IKEA of Sweden LED1805E22 User Manual
LED1805E22
English
6
Français
Español
9
14
English 4
ADD LIGHT SOURCES TO YOUR STEERING DEVICE:
Before you can use your light source you’ll need to pair it
with a steering device.
To add more light sources, just repeat the steps below:
1. Make sure that your light source is installed and the main
power switch is turned on.
2. Hold the steering device close to the light source you
want to add (no more than 5 cm away).
3. Press and hold the pairing button for at least 10
seconds. A red light will shine steadily on the steering
device. Your light source will begin to dim and nally
ash one time to indicate that it has been successfully
paired.
Up to 10 light sources can be paired with 1 steering device.
Make sure to pair them one at a time. If the light sources
are close to each other, disconnect those that have already
been paired from the main power switch.
CAUTION:
DO NOT USE WITH STANDARD DIMMERS. Only use the
control provided with or specied by these instructions to
control this bulb. This bulb will not operate properly when
connected to a standard (incandescent) dimmer or dimming
control. Only controllable by IKEA Smart lighting products.
The colour temperature can be switched between 2200K
(warm glow), 2700K (warm white) and 4000K (cool white).
RESET YOUR DEVICE
Toggle the main switch 6 times.
TECHNICAL DATA
Type: LED1805E22
Input: 110-120 Vac, 60Hz
Range: 10 m in open air
Operating frequency: 2405-2480MHz
Output power: 10 dBm
Manufacturer: IKEA of Sweden AB
Address: Box 702, SE-343 81, Älmhult, SWEDEN
5
This device complies with Part 15 of the FCC Rules/
Innovation Science and Economic Development Canada's
licence-exempt RSS standard(s). Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation of the device.
WARNING:
Any changes or modications to this unit not expressly
approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation.
6
Loading...