IKEA of Sweden F1730 User Manual
FREKVENS
11
10
1
10
4
11
14
12
13
5
2
3
14
4
6
7
15
9
13
13
8
3
14
ENGLISH
4
FRANÇAIS
ESPAÑOL
8
12
ENGLISH 4
TABLE OF CONTENTS
1. Volume Control
2. Power on/off
3. AC IN
4. AC OUT
5. AUDIO IN
6. AUDIO OUT
7. SUBWOOFER OUT
8. SUBWOOFER IN
9. Bass level
10. Handle with jumpers
11. Cover
12. Foot
13. Battery compartment lid
14. Power Connection cable
15. 3,5 Audio Cable
Getting started
1. Connect mains cord into speaker AC
In (3)connector of the speaker and the
speaker to subwoofer with the power
connection cable between AC out (4) and
AC in (3) on the subwoofer.
2. Connect the 3,5mm Audio cable between
Subwoofer OUT (7) and Subwoofer IN
(8).
3. A quick press on each button (2) turns
the speaker and the subwoofer on/off.
White LED is now on. If a paired device
is found, the LED on the speaker shines
without blinking and your speaker is
ready to use.
4. If no device is found the speaker LED
continues to blink and enters pairing
mode automatically. Go to the Bluetooth
settings in your mobile device and
connect to FREKVENS 10x20. The LED
should now stop blinking and your
speaker is ready to use. If no music has
been playing for 20min, the speaker will
enter sleep mode.
2. Once Bluetooth connection is established,
the white LED stops blinking.
Unpair Bluetooth device
Go to your Bluetooth menu on your mobile
device and unpair FREKVENS 10x20 from
your devices.
Using an external source
Connect the external source to the AUDIO
IN (5) jack on the rear panel. The speaker
automatically detects the external input
and disables Bluetooth functionality. Use a
3.5mm 3-pol Audio cable for this feature.
Using and charging the speaker
FREKVENS 10x20 with subwoofer has the
possibility to be portable. ENEBY battery
pack for the subwoofer and BRAUNIT battery
pack for the speaker are sold separately.
• To insert the battery, open the
compartment lid (13) and insert the
battery in the correct direction.
• The battery is charged in the product when
mains cord is connected.
• When battery is low a red LED at the
button (2) will ash. During charging the
red LED is on.
Accessories
Covers: pull off to detach and push on to
attach.
Handle: Attach/remove with two jumpers
and four screws using an Allen key.
Jumpers: attach the speaker to the
subwoofer by using using the included
jumpers.
Factory reset
Press button (2) 10 sec. This deletes all
paired Bluetooth devices.
Adjust Volume
Turn the knob (1) left to decrease or turn it
right to increase volume level.
Turn the knob (9) left to decrease or turn it
right to increase Bass level.
Pair Bluetooth device(s)
(maximum 8 devices can be stored)
1. Go to your Bluetooth menu on your
mobile device and connect to FREKVENS
10x20.
Safety and important notice
WARNING:
— Risk of overheating! Never install the
product in a conned space. Always
leave a space of at least 5 mm around
the product for ventilation. Ensure
curtains or other objects never cover the
ventilation slots on the product.
5
— Never place the product or batteries
near open ames or other heat sources,
including direct sunlight.
— Only use this product indoors. The
apparatus shall not be exposed to
dripping or splashing, no objects lled
with liquids, such as vases, shall be
placed on the apparatus.
— Never place this product on other
electrical equipment.
— The mains plug or an appliance coupler
is to be used as a disconnect device, the
disconnect device shall remain readily
operable.
— If the supply cord is damaged, replace
it with a new cord set which is typeapproved for your country.
— Batteries (battery pack or batteries
installed) shall not be exposed to
excessive heat such as sunshine, re or
similar.
IMPORTANT!
— The speaker is for indoor use only and
can be used in temperatures ranging
from 0º C to 45º C.
— Do not leave the speaker in direct
sunlight or near any heat source, as it
may overheat.
— Do not subject the speaker to wet, moist
or excessively dusty environments, as
this may cause damage.
— The range between the speaker and the
receiver is measured in open air.
— Different building materials and
placement of the units can affect the
wireless connectivity range.
— Too high volume can damage your
hearing.
— Do not touch the acoustic components.
— Do not use the product as a shelf or
stand.
CARE INSTRUCTIONS
To clean the speaker, wipe with a dry cloth.
Never submerge the speaker in water.
PRODUCT SERVICING
Do not attempt to repair this product
yourself, as opening or removing covers may
expose you to dangerous voltage points or
other risks.
Technical data subwoofer
Model Name:
FREKVENS speaker with Subwoofer 30x20
Type number: F1730
Input: 100-240VAC 50-60Hz
Standby Power Consumption: <0.5 W
Rated Power
Consumption: 950mA - 450mA.
Operating temperatures: 0°C to 45°C
Operating humidity: 0 to 95%RH
Dimensions (mm):
199x101.5x99 (without handle) /
199x194x99
Weight: 1.3kg (without battery) / 2.2kg
Audio IN/OUT/SUB OUT: 3.5mm jack
Audio In Input sensitivity: 1.65V max
Battery playtime
at 50% volume: 8-10 Hours / 6-8 Hours
Auto Standby: 20 min
Speaker type: mixed mono
Woofer: 1 x 3.0" / 1 x 5.25"
Soft dome tweeter: 1 x 0.75" / N/A
Amplier output
power: 1 x 8W / 1 x 24W
Frequency
range: 75 - 20 kHz / 50 - 180Hz
Bluetooth Version: V 4.2
Wireless range in open air: <10 m
Operating frequency: 2.4 - 2.48 GHz
Radio output power: 4 dBm
Manufacturer: IKEA of Sweden AB
Address:
Box 702, SE-343 81, Älmhult, SWEDEN
NOTE!
Never use abrasive cleaners or chemical
solvents as this can damage the product.
Loading...