Concave
Concave
COLOR CAMERA
ISD-A30
INSTALLATION PROCEDURE
Precautions
1
2
●Do not remove the transparent sheet off the dome cover until the camera has been
completely installed.
●
During the set-up work, be very careful not to get yourself injured.
Make the tow pilot holes in the mounting
face, as shown below, that fit the wiring
holes and the mounting screw positions.
Drill the wiring holes to the diameters of
50-60 mm.
90
Holes for
camera fixing
Temporarily drive the mounting screws
(prepare them according to the mount's
material) in the two mounting screw
holes (drilled in Step 1 above), as shown
below. Make sure there is a clearance of
5 mm or so with the mounting face.
Ceiling wiring
hole size:
50-60 mm dia.
9 mm dia.
4.3 mm dia.
3
4
Turn the ornamental ring to detach the
dome cover.
Dome cover
Ornamental ring
①Loosen the two camera unit fixing
screws from the camera unit.
②Turn the camera unit until the
concaves of the camera unit match
the mounting screw hole positions of
the camera.
5mm
Camera unit
fixing screw
Mounting screw hole
Concave
Camera unit
Concave
Camera unit
fixing screw
1
5
6
Tighten up the two camera unit fixing
screws to fix the camera unit in position.
Let the camera's specially-shaped holes
through the heads of the screws in Step
2 above, and turn the camera clockwise.
Tighten up the mounting screws to fix the
camera in position.
7
After positioning the camera, secure the
ornamental ring and dome cover in
place.
Ornamental ring
Dome cover
Ikegami Tsushinki Co., Ltd.
2
KY8-0171
Loading...