IKEA of Sweden E1803 User Manual

FNURRA

1

2

4

3

4

1

1

ENGLISH
FRANÇAIS
ESPAÑOL

6
13
21

ENGLISH 6

Getting started

Remove light lens (1) and open lid (2) and insert AA
Ni-MH batteries with correct polarity and/or connect USB
cord into connector (3).

Setting time

After USB cable or battery is inserted, hours will start
blinking.

Increase and decrease hours and minutes
Set value.
Short press toggles between AM/PM and 24 hrs.
Long press starts clock setting sequence.

Setting alarm

Long press activates alarm setting mode.

Increase and decrease hours and minutes.
Set value.

Short press toggles alarm on/off.

Alarm symbol in display is on when alarm is
activated.

Select alarm sounds or mute sound. Sounds preview

with 50% volume.

Display symbols

Alarm activated.

Snooze activated.

Sound muted.

Flash: Low battery, Steady On: Charging, Off: Fully

Charged

7

Sleep timer activated.

Er Error

Waking up with alarm

20 minutes before the alarm goes off the main light starts
from minimum brightness level.
During this 20 minutes cycle the brightness gradually
increases until it reaches 100% at the alarm set off time.
If the sound is not muted sound starts playing at zero
volume at the alarm time and increases slowly during 2
minutes until it reaches 100%.
By tapping (4) on the top of product the alarm will be
snoozed. To stop the alarm, press any button.

Setting snooze time

Long press activates the snooze time setting.

Increase and decrease minutes.
Set value. Default snooze value is 7 minutes.

Sleep light timer

Short press activates sleep light timer, each press

increases the timer with 5 minutes.

Light adjustments

Short press toggles light on/off.

Short press changing the brightness.

Display brightness

Short press adjusting the display brightness in three

steps, 10%, 50% and 100% brightness.

8

Charging

When battery is low the battery symbol will ash. Connect

a power supply to the USB-C connector (3). For charging,
use only Ni-MH type AA rechargeable batteries. Do not
use or attempt to charge other types such as Alkaline,
Carbon Zink etc. The wake up lamp has built in protection
and will detect wrong battery types. Er will show in
display in case of error

Recommended power supply:

5V DC, min 2A (Not included)

Recommended battery types:

3 x IKEA LADDA 2450 (AA, 1.2V, 2450mAh, Ni-MH) (not
included). Use only Ni-MH type batteries.
Do not use Alkaline, Carbon Zink etc battery types.
Do not mix batteries of different capacities, types or date
stamps.
Remove batteries if luminary to be stored for a long
period or before it is scrapped.
Disconnect device from supply before removing batteries
and dispose batteries safely

TECHNICAL DATA
Type nr: E1803
Input: 5V DC, 1A, 5W or 3xAA
Max lumen output: 130lm
IP-Class: IP44
Operating temperatures: 0°C to 40°C (32°F to 104°F)

9

Estimated battery run time:

• Max brightness on both light and display: 10h

• 50% brightness on both light and display: 17h

• Min brightness on display and Light off: 7days

Manufacturer: IKEA of Sweden AB

Address: Box 702, SE-343 81 Älmhult, SWEDEN

WARNING:

Read all safety warnings and instructions. Failure to
follow the warnings and instructions may result in

electric shock, re and/or serious injury.

• Use the lantern only with 1.2V AA Ni-MH rechargeable
batteries. Use of any other type of battery may create a

risk of injury and re.

• Do not use a battery or appliance that is damaged or

modied.

• Damaged or modied batteries may exhibit
unpredictable behavior resulting in re, explosion or risk

of injury.

• In the event of a cell leaking, do not allow the liquid to
come in contact with the skin or eyes.

• Follow all charging instructions and do not charge the
batteries or lantern outside of the temperature range

specied in the instructions. Charging improperly or

10

at temperatures outside of the specied range may
damage the battery and increase the risk of re.

• To reduce the risk of injury, user must read instruction
manual

• Only use the charger in dry locations.

• Children should be supervised to ensure they do not
play with the product.

• If the charger is damaged it shall be destroyed.

WARNING:

• Never install the product in a conned space. Always

leave a space of at least 5 mm around the product for
ventilation.

• Product and batteries (battery pack or batteries
installed) shall not be exposed to excessive heat such as

sunshine, re or similar. No naked ame sources, such

as candlelight should be placed on the apparatus.

• The light source contained in this luminary shall only
be replaced by the manufacture or his service agent or

similar qualied person. Only to be supplied at SELV.

CAUTION:

• Risk of explosion if batteries are replaced by an
incorrect type.

• Dispose of used batteries according to the instruction.