C,
page 3).

Detachment Procedure

1. Remove housing port.

2. Depress camera lens release button using housing control.
Refer to your Ikelite housing manual for proper port installation.

3. Rotate lens counterclockwise off camera and gently wiggle
Zoom Sleeve up lens barrel to remove.

4. Reattach lens to camera.

2