Pairing: Add IKEA Smart Lighting
products to your system. See
instructions below.
ADDING DEVICES TO YOUR
WIRELESS ON/OFF SWITCH
When the wireless ON/OFF switch is sold
together with a control outlet (in the same
package), they are already paired.
To add more control outlets, just repeat the
steps below:
Make sure that your control outlet is
plugged in and the main power is turned
on.
1 Hold the ON/OFF switch close to the
control outlet you want to add (no more
than 5 cm away).
2 Press and hold the pairing button for
at least 10 seconds , you can nd the
pairing button under the rear cover.
3 A red light will shine steadily on the ON/
OFF switch. On your control outlet a
white light will begin to dim and ash
one time to indicate that it has been
successfully paired.
Up to 10 control outlets can be paired with
1 ON/OFF switch.
Make sure to pair them one at a time. If
the control outlets are close to each other,
disconnect those that have already been
paired from the wall outlet.
FACTORY RESET YOUR DEVICE
For wireless ON/OFF switch:
Press the pairing button 4 times within 5
seconds.
CHANGING THE BATTERY
When the wireless ON/OFF switch is used
regularly and as intended, the battery will
last for approximately 2 years.
When it’s time to replace the battery, a red
LED indicator will ash when you toggle the
ON/OFF switch.
Open the rear cover, and replace the
battery with a new CR2032 battery.
5
6
CAUTION!
Risk of explosion if battery is replaced by
an incorrect type. Dispose of used batteries
according to the instructions.
IMPORTANT!
— The wireless ON/OFF switch is for
indoor use only and can be used in
temperatures ranging from 0ºC to 40 ºC.
— Do not leave the wireless ON/OFF switch
in direct sunlight or near any heat
source, as it may overheat.
— The range between the wireless ON/OFF
switch and the receiver are measured
in open air. Different building materials
and placement of the units can affect
the wireless connectivity range.
CARE INSTRUCTIONS
To clean the wireless ON/OFF switch wipe
with a soft dry cloth.
NOTE!
Never use abrasive cleaners or chemical
solvents as this can damage the product.
Save these instructions for future use.
TECHNICAL DATA
Type: E1743 wireless ON/OFF button
Input: 3V, CR2032 Battery
Range: 10 m in open air
For indoor use only
Operating frequency: 2405-2480Mhz
Output power: 3 dBm
Manufacturer: IKEA of Sweden AB
Address: Box 702, SE-343 81 ÄLMHULT
7
8
This device complies with Part 15 of the
FCC Rules/Industry Canada licence-exempt
RSS standard(s). Operation is subject to
the following two conditions:
(1) this device may not cause harmful
interference, and
(2) this device must accept any interference
received, including interference that
may cause undesired operation of the
device.
WARNING:
Any changes or modications to this unit
not expressly approved by the party
responsible for compliance could void the
user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and
can radiate radio frequency energy and,
if not installed and used in accordance
9
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the quipment off and on, the
user is encouraged to try to correct the
interference by one or more of the following
measures:
— Reorient or relocate the receiving
antenna.
— Increase the separation between the
equipment and receiver.
— Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
— Consult the dealer or an experienced
radio/TV technician for help.
Loading...
+ 19 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.